bna: remove oper_state_cbfn from struct bna_rxf
[linux/fpc-iii.git] / drivers / usb / serial / ti_usb_3410_5052.h
blob4a2423e84d55820b594ca43ed99fc8ae88b2f002
1 /* vi: ts=8 sw=8
3 * TI 3410/5052 USB Serial Driver Header
5 * Copyright (C) 2004 Texas Instruments
7 * This driver is based on the Linux io_ti driver, which is
8 * Copyright (C) 2000-2002 Inside Out Networks
9 * Copyright (C) 2001-2002 Greg Kroah-Hartman
11 * This program is free software; you can redistribute it and/or modify
12 * it under the terms of the GNU General Public License as published by
13 * the Free Software Foundation; either version 2 of the License, or
14 * (at your option) any later version.
16 * For questions or problems with this driver, contact Texas Instruments
17 * technical support, or Al Borchers <alborchers@steinerpoint.com>, or
18 * Peter Berger <pberger@brimson.com>.
21 #ifndef _TI_3410_5052_H_
22 #define _TI_3410_5052_H_
24 /* Configuration ids */
25 #define TI_BOOT_CONFIG 1
26 #define TI_ACTIVE_CONFIG 2
28 /* Vendor and product ids */
29 #define TI_VENDOR_ID 0x0451
30 #define IBM_VENDOR_ID 0x04b3
31 #define TI_3410_PRODUCT_ID 0x3410
32 #define IBM_4543_PRODUCT_ID 0x4543
33 #define IBM_454B_PRODUCT_ID 0x454b
34 #define IBM_454C_PRODUCT_ID 0x454c
35 #define TI_3410_EZ430_ID 0xF430 /* TI ez430 development tool */
36 #define TI_5052_BOOT_PRODUCT_ID 0x5052 /* no EEPROM, no firmware */
37 #define TI_5152_BOOT_PRODUCT_ID 0x5152 /* no EEPROM, no firmware */
38 #define TI_5052_EEPROM_PRODUCT_ID 0x505A /* EEPROM, no firmware */
39 #define TI_5052_FIRMWARE_PRODUCT_ID 0x505F /* firmware is running */
40 #define FRI2_PRODUCT_ID 0x5053 /* Fish River Island II */
42 /* Multi-Tech vendor and product ids */
43 #define MTS_VENDOR_ID 0x06E0
44 #define MTS_GSM_NO_FW_PRODUCT_ID 0xF108
45 #define MTS_CDMA_NO_FW_PRODUCT_ID 0xF109
46 #define MTS_CDMA_PRODUCT_ID 0xF110
47 #define MTS_GSM_PRODUCT_ID 0xF111
48 #define MTS_EDGE_PRODUCT_ID 0xF112
49 #define MTS_MT9234MU_PRODUCT_ID 0xF114
50 #define MTS_MT9234ZBA_PRODUCT_ID 0xF115
51 #define MTS_MT9234ZBAOLD_PRODUCT_ID 0x0319
53 /* Abbott Diabetics vendor and product ids */
54 #define ABBOTT_VENDOR_ID 0x1a61
55 #define ABBOTT_STEREO_PLUG_ID 0x3410
56 #define ABBOTT_PRODUCT_ID ABBOTT_STEREO_PLUG_ID
57 #define ABBOTT_STRIP_PORT_ID 0x3420
59 /* Commands */
60 #define TI_GET_VERSION 0x01
61 #define TI_GET_PORT_STATUS 0x02
62 #define TI_GET_PORT_DEV_INFO 0x03
63 #define TI_GET_CONFIG 0x04
64 #define TI_SET_CONFIG 0x05
65 #define TI_OPEN_PORT 0x06
66 #define TI_CLOSE_PORT 0x07
67 #define TI_START_PORT 0x08
68 #define TI_STOP_PORT 0x09
69 #define TI_TEST_PORT 0x0A
70 #define TI_PURGE_PORT 0x0B
71 #define TI_RESET_EXT_DEVICE 0x0C
72 #define TI_WRITE_DATA 0x80
73 #define TI_READ_DATA 0x81
74 #define TI_REQ_TYPE_CLASS 0x82
76 /* Module identifiers */
77 #define TI_I2C_PORT 0x01
78 #define TI_IEEE1284_PORT 0x02
79 #define TI_UART1_PORT 0x03
80 #define TI_UART2_PORT 0x04
81 #define TI_RAM_PORT 0x05
83 /* Modem status */
84 #define TI_MSR_DELTA_CTS 0x01
85 #define TI_MSR_DELTA_DSR 0x02
86 #define TI_MSR_DELTA_RI 0x04
87 #define TI_MSR_DELTA_CD 0x08
88 #define TI_MSR_CTS 0x10
89 #define TI_MSR_DSR 0x20
90 #define TI_MSR_RI 0x40
91 #define TI_MSR_CD 0x80
92 #define TI_MSR_DELTA_MASK 0x0F
93 #define TI_MSR_MASK 0xF0
95 /* Line status */
96 #define TI_LSR_OVERRUN_ERROR 0x01
97 #define TI_LSR_PARITY_ERROR 0x02
98 #define TI_LSR_FRAMING_ERROR 0x04
99 #define TI_LSR_BREAK 0x08
100 #define TI_LSR_ERROR 0x0F
101 #define TI_LSR_RX_FULL 0x10
102 #define TI_LSR_TX_EMPTY 0x20
104 /* Line control */
105 #define TI_LCR_BREAK 0x40
107 /* Modem control */
108 #define TI_MCR_LOOP 0x04
109 #define TI_MCR_DTR 0x10
110 #define TI_MCR_RTS 0x20
112 /* Mask settings */
