WIP FPC-III support
[linux/fpc-iii.git] / arch / sh / boards / board-urquell.c
blobdad2b3b40735cbca1fb06e18a193a6fa4f0fa3ed
1 // SPDX-License-Identifier: GPL-2.0
2 /*
3 * Renesas Technology Corp. SH7786 Urquell Support.
5 * Copyright (C) 2008 Kuninori Morimoto <morimoto.kuninori@renesas.com>
6 * Copyright (C) 2009, 2010 Paul Mundt
8 * Based on board-sh7785lcr.c
9 * Copyright (C) 2008 Yoshihiro Shimoda
11 #include <linux/init.h>
12 #include <linux/platform_device.h>
13 #include <linux/fb.h>
14 #include <linux/smc91x.h>
15 #include <linux/mtd/physmap.h>
16 #include <linux/delay.h>
17 #include <linux/gpio.h>
18 #include <linux/irq.h>
19 #include <linux/clk.h>
20 #include <linux/sh_intc.h>
21 #include <mach/urquell.h>
22 #include <cpu/sh7786.h>
23 #include <asm/heartbeat.h>
24 #include <linux/sizes.h>
25 #include <asm/smp-ops.h>
28 * bit 1234 5678
29 *----------------------------
30 * SW1 0101 0010 -> Pck 33MHz version
31 * (1101 0010) Pck 66MHz version
32 * SW2 0x1x xxxx -> little endian
33 * 29bit mode
34 * SW47 0001 1000 -> CS0 : on-board flash
35 * CS1 : SRAM, registers, LAN, PCMCIA
36 * 38400 bps for SCIF1
38 * Address
39 * 0x00000000 - 0x04000000 (CS0) Nor Flash
40 * 0x04000000 - 0x04200000 (CS1) SRAM
41 * 0x05000000 - 0x05800000 (CS1) on board register
42 * 0x05800000 - 0x06000000 (CS1) LAN91C111
43 * 0x06000000 - 0x06400000 (CS1) PCMCIA
44 * 0x08000000 - 0x10000000 (CS2-CS3) DDR3
45 * 0x10000000 - 0x14000000 (CS4) PCIe
46 * 0x14000000 - 0x14800000 (CS5) Core0 LRAM/URAM
47 * 0x14800000 - 0x15000000 (CS5) Core1 LRAM/URAM
48 * 0x18000000 - 0x1C000000 (CS6) ATA/NAND-Flash
49 * 0x1C000000 - (CS7) SH7786 Control register
52 /* HeartBeat */
53 static struct resource heartbeat_resource = {
54 .start = BOARDREG(SLEDR),
55 .end = BOARDREG(SLEDR),
56 .flags = IORESOURCE_MEM | IORESOURCE_MEM_16BIT,
59 static struct platform_device heartbeat_device = {
60 .name = "heartbeat",
61 .id = -1,
62 .num_resources = 1,
63 .resource = &heartbeat_resource,
66 /* LAN91C111 */
67 static struct smc91x_platdata smc91x_info = {
68 .flags = SMC91X_USE_16BIT | SMC91X_NOWAIT,
71 static struct resource smc91x_eth_resources[] = {
72 [0] = {
73 .name = "SMC91C111" ,
74 .start = 0x05800300,
75 .end = 0x0580030f,
76 .flags = IORESOURCE_MEM,
78 [1] = {
79 .start = evt2irq(0x360),
80 .flags = IORESOURCE_IRQ,
84 static struct platform_device smc91x_eth_device = {
85 .name = "smc91x",
86 .num_resources = ARRAY_SIZE(smc91x_eth_resources),
87 .resource = smc91x_eth_resources,
88 .dev = {
89 .platform_data = &smc91x_info,
93 /* Nor Flash */
94 static struct mtd_partition nor_flash_partitions[] = {
96 .name = "loader",
97 .offset = 0x00000000,
98 .size = SZ_512K,
99 .mask_flags = MTD_WRITEABLE, /* Read-only */
102 .name = "bootenv",
103 .offset = MTDPART_OFS_APPEND,
104 .size = SZ_512K,
105 .mask_flags = MTD_WRITEABLE, /* Read-only */
108 .name = "kernel",
109 .offset = MTDPART_OFS_APPEND,
110 .size = SZ_4M,
113 .name = "data",
114 .offset = MTDPART_OFS_APPEND,
115 .size = MTDPART_SIZ_FULL,
119 static struct physmap_flash_data nor_flash_data = {
120 .width = 2,
121 .parts = nor_flash_partitions,
122 .nr_parts = ARRAY_SIZE(nor_flash_partitions),
125 static struct resource nor_flash_resources[] = {
126 [0] = {
127 .start = NOR_FLASH_ADDR,
128 .end = NOR_FLASH_ADDR + NOR_FLASH_SIZE - 1,
129 .flags = IORESOURCE_MEM,
133 static struct platform_device nor_flash_device = {
134 .name = "physmap-flash",
135 .dev = {
136 .platform_data = &nor_flash_data,
138 .num_resources = ARRAY_SIZE(nor_flash_resources),
139 .resource = nor_flash_resources,
142 static struct platform_device *urquell_devices[] __initdata = {
143 &heartbeat_device,
144 &smc91x_eth_device,
145 &nor_flash_device,
148 static int __init urquell_devices_setup(void)
150 /* USB */
151 gpio_request(GPIO_FN_USB_OVC0, NULL);
152 gpio_request(GPIO_FN_USB_PENC0, NULL);
154 /* enable LAN */
155 __raw_writew(__raw_readw(UBOARDREG(IRL2MSKR)) & ~0x00000001,
156 UBOARDREG(IRL2MSKR));
158 return platform_add_devices(urquell_devices,
159 ARRAY_SIZE(urquell_devices));
161 device_initcall(urquell_devices_setup);
163 static void urquell_power_off(void)
165 __raw_writew(0xa5a5, UBOARDREG(SRSTR));
168 static void __init urquell_init_irq(void)
170 plat_irq_setup_pins(IRQ_MODE_IRL3210_MASK);
173 static int urquell_mode_pins(void)
175 return __raw_readw(UBOARDREG(MDSWMR));
178 static int urquell_clk_init(void)
180 struct clk *clk;
181 int ret;
184 * Only handle the EXTAL case, anyone interfacing a crystal
185 * resonator will need to provide their own input clock.
187 if (test_mode_pin(MODE_PIN9))
188 return -EINVAL;
190 clk = clk_get(NULL, "extal");
191 if (IS_ERR(clk))
192 return PTR_ERR(clk);
193 ret = clk_set_rate(clk, 33333333);
194 clk_put(clk);
196 return ret;
199 /* Initialize the board */
200 static void __init urquell_setup(char **cmdline_p)
202 printk(KERN_INFO "Renesas Technology Corp. Urquell support.\n");
204 pm_power_off = urquell_power_off;
206 register_smp_ops(&shx3_smp_ops);
210 * The Machine Vector
212 static struct sh_machine_vector mv_urquell __initmv = {
213 .mv_name = "Urquell",
214 .mv_setup = urquell_setup,
215 .mv_init_irq = urquell_init_irq,
216 .mv_mode_pins = urquell_mode_pins,
217 .mv_clk_init = urquell_clk_init,