cpu/x86/smm/pci_resource_store: Store DEV/VEN ID
[coreboot2.git] / src / device / azalia_device.c
blob4ac585dac121bb6909104937a09e157bc7957b95
1 /* SPDX-License-Identifier: GPL-2.0-only */
3 #include <console/console.h>
4 #include <device/device.h>
5 #include <device/pci.h>
6 #include <device/azalia_device.h>
7 #include <device/mmio.h>
8 #include <delay.h>
9 #include <timer.h>
11 int azalia_set_bits(void *port, u32 mask, u32 val)
13 struct stopwatch sw;
14 u32 reg32;
16 /* Write (val & mask) to port */
17 val &= mask;
18 reg32 = read32(port);
19 reg32 &= ~mask;
20 reg32 |= val;
21 write32(port, reg32);
23 /* Wait for readback of register to match what was just written to it */
24 stopwatch_init_msecs_expire(&sw, 50);
25 do {
26 /* Wait 1ms based on BKDG wait time */
27 mdelay(1);
28 reg32 = read32(port);
29 reg32 &= mask;
30 } while ((reg32 != val) && !stopwatch_expired(&sw));
32 /* Timeout occurred */
33 if (stopwatch_expired(&sw))
34 return -1;
35 return 0;
38 int azalia_enter_reset(u8 *base)
40 /* Set bit 0 to 0 to enter reset state (BAR + 0x8)[0] */
41 return azalia_set_bits(base + HDA_GCTL_REG, HDA_GCTL_CRST, 0);
44 int azalia_exit_reset(u8 *base)
46 /* Set bit 0 to 1 to exit reset state (BAR + 0x8)[0] */
47 return azalia_set_bits(base + HDA_GCTL_REG, HDA_GCTL_CRST, HDA_GCTL_CRST);
50 static u16 codec_detect(u8 *base)
52 struct stopwatch sw;
53 u16 reg16;
55 if (azalia_exit_reset(base) < 0)
56 goto no_codec;
58 if (CONFIG(AZALIA_LOCK_DOWN_R_WO_GCAP)) {
59 /* If GCAP is R/WO, lock it down after deasserting controller reset */
60 write16(base + HDA_GCAP_REG, read16(base + HDA_GCAP_REG));
63 /* clear STATESTS bits (BAR + 0x0e)[14:0] */
64 reg16 = read16(base + HDA_STATESTS_REG);
65 reg16 |= 0x7fff;
66 write16(base + HDA_STATESTS_REG, reg16);
68 /* Wait for readback of register to
69 * match what was just written to it
71 stopwatch_init_msecs_expire(&sw, 50);
72 do {
73 /* Wait 1ms based on BKDG wait time */
74 mdelay(1);
75 reg16 = read16(base + HDA_STATESTS_REG);
76 } while ((reg16 != 0) && !stopwatch_expired(&sw));
78 /* Timeout occurred */
79 if (stopwatch_expired(&sw))
80 goto no_codec;
82 if (azalia_enter_reset(base) < 0)
83 goto no_codec;
85 if (azalia_exit_reset(base) < 0)
86 goto no_codec;
88 /* Read in Codec location (BAR + 0x0e)[14:0] */
89 reg16 = read16(base + HDA_STATESTS_REG);
90 reg16 &= 0x7fff;
91 if (!reg16)
92 goto no_codec;
94 return reg16;
96 no_codec:
97 /* Codec Not found */
98 /* Put HDA back in reset (BAR + 0x8) [0] */
99 azalia_set_bits(base + HDA_GCTL_REG, 1, 0);
100 printk(BIOS_DEBUG, "azalia_audio: No codec!\n");
101 return 0;
105 * Find a specific entry within a verb table
107 * @param verb_table: verb table data
108 * @param verb_table_bytes: verb table size in bytes
109 * @param viddid: vendor/device to search for
110 * @param verb: pointer to entry within table
112 * Returns size of the entry within the verb table,
113 * Returns 0 if the entry is not found
115 * The HDA verb table is composed of dwords. A set of 4 dwords is
116 * grouped together to form a "jack" descriptor.
