x86: change 64-bit __change_page_attr() to struct page
[wrt350n-kernel.git] / arch / ppc / platforms / prpmc750.h
blobc4dcff09d7cabea8ce217eb0bffc5ec30562b732
1 /*
2 * arch/ppc/platforms/prpmc750.h
4 * Definitions for Motorola PrPMC750 board support
6 * Author: Matt Porter <mporter@mvista.com>
8 * 2001-2004 (c) MontaVista, Software, Inc. This file is licensed under
9 * the terms of the GNU General Public License version 2. This program
10 * is licensed "as is" without any warranty of any kind, whether express
11 * or implied.
14 #ifdef __KERNEL__
15 #ifndef __ASM_PRPMC750_H__
16 #define __ASM_PRPMC750_H__
19 * Due to limitations imposed by legacy hardware (primarily IDE controllers),
20 * the PrPMC750 carrier board operates using a PReP address map.
22 * From Processor (physical) -> PCI:
23 * PCI Mem Space: 0xc0000000 - 0xfe000000 -> 0x00000000 - 0x3e000000 (768 MB)
24 * PCI I/O Space: 0x80000000 - 0x90000000 -> 0x00000000 - 0x10000000 (256 MB)
25 * Note: Must skip 0xfe000000-0xfe400000 for CONFIG_HIGHMEM/PKMAP area
27 * From PCI -> Processor (physical):
28 * System Memory: 0x80000000 -> 0x00000000
31 #define PRPMC750_ISA_IO_BASE PREP_ISA_IO_BASE
32 #define PRPMC750_ISA_MEM_BASE PREP_ISA_MEM_BASE
34 /* PCI Memory space mapping info */
35 #define PRPMC750_PCI_MEM_SIZE 0x30000000U
36 #define PRPMC750_PROC_PCI_MEM_START PRPMC750_ISA_MEM_BASE
37 #define PRPMC750_PROC_PCI_MEM_END (PRPMC750_PROC_PCI_MEM_START + \
38 PRPMC750_PCI_MEM_SIZE - 1)
39 #define PRPMC750_PCI_MEM_START 0x00000000U
40 #define PRPMC750_PCI_MEM_END (PRPMC750_PCI_MEM_START + \
41 PRPMC750_PCI_MEM_SIZE - 1)
43 /* PCI I/O space mapping info */
44 #define PRPMC750_PCI_IO_SIZE 0x10000000U
45 #define PRPMC750_PROC_PCI_IO_START PRPMC750_ISA_IO_BASE
46 #define PRPMC750_PROC_PCI_IO_END (PRPMC750_PROC_PCI_IO_START + \
47 PRPMC750_PCI_IO_SIZE - 1)
48 #define PRPMC750_PCI_IO_START 0x00000000U
49 #define PRPMC750_PCI_IO_END (PRPMC750_PCI_IO_START + \
50 PRPMC750_PCI_IO_SIZE - 1)
52 /* System memory mapping info */
53 #define PRPMC750_PCI_DRAM_OFFSET PREP_PCI_DRAM_OFFSET
54 #define PRPMC750_PCI_PHY_MEM_OFFSET (PRPMC750_ISA_MEM_BASE-PRPMC750_PCI_MEM_START)
56 /* Register address definitions */
57 #define PRPMC750_HAWK_SMC_BASE 0xfef80000U
58 #define PRPMC750_HAWK_PPC_REG_BASE 0xfeff0000U
60 #define PRPMC750_BASE_BAUD 1843200
61 #define PRPMC750_SERIAL_0 0xfef88000
62 #define PRPMC750_SERIAL_0_DLL (PRPMC750_SERIAL_0 + (UART_DLL << 4))
63 #define PRPMC750_SERIAL_0_DLM (PRPMC750_SERIAL_0 + (UART_DLM << 4))
64 #define PRPMC750_SERIAL_0_LCR (PRPMC750_SERIAL_0 + (UART_LCR << 4))
66 #define PRPMC750_STATUS_REG 0xfef88080
67 #define PRPMC750_BAUDOUT_MASK 0x02
68 #define PRPMC750_MONARCH_MASK 0x01
70 #define PRPMC750_MODRST_REG 0xfef880a0
71 #define PRPMC750_MODRST_MASK 0x01
73 #define PRPMC750_PIRQ_REG 0xfef880b0
74 #define PRPMC750_SEL1_MASK 0x02
75 #define PRPMC750_SEL0_MASK 0x01
77 #define PRPMC750_TBEN_REG 0xfef880c0
78 #define PRPMC750_TBEN_MASK 0x01
80 /* UART Defines. */
81 #define RS_TABLE_SIZE 4
83 /* Rate for the 1.8432 Mhz clock for the onboard serial chip */
84 #define BASE_BAUD (PRPMC750_BASE_BAUD / 16)
86 #define STD_COM_FLAGS ASYNC_BOOT_AUTOCONF
88 #define SERIAL_PORT_DFNS \
89 { 0, BASE_BAUD, PRPMC750_SERIAL_0, 1, STD_COM_FLAGS, \
90 iomem_base: (unsigned char *)PRPMC750_SERIAL_0, \
91 iomem_reg_shift: 4, \
92 io_type: SERIAL_IO_MEM } /* ttyS0 */
94 #endif /* __ASM_PRPMC750_H__ */
95 #endif /* __KERNEL__ */