x86: Make the vdso2c compiler use the host architecture headers
[linux/fpc-iii.git] / arch / arm / plat-omap / counter_32k.c
blob2438b96004c1c36013cb8e55fe2fb4b2eb180663
1 /*
2 * OMAP 32ksynctimer/counter_32k-related code
4 * Copyright (C) 2009 Texas Instruments
5 * Copyright (C) 2010 Nokia Corporation
6 * Tony Lindgren <tony@atomide.com>
7 * Added OMAP4 support - Santosh Shilimkar <santosh.shilimkar@ti.com>
9 * This program is free software; you can redistribute it and/or modify
10 * it under the terms of the GNU General Public License version 2 as
11 * published by the Free Software Foundation.
13 * NOTE: This timer is not the same timer as the old OMAP1 MPU timer.
15 #include <linux/kernel.h>
16 #include <linux/init.h>
17 #include <linux/clk.h>
18 #include <linux/err.h>
19 #include <linux/io.h>
20 #include <linux/clocksource.h>
21 #include <linux/sched_clock.h>
23 #include <asm/mach/time.h>
25 #include <plat/counter-32k.h>
27 /* OMAP2_32KSYNCNT_CR_OFF: offset of 32ksync counter register */
28 #define OMAP2_32KSYNCNT_REV_OFF 0x0
29 #define OMAP2_32KSYNCNT_REV_SCHEME (0x3 << 30)
30 #define OMAP2_32KSYNCNT_CR_OFF_LOW 0x10
31 #define OMAP2_32KSYNCNT_CR_OFF_HIGH 0x30
34 * 32KHz clocksource ... always available, on pretty most chips except
35 * OMAP 730 and 1510. Other timers could be used as clocksources, with
36 * higher resolution in free-running counter modes (e.g. 12 MHz xtal),
37 * but systems won't necessarily want to spend resources that way.
39 static void __iomem *sync32k_cnt_reg;
41 static u64 notrace omap_32k_read_sched_clock(void)
43 return sync32k_cnt_reg ? readl_relaxed(sync32k_cnt_reg) : 0;
46 /**
47 * omap_read_persistent_clock64 - Return time from a persistent clock.
49 * Reads the time from a source which isn't disabled during PM, the
50 * 32k sync timer. Convert the cycles elapsed since last read into
51 * nsecs and adds to a monotonically increasing timespec64.
53 static struct timespec64 persistent_ts;
54 static cycles_t cycles;
55 static unsigned int persistent_mult, persistent_shift;
57 static void omap_read_persistent_clock64(struct timespec64 *ts)
59 unsigned long long nsecs;
60 cycles_t last_cycles;
62 last_cycles = cycles;
63 cycles = sync32k_cnt_reg ? readl_relaxed(sync32k_cnt_reg) : 0;
65 nsecs = clocksource_cyc2ns(cycles - last_cycles,
66 persistent_mult, persistent_shift);
68 timespec64_add_ns(&persistent_ts, nsecs);
70 *ts = persistent_ts;
73 /**
74 * omap_init_clocksource_32k - setup and register counter 32k as a
75 * kernel clocksource
76 * @pbase: base addr of counter_32k module
77 * @size: size of counter_32k to map
79 * Returns 0 upon success or negative error code upon failure.
82 int __init omap_init_clocksource_32k(void __iomem *vbase)
84 int ret;
87 * 32k sync Counter IP register offsets vary between the
88 * highlander version and the legacy ones.
89 * The 'SCHEME' bits(30-31) of the revision register is used
90 * to identify the version.
92 if (readl_relaxed(vbase + OMAP2_32KSYNCNT_REV_OFF) &
93 OMAP2_32KSYNCNT_REV_SCHEME)
94 sync32k_cnt_reg = vbase + OMAP2_32KSYNCNT_CR_OFF_HIGH;
95 else
96 sync32k_cnt_reg = vbase + OMAP2_32KSYNCNT_CR_OFF_LOW;
99 * 120000 rough estimate from the calculations in
100 * __clocksource_update_freq_scale.
102 clocks_calc_mult_shift(&persistent_mult, &persistent_shift,
103 32768, NSEC_PER_SEC, 120000);
105 ret = clocksource_mmio_init(sync32k_cnt_reg, "32k_counter", 32768,
106 250, 32, clocksource_mmio_readl_up);
107 if (ret) {
108 pr_err("32k_counter: can't register clocksource\n");
109 return ret;
112 sched_clock_register(omap_32k_read_sched_clock, 32, 32768);
113 register_persistent_clock(NULL, omap_read_persistent_clock64);
114 pr_info("OMAP clocksource: 32k_counter at 32768 Hz\n");
116 return 0;