src/include/target/DIY_900_TX_ESP32_SX127x_E19.h

   1 // The name of the device in the LUA module
   2 #ifndef DEVICE_NAME
   3 #define DEVICE_NAME "DIY900 E19"
   4 #endif
   5
   6 // GPIO pin definitions
   7 #define GPIO_PIN_NSS 5
   8 #define GPIO_PIN_DIO0 26
   9 #define GPIO_PIN_DIO1 25
  10 #define GPIO_PIN_MOSI 23
  11 #define GPIO_PIN_MISO 19
  12 #define GPIO_PIN_SCK 18
  13 #define GPIO_PIN_RST 14
  14 #define GPIO_PIN_RX_ENABLE 13
  15 #define GPIO_PIN_TX_ENABLE 12
  16 #define GPIO_PIN_RCSIGNAL_RX 2
  17 #define GPIO_PIN_RCSIGNAL_TX 2 // so we don't have to solder the extra resistor, we switch rx/tx using gpio mux
  18 #define GPIO_PIN_LED 27
  19
  20 // Output Power
  21 #define MinPower    PWR_50mW
  22 #define HighPower   PWR_250mW
  23 #define MaxPower    PWR_1000mW
  24 #define POWER_OUTPUT_VALUES {2,5,8,12,15}