include/linux/pinctrl/pinctrl-state.h

   1 /* SPDX-License-Identifier: GPL-2.0 */
   2 /*
   3  * Standard pin control state definitions
   4  */
   5
   6 /**
   7  * @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put
   8  *      into as default, usually this means the pins are up and ready to
   9  *      be used by the device driver. This state is commonly used by
  10  *      hogs to configure muxing and pins at boot, and also as a state
  11  *      to go into when returning from sleep and idle in
  12  *      .pm_runtime_resume() or ordinary .resume() for example.
  13  * @PINCTRL_STATE_INIT: normally the pinctrl will be set to "default"
  14  *      before the driver's probe() function is called.  There are some
  15  *      drivers where that is not appropriate becausing doing so would
  16  *      glitch the pins.  In those cases you can add an "init" pinctrl
  17  *      which is the state of the pins before drive probe.  After probe
  18  *      if the pins are still in "init" state they'll be moved to
  19  *      "default".
  20  * @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into
  21  *      when the pins are idle. This is a state where the system is relaxed
  22  *      but not fully sleeping - some power may be on but clocks gated for
  23  *      example. Could typically be set from a pm_runtime_suspend() or
  24  *      pm_runtime_idle() operation.
  25  * @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into
  26  *      when the pins are sleeping. This is a state where the system is in
  27  *      its lowest sleep state. Could typically be set from an
  28  *      ordinary .suspend() function.
  29  */
  30 #define PINCTRL_STATE_DEFAULT "default"
  31 #define PINCTRL_STATE_INIT "init"
  32 #define PINCTRL_STATE_IDLE "idle"
  33 #define PINCTRL_STATE_SLEEP "sleep"