security/nss/cmd/lib/NSPRerrs.h

   1 /* ***** BEGIN LICENSE BLOCK *****
   2  * Version: MPL 1.1/GPL 2.0/LGPL 2.1
   3  *
   4  * The contents of this file are subject to the Mozilla Public License Version
   5  * 1.1 (the "License"); you may not use this file except in compliance with
   6  * the License. You may obtain a copy of the License at
   7  * http://www.mozilla.org/MPL/
   8  *
   9  * Software distributed under the License is distributed on an "AS IS" basis,
  10  * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
  11  * for the specific language governing rights and limitations under the
  12  * License.
  13  *
  14  * The Original Code is the Netscape security libraries.
  15  *
  16  * The Initial Developer of the Original Code is
  17  * Netscape Communications Corporation.
  18  * Portions created by the Initial Developer are Copyright (C) 1994-2000
  19  * the Initial Developer. All Rights Reserved.
  20  *
  21  * Contributor(s):
  22  *
  23  * Alternatively, the contents of this file may be used under the terms of
  24  * either the GNU General Public License Version 2 or later (the "GPL"), or
  25  * the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
  26  * in which case the provisions of the GPL or the LGPL are applicable instead
  27  * of those above. If you wish to allow use of your version of this file only
  28  * under the terms of either the GPL or the LGPL, and not to allow others to
  29  * use your version of this file under the terms of the MPL, indicate your
  30  * decision by deleting the provisions above and replace them with the notice
  31  * and other provisions required by the GPL or the LGPL. If you do not delete
  32  * the provisions above, a recipient may use your version of this file under
  33  * the terms of any one of the MPL, the GPL or the LGPL.
  34  *
  35  * ***** END LICENSE BLOCK ***** */
  36 /* General NSPR 2.0 errors */
  37 /* Caller must #include "prerror.h" */
  38
  39 ER2( PR_OUT_OF_MEMORY_ERROR,    "Memory allocation attempt failed." )
  40 ER2( PR_BAD_DESCRIPTOR_ERROR,   "Invalid file descriptor." )
  41 ER2( PR_WOULD_BLOCK_ERROR,      "The operation would have blocked." )
  42 ER2( PR_ACCESS_FAULT_ERROR,     "Invalid memory address argument." )
  43 ER2( PR_INVALID_METHOD_ERROR,   "Invalid function for file type." )
  44 ER2( PR_ILLEGAL_ACCESS_ERROR,   "Invalid memory address argument." )
  45 ER2( PR_UNKNOWN_ERROR,          "Some unknown error has occurred." )
  46 ER2( PR_PENDING_INTERRUPT_ERROR,"Operation interrupted by another thread." )
  47 ER2( PR_NOT_IMPLEMENTED_ERROR,  "function not implemented." )
  48 ER2( PR_IO_ERROR,               "I/O function error." )
  49 ER2( PR_IO_TIMEOUT_ERROR,       "I/O operation timed out." )
  50 ER2( PR_IO_PENDING_ERROR,       "I/O operation on busy file descriptor." )
  51 ER2( PR_DIRECTORY_OPEN_ERROR,   "The directory could not be opened." )
  52 ER2( PR_INVALID_ARGUMENT_ERROR, "Invalid function argument." )
  53 ER2( PR_ADDRESS_NOT_AVAILABLE_ERROR, "Network address not available (in use?)." )
  54 ER2( PR_ADDRESS_NOT_SUPPORTED_ERROR, "Network address type not supported." )
  55 ER2( PR_IS_CONNECTED_ERROR,     "Already connected." )
  56 ER2( PR_BAD_ADDRESS_ERROR,      "Network address is invalid." )
  57 ER2( PR_ADDRESS_IN_USE_ERROR,   "Local Network address is in use." )
  58 ER2( PR_CONNECT_REFUSED_ERROR,  "Connection refused by peer." )
  59 ER2( PR_NETWORK_UNREACHABLE_ERROR, "Network address is presently unreachable." )
  60 ER2( PR_CONNECT_TIMEOUT_ERROR,  "Connection attempt timed out." )
  61 ER2( PR_NOT_CONNECTED_ERROR,    "Network file descriptor is not connected." )
  62 ER2( PR_LOAD_LIBRARY_ERROR,     "Failure to load dynamic library." )
  63 ER2( PR_UNLOAD_LIBRARY_ERROR,   "Failure to unload dynamic library." )
  64 ER2( PR_FIND_SYMBOL_ERROR,
  65 "Symbol not found in any of the loaded dynamic libraries." )
  66 ER2( PR_INSUFFICIENT_RESOURCES_ERROR, "Insufficient system resources." )
  67 ER2( PR_DIRECTORY_LOOKUP_ERROR,
  68 "A directory lookup on a network address has failed." )