117 * Bits 31:28 - Codec Address
118 * Bits 27:20 - NID
119 * Bits 19:8 - Verb ID
120 * Bits 7:0 - Payload
122 * coreboot groups different codec verb tables into a single table
123 * and prefixes each with a specific header consisting of 3
124 * dword entries:
125 * 1 - Codec Vendor/Device ID
126 * 2 - Subsystem ID
127 * 3 - Number of jacks (groups of 4 dwords) for this codec
129 u32 azalia_find_verb(const u32 *verb_table, u32 verb_table_bytes, u32 viddid, const u32 **verb)
131 int idx = 0;
133 while (idx < (verb_table_bytes / sizeof(u32))) {
134 /* Header contains the number of jacks, aka groups of 4 dwords */
135 u32 verb_size = 4 * verb_table[idx + 2];
136 if (verb_table[idx] != viddid) {
137 idx += verb_size + 3; // skip verb + header
138 continue;
140 *verb = &verb_table[idx + 3];
141 return verb_size;
144 /* Not all codecs need to load another verb */
145 return 0;
149 * Wait 50usec for the codec to indicate it is ready.
150 * No response would imply that the codec is non-operative.
153 static int wait_for_ready(u8 *base)
155 struct stopwatch sw;
156 /* Use a 50 usec timeout - the Linux kernel uses the same duration */
157 stopwatch_init_usecs_expire(&sw, 50);
159 while (!stopwatch_expired(&sw)) {
160 u32 reg32 = read32(base + HDA_ICII_REG);
161 if (!(reg32 & HDA_ICII_BUSY))
162 return 0;
163 udelay(1);
166 return -1;
170 * Wait for the codec to indicate that it accepted the previous command.
171 * No response would imply that the codec is non-operative.
174 static int wait_for_valid(u8 *base)
176 struct stopwatch sw;
177 u32 reg32;
179 /* Send the verb to the codec */
180 reg32 = read32(base + HDA_ICII_REG);
181 reg32 |= HDA_ICII_BUSY | HDA_ICII_VALID;
182 write32(base + HDA_ICII_REG, reg32);
185 * The timeout is never reached when the codec is functioning properly.
186 * Using a small timeout value can result in spurious errors with some
187 * codecs, e.g. a codec that is slow to respond but operates correctly.
188 * When a codec is non-operative, the timeout is only reached once per
189 * verb table, thus the impact on booting time is relatively small. So,
190 * use a reasonably long enough timeout to cover all possible cases.
192 stopwatch_init_msecs_expire(&sw, 1);
193 while (!stopwatch_expired(&sw)) {
194 reg32 = read32(base + HDA_ICII_REG);
195 if ((reg32 & (HDA_ICII_VALID | HDA_ICII_BUSY)) == HDA_ICII_VALID)
196 return 0;
197 udelay(1);
200 return -1;
203 static int azalia_write_verb(u8 *base, u32 verb)
205 if (wait_for_ready(base) < 0)
206 return -1;
208 write32(base + HDA_IC_REG, verb);
210 return wait_for_valid(base);
213 int azalia_program_verb_table(u8 *base, const u32 *verbs, u32 verb_size)
215 if (!verbs)
216 return 0;
218 for (u32 i = 0; i < verb_size; i++) {
219 if (azalia_write_verb(base, verbs[i]) < 0)
220 return -1;
222 return 0;
225 __weak void mainboard_azalia_program_runtime_verbs(u8 *base, u32 viddid)
229 void azalia_codec_init(u8 *base, int addr, const u32 *verb_table, u32 verb_table_bytes)
231 u32 reg32;
232 const u32 *verb;
233 u32 verb_size;
235 printk(BIOS_DEBUG, "azalia_audio: Initializing codec #%d\n", addr);
237 /* 1 */
238 if (wait_for_ready(base) < 0) {
239 printk(BIOS_DEBUG, " codec not ready.\n");
240 return;
243 reg32 = (addr << 28) | 0x000f0000;
244 write32(base + HDA_IC_REG, reg32);
246 if (wait_for_valid(base) < 0) {
247 printk(BIOS_DEBUG, " codec not valid.\n");
248 return;
251 /* 2 */
252 reg32 = read32(base + HDA_IR_REG);
253 printk(BIOS_DