[PATCH] USB: Rename hcd->hub_suspend to hcd->bus_suspend
[linux/fpc-iii.git] / drivers / pcmcia / vg468.h
blob88c2b487f675fcb14fbd94fe24ac73cb0e08e7a9
1 /*
2 * vg468.h 1.11 1999/10/25 20:03:34
4 * The contents of this file are subject to the Mozilla Public License
5 * Version 1.1 (the "License"); you may not use this file except in
6 * compliance with the License. You may obtain a copy of the License
7 * at http://www.mozilla.org/MPL/
9 * Software distributed under the License is distributed on an "AS IS"
10 * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See
11 * the License for the specific language governing rights and
12 * limitations under the License.
14 * The initial developer of the original code is David A. Hinds
15 * <dahinds@users.sourceforge.net>. Portions created by David A. Hinds
16 * are Copyright (C) 1999 David A. Hinds. All Rights Reserved.
18 * Alternatively, the contents of this file may be used under the
19 * terms of the GNU General Public License version 2 (the "GPL"), in which
20 * case the provisions of the GPL are applicable instead of the
21 * above. If you wish to allow the use of your version of this file
22 * only under the terms of the GPL and not to allow others to use
23 * your version of this file under the MPL, indicate your decision by
24 * deleting the provisions above and replace them with the notice and
25 * other provisions required by the GPL. If you do not delete the
26 * provisions above, a recipient may use your version of this file
27 * under either the MPL or the GPL.
30 #ifndef _LINUX_VG468_H
31 #define _LINUX_VG468_H
33 /* Special bit in I365_IDENT used for Vadem chip detection */
34 #define I365_IDENT_VADEM 0x08
36 /* Special definitions in I365_POWER */
37 #define VG468_VPP2_MASK 0x0c
38 #define VG468_VPP2_5V 0x04
39 #define VG468_VPP2_12V 0x08
41 /* Unique Vadem registers */
42 #define VG469_VSENSE 0x1f /* Card voltage sense */
43 #define VG469_VSELECT 0x2f /* Card voltage select */
44 #define VG468_CTL 0x38 /* Control register */
45 #define VG468_TIMER 0x39 /* Timer control */
46 #define VG468_MISC 0x3a /* Miscellaneous */
47 #define VG468_GPIO_CFG 0x3b /* GPIO configuration */
48 #define VG469_EXT_MODE 0x3c /* Extended mode register */
49 #define VG468_SELECT 0x3d /* Programmable chip select */
50 #define VG468_SELECT_CFG 0x3e /* Chip select configuration */
51 #define VG468_ATA 0x3f /* ATA control */
53 /* Flags for VG469_VSENSE */
54 #define VG469_VSENSE_A_VS1 0x01
55 #define VG469_VSENSE_A_VS2 0x02
56 #define VG469_VSENSE_B_VS1 0x04
57 #define VG469_VSENSE_B_VS2 0x08
59 /* Flags for VG469_VSELECT */
60 #define VG469_VSEL_VCC 0x03
61 #define VG469_VSEL_5V 0x00
62 #define VG469_VSEL_3V 0x03
63 #define VG469_VSEL_MAX 0x0c
64 #define VG469_VSEL_EXT_STAT 0x10
65 #define VG469_VSEL_EXT_BUS 0x20
66 #define VG469_VSEL_MIXED 0x40
67 #define VG469_VSEL_ISA 0x80
69 /* Flags for VG468_CTL */
70 #define VG468_CTL_SLOW 0x01 /* 600ns memory timing */
71 #define VG468_CTL_ASYNC 0x02 /* Asynchronous bus clocking */
72 #define VG468_CTL_TSSI 0x08 /* Tri-state some outputs */
73 #define VG468_CTL_DELAY 0x10 /* Card detect debounce */
74 #define VG468_CTL_INPACK 0x20 /* Obey INPACK signal? */
75 #define VG468_CTL_POLARITY 0x40 /* VCCEN polarity */
76 #define VG468_CTL_COMPAT 0x80 /* Compatibility stuff */
78 #define VG469_CTL_WS_COMPAT 0x04 /* Wait state compatibility */
79 #define VG469_CTL_STRETCH 0x10 /* LED stretch */
81 /* Flags for VG468_TIMER */
82 #define VG468_TIMER_ZEROPWR 0x10 /* Zero power control */
83 #define VG468_TIMER_SIGEN 0x20 /* Power up */
84 #define VG468_TIMER_STATUS 0x40 /* Activity timer status */
85 #define VG468_TIMER_RES 0x80 /* Timer resolution */
86 #define VG468_TIMER_MASK 0x0f /* Activity timer timeout */
88 /* Flags for VG468_MISC */
89 #define VG468_MISC_GPIO 0x04 /* General-purpose IO */
90 #define VG468_MISC_DMAWSB 0x08 /* DMA wait state control */
91 #define VG469_MISC_LEDENA 0x10 /* LED enable */
92 #define VG468_MISC_VADEMREV 0x40 /* Vadem revision control */
93 #define VG468_MISC_UNLOCK 0x80 /* Unique register lock */
95 /* Flags for VG469_EXT_MODE_A */
96 #define VG469_MODE_VPPST 0x03 /* Vpp steering control */
97 #define VG469_MODE_INT_SENSE 0x04 /* Internal voltage sense */
98 #define VG469_MODE_CABLE 0x08
99 #define VG469_MODE_COMPAT 0x10 /* i82365sl B or DF step */
100 #define VG469_MODE_TEST 0x20
101 #define VG469_MODE_RIO 0x40 /* Steer RIO to INTR? */
103 /* Flags for VG469_EXT_MODE_B */
104 #define VG469_MODE_B_3V 0x01 /* 3.3v for socket B */
106 #endif /* _LINUX_VG468_H */