  69 ER2( PR_TPD_RANGE_ERROR,
  70 "Attempt to access a TPD key that is out of range." )
  71 ER2( PR_PROC_DESC_TABLE_FULL_ERROR, "Process open FD table is full." )
  72 ER2( PR_SYS_DESC_TABLE_FULL_ERROR, "System open FD table is full." )
  73 ER2( PR_NOT_SOCKET_ERROR,
  74 "Network operation attempted on non-network file descriptor." )
  75 ER2( PR_NOT_TCP_SOCKET_ERROR,
  76 "TCP-specific function attempted on a non-TCP file descriptor." )
  77 ER2( PR_SOCKET_ADDRESS_IS_BOUND_ERROR, "TCP file descriptor is already bound." )
  78 ER2( PR_NO_ACCESS_RIGHTS_ERROR, "Access Denied." )
  79 ER2( PR_OPERATION_NOT_SUPPORTED_ERROR,
  80 "The requested operation is not supported by the platform." )
  81 ER2( PR_PROTOCOL_NOT_SUPPORTED_ERROR,
  82 "The host operating system does not support the protocol requested." )
  83 ER2( PR_REMOTE_FILE_ERROR,      "Access to the remote file has been severed." )
  84 ER2( PR_BUFFER_OVERFLOW_ERROR,
  85 "The value requested is too large to be stored in the data buffer provided." )
  86 ER2( PR_CONNECT_RESET_ERROR,    "TCP connection reset by peer." )
  87 ER2( PR_RANGE_ERROR,            "Unused." )
  88 ER2( PR_DEADLOCK_ERROR,         "The operation would have deadlocked." )
  89 ER2( PR_FILE_IS_LOCKED_ERROR,   "The file is already locked." )
  90 ER2( PR_FILE_TOO_BIG_ERROR,
  91 "Write would result in file larger than the system allows." )
  92 ER2( PR_NO_DEVICE_SPACE_ERROR,  "The device for storing the file is full." )
  93 ER2( PR_PIPE_ERROR,             "Unused." )
  94 ER2( PR_NO_SEEK_DEVICE_ERROR,   "Unused." )
  95 ER2( PR_IS_DIRECTORY_ERROR,
  96 "Cannot perform a normal file operation on a directory." )
  97 ER2( PR_LOOP_ERROR,             "Symbolic link loop." )
  98 ER2( PR_NAME_TOO_LONG_ERROR,    "File name is too long." )
  99 ER2( PR_FILE_NOT_FOUND_ERROR,   "File not found." )
 100 ER2( PR_NOT_DIRECTORY_ERROR,
 101 "Cannot perform directory operation on a normal file." )
 102 ER2( PR_READ_ONLY_FILESYSTEM_ERROR,
 103 "Cannot write to a read-only file system." )
 104 ER2( PR_DIRECTORY_NOT_EMPTY_ERROR,
 105 "Cannot delete a directory that is not empty." )
 106 ER2( PR_FILESYSTEM_MOUNTED_ERROR,
 107 "Cannot delete or rename a file object while the file system is busy." )
 108 ER2( PR_NOT_SAME_DEVICE_ERROR,
 109 "Cannot rename a file to a file system on another device." )
 110 ER2( PR_DIRECTORY_CORRUPTED_ERROR,
 111 "The directory object in the file system is corrupted." )
 112 ER2( PR_FILE_EXISTS_ERROR,
 113 "Cannot create or rename a filename that already exists." )
 114 ER2( PR_MAX_DIRECTORY_ENTRIES_ERROR,
 115 "Directory is full.  No additional filenames may be added." )
 116 ER2( PR_INVALID_DEVICE_STATE_ERROR,
 117 "The required device was in an invalid state." )
 118 ER2( PR_DEVICE_IS_LOCKED_ERROR, "The device is locked." )
 119 ER2( PR_NO_MORE_FILES_ERROR,    "No more entries in the directory." )
 120 ER2( PR_END_OF_FILE_ERROR,      "Encountered end of file." )
 121 ER2( PR_FILE_SEEK_ERROR,        "Seek error." )
 122 ER2( PR_FILE_IS_BUSY_ERROR,     "The file is busy." )
 123 ER2( PR_IN_PROGRESS_ERROR,
 124 "Operation is still in progress (probably a non-blocking connect)." )
 125 ER2( PR_ALREADY_INITIATED_ERROR,
 126 "Operation has already been initiated (probably a non-blocking connect)." )
 127
 128 #ifdef PR_GROUP_EMPTY_ERROR
 129 ER2( PR_GROUP_EMPTY_ERROR,      "The wait group is empty." )
 130 #endif
 131
 132 #ifdef PR_INVALID_STATE_ERROR
 133 ER2( PR_INVALID_STATE_ERROR,    "Object state improper for request." )
 134 #endif
 135
 136 #ifdef PR_NETWORK_DOWN_ERROR
 137 ER2( PR_NETWORK_DOWN_ERROR,     "Network is down." )
 138 #endif
 139
 140 #ifdef PR_SOCKET_SHUTDOWN_ERROR
 141 ER2( PR_SOCKET_SHUTDOWN_ERROR,  "The socket was previously shut down." )
 142 #endif
 143
 144 #ifdef PR_CONNECT_ABORTED_ERROR
 145 ER2( PR_CONNECT_ABORTED_ERROR,  "TCP Connection aborted." )
 146 #endif
 147
 148 #ifdef PR_HOST_UNREACHABLE_ERROR
 149 ER2( PR_HOST_UNREACHABLE_ERROR, "Host is unreachable." )
 150 #endif
 151
 152 /* always last */
 153 ER2( PR_MAX_ERROR,              "Placeholder for the end of the list" )