113 #define TI_UART_ENABLE_RTS_IN 0x0001
114 #define TI_UART_DISABLE_RTS 0x0002
115 #define TI_UART_ENABLE_PARITY_CHECKING 0x0008
116 #define TI_UART_ENABLE_DSR_OUT 0x0010
117 #define TI_UART_ENABLE_CTS_OUT 0x0020
118 #define TI_UART_ENABLE_X_OUT 0x0040
119 #define TI_UART_ENABLE_XA_OUT 0x0080
120 #define TI_UART_ENABLE_X_IN 0x0100
121 #define TI_UART_ENABLE_DTR_IN 0x0800
122 #define TI_UART_DISABLE_DTR 0x1000
123 #define TI_UART_ENABLE_MS_INTS 0x2000
124 #define TI_UART_ENABLE_AUTO_START_DMA 0x4000
126 /* Parity */
127 #define TI_UART_NO_PARITY 0x00
128 #define TI_UART_ODD_PARITY 0x01
129 #define TI_UART_EVEN_PARITY 0x02
130 #define TI_UART_MARK_PARITY 0x03
131 #define TI_UART_SPACE_PARITY 0x04
133 /* Stop bits */
134 #define TI_UART_1_STOP_BITS 0x00
135 #define TI_UART_1_5_STOP_BITS 0x01
136 #define TI_UART_2_STOP_BITS 0x02
138 /* Bits per character */
139 #define TI_UART_5_DATA_BITS 0x00
140 #define TI_UART_6_DATA_BITS 0x01
141 #define TI_UART_7_DATA_BITS 0x02
142 #define TI_UART_8_DATA_BITS 0x03
144 /* 232/485 modes */
145 #define TI_UART_232 0x00
146 #define TI_UART_485_RECEIVER_DISABLED 0x01
147 #define TI_UART_485_RECEIVER_ENABLED 0x02
149 /* Pipe transfer mode and timeout */
150 #define TI_PIPE_MODE_CONTINOUS 0x01
151 #define TI_PIPE_MODE_MASK 0x03
152 #define TI_PIPE_TIMEOUT_MASK 0x7C
153 #define TI_PIPE_TIMEOUT_ENABLE 0x80
155 /* Config struct */
156 struct ti_uart_config {
157 __u16 wBaudRate;
158 __u16 wFlags;
159 __u8 bDataBits;
160 __u8 bParity;
161 __u8 bStopBits;
162 char cXon;
163 char cXoff;
164 __u8 bUartMode;
165 } __attribute__((packed));
167 /* Get port status */
168 struct ti_port_status {
169 __u8 bCmdCode;
170 __u8 bModuleId;
171 __u8 bErrorCode;
172 __u8 bMSR;
173 __u8 bLSR;
174 } __attribute__((packed));
176 /* Purge modes */
177 #define TI_PURGE_OUTPUT 0x00
178 #define TI_PURGE_INPUT 0x80
180 /* Read/Write data */
181 #define TI_RW_DATA_ADDR_SFR 0x10
182 #define TI_RW_DATA_ADDR_IDATA 0x20
183 #define TI_RW_DATA_ADDR_XDATA 0x30
184 #define TI_RW_DATA_ADDR_CODE 0x40
185 #define TI_RW_DATA_ADDR_GPIO 0x50
186 #define TI_RW_DATA_ADDR_I2C 0x60
187 #define TI_RW_DATA_ADDR_FLASH 0x70
188 #define TI_RW_DATA_ADDR_DSP 0x80
190 #define TI_RW_DATA_UNSPECIFIED 0x00
191 #define TI_RW_DATA_BYTE 0x01
192 #define TI_RW_DATA_WORD 0x02
193 #define TI_RW_DATA_DOUBLE_WORD 0x04
195 struct ti_write_data_bytes {
196 __u8 bAddrType;
197 __u8 bDataType;
198 __u8 bDataCounter;
199 __be16 wBaseAddrHi;
200 __be16 wBaseAddrLo;
201 __u8 bData[0];
202 } __attribute__((packed));
204 struct ti_read_data_request {
205 __u8 bAddrType;
206 __u8 bDataType;
207 __u8 bDataCounter;
208 __be16 wBaseAddrHi;
209 __be16 wBaseAddrLo;
210 } __attribute__((packed));
212 struct ti_read_data_bytes {
213 __u8 bCmdCode;
214 __u8 bModuleId;
215 __u8 bErrorCode;
216 __u8 bData[0];
217 } __attribute__((packed));
219 /* Interrupt struct */
220 struct ti_interrupt {
221 __u8 bICode;
222 __u8 bIInfo;
223 } __attribute__((packed));
225 /* Interrupt codes */
226 #define TI_GET_PORT_FROM_CODE(c) (((c) >> 4) - 3)
227 #define TI_GET_FUNC_FROM_CODE(c) ((c) & 0x0f)
228 #define TI_CODE_HARDWARE_ERROR 0xFF
229 #define TI_CODE_DATA_ERROR 0x03
230 #define TI_CODE_MODEM_STATUS 0x04
232 /* Download firmware max packet size */
233 #define TI_DOWNLOAD_MAX_PACKET_SIZE 64
235 /* Firmware image header */
236 struct ti_firmware_header {
237 __le16 wLength;
238 __u8 bCheckSum;
239 } __attribute__((packed));
241 /* UART addresses */
242 #define TI_UART1_BASE_ADDR 0xFFA0 /* UART 1 base address */
243 #define TI_UART2_BASE_ADDR 0xFFB0 /* UART 2 base address */
244 #define TI_UART_OFFSET_LCR 0x0002 /* UART MCR register offset */
245 #define TI_UART_OFFSET_MCR 0x0004 /* UART MCR register offset */
247 #endif /* _TI_3410_5052_H_ */