1 # SPDX-License-Identifier: GPL-2.0-only
3 # Freescale device configuration
6 config NET_VENDOR_FREESCALE
7 bool "Freescale devices"
9 depends on FSL_SOC || QUICC_ENGINE || CPM1 || CPM2 || PPC_MPC512x || \
10 M523x || M527x || M5272 || M528x || M520x || M532x || \
11 ARCH_MXC || ARCH_MXS || (PPC_MPC52xx && PPC_BESTCOMM) || \
12 ARCH_LAYERSCAPE || COMPILE_TEST
14 If you have a network (Ethernet) card belonging to this class, say Y.
16 Note that the answer to this question doesn't directly affect the
17 kernel: saying N will just cause the configurator to skip all
18 the questions about Freescale devices. If you say Y, you will be
19 asked for your specific card in the following questions.
21 if NET_VENDOR_FREESCALE
24 tristate "FEC ethernet controller (of ColdFire and some i.MX CPUs)"
25 depends on (M523x || M527x || M5272 || M528x || M520x || M532x || \
26 ARCH_MXC || SOC_IMX28 || COMPILE_TEST)
27 default ARCH_MXC || SOC_IMX28 if ARM
31 Say Y here if you want to use the built-in 10/100 Fast ethernet
32 controller on some Motorola ColdFire and Freescale i.MX processors.
35 tristate "FEC MPC52xx driver"
36 depends on PPC_MPC52xx && PPC_BESTCOMM
39 select PPC_BESTCOMM_FEC
41 This option enables support for the MPC5200's on-chip
42 Fast Ethernet Controller
43 If compiled as module, it will be called fec_mpc52xx.
45 config FEC_MPC52xx_MDIO
46 bool "FEC MPC52xx MDIO bus driver"
47 depends on FEC_MPC52xx
50 The MPC5200's FEC can connect to the Ethernet either with
51 an external MII PHY chip or 10 Mbps 7-wire interface
52 (Motorola? industry standard).
53 If your board uses an external PHY connected to FEC, enable this.
55 If compiled as module, it will be called fec_mpc52xx_phy.
57 source "drivers/net/ethernet/freescale/fs_enet/Kconfig"
58 source "drivers/net/ethernet/freescale/fman/Kconfig"
61 tristate "Freescale PQ MDIO"
64 This driver supports the MDIO bus used by the gianfar and UCC drivers.
67 tristate "Freescale XGMAC MDIO"
72 This driver supports the MDIO bus on the Fman 10G Ethernet MACs, and
73 on the FMan mEMAC (which supports both Clauses 22 and 45)
76 tristate "Freescale QE Gigabit Ethernet"
77 depends on QUICC_ENGINE && PPC32
81 This driver supports the Gigabit Ethernet mode of the QUICC Engine,
82 which is available on some Freescale SOCs.
84 config UGETH_TX_ON_DEMAND
85 bool "Transmit on Demand support"
89 tristate "Gianfar Ethernet"
95 This driver supports the Gigabit TSEC on the MPC83xx, MPC85xx,
96 and MPC86xx family of chips, the eTSEC on LS1021A and the FEC
99 source "drivers/net/ethernet/freescale/dpaa/Kconfig"
100 source "drivers/net/ethernet/freescale/dpaa2/Kconfig"
101 source "drivers/net/ethernet/freescale/enetc/Kconfig"
103 endif # NET_VENDOR_FREESCALE