drm/msm/hdmi: Enable HPD after HDMI IRQ is set up
[linux/fpc-iii.git] / drivers / gpu / drm / hisilicon / kirin / dw_dsi_reg.h
blob18808fc9f3626cba1450dfef1178e996033f3dbb
1 /*
2 * Copyright (c) 2016 Linaro Limited.
3 * Copyright (c) 2014-2016 Hisilicon Limited.
5 * This program is free software; you can redistribute it and/or modify
6 * it under the terms of the GNU General Public License version 2 as
7 * published by the Free Software Foundation.
9 */
11 #ifndef __DW_DSI_REG_H__
12 #define __DW_DSI_REG_H__
14 #define MASK(x) (BIT(x) - 1)
17 * regs
19 #define PWR_UP 0x04 /* Core power-up */
20 #define RESET 0
21 #define POWERUP BIT(0)
22 #define PHY_IF_CFG 0xA4 /* D-PHY interface configuration */
23 #define CLKMGR_CFG 0x08 /* the internal clock dividers */
24 #define PHY_RSTZ 0xA0 /* D-PHY reset control */
25 #define PHY_ENABLECLK BIT(2)
26 #define PHY_UNRSTZ BIT(1)
27 #define PHY_UNSHUTDOWNZ BIT(0)
28 #define PHY_TST_CTRL0 0xB4 /* D-PHY test interface control 0 */
29 #define PHY_TST_CTRL1 0xB8 /* D-PHY test interface control 1 */
30 #define CLK_TLPX 0x10
31 #define CLK_THS_PREPARE 0x11
32 #define CLK_THS_ZERO 0x12
33 #define CLK_THS_TRAIL 0x13
34 #define CLK_TWAKEUP 0x14
35 #define DATA_TLPX(x) (0x20 + ((x) << 4))
36 #define DATA_THS_PREPARE(x) (0x21 + ((x) << 4))
37 #define DATA_THS_ZERO(x) (0x22 + ((x) << 4))
38 #define DATA_THS_TRAIL(x) (0x23 + ((x) << 4))
39 #define DATA_TTA_GO(x) (0x24 + ((x) << 4))
40 #define DATA_TTA_GET(x) (0x25 + ((x) << 4))
41 #define DATA_TWAKEUP(x) (0x26 + ((x) << 4))
42 #define PHY_CFG_I 0x60
43 #define PHY_CFG_PLL_I 0x63
44 #define PHY_CFG_PLL_II 0x64
45 #define PHY_CFG_PLL_III 0x65
46 #define PHY_CFG_PLL_IV 0x66
47 #define PHY_CFG_PLL_V 0x67
48 #define DPI_COLOR_CODING 0x10 /* DPI color coding */
49 #define DPI_CFG_POL 0x14 /* DPI polarity configuration */
50 #define VID_HSA_TIME 0x48 /* Horizontal Sync Active time */
51 #define VID_HBP_TIME 0x4C /* Horizontal Back Porch time */
52 #define VID_HLINE_TIME 0x50 /* Line time */
53 #define VID_VSA_LINES 0x54 /* Vertical Sync Active period */
54 #define VID_VBP_LINES 0x58 /* Vertical Back Porch period */
55 #define VID_VFP_LINES 0x5C /* Vertical Front Porch period */
56 #define VID_VACTIVE_LINES 0x60 /* Vertical resolution */
57 #define VID_PKT_SIZE 0x3C /* Video packet size */
58 #define VID_MODE_CFG 0x38 /* Video mode configuration */
59 #define PHY_TMR_CFG 0x9C /* Data lanes timing configuration */
60 #define BTA_TO_CNT 0x8C /* Response timeout definition */
61 #define PHY_TMR_LPCLK_CFG 0x98 /* clock lane timing configuration */
62 #define CLK_DATA_TMR_CFG 0xCC
63 #define LPCLK_CTRL 0x94 /* Low-power in clock lane */
64 #define PHY_TXREQUESTCLKHS BIT(0)
65 #define MODE_CFG 0x34 /* Video or Command mode selection */
66 #define PHY_STATUS 0xB0 /* D-PHY PPI status interface */
68 #define PHY_STOP_WAIT_TIME 0x30
71 * regs relevant enum
73 enum dpi_color_coding {
74 DSI_24BITS_1 = 5,
77 enum dsi_video_mode_type {
78 DSI_NON_BURST_SYNC_PULSES = 0,
79 DSI_NON_BURST_SYNC_EVENTS,
80 DSI_BURST_SYNC_PULSES_1,
81 DSI_BURST_SYNC_PULSES_2
84 enum dsi_work_mode {
85 DSI_VIDEO_MODE = 0,
86 DSI_COMMAND_MODE
90 * Register Write/Read Helper functions
92 static inline void dw_update_bits(void __iomem *addr, u32 bit_start,
93 u32 mask, u32 val)
95 u32 tmp, orig;
97 orig = readl(addr);
98 tmp = orig & ~(mask << bit_start);
99 tmp |= (val & mask) << bit_start;
100 writel(tmp, addr);
103 #endif /* __DW_DRM_DSI_H__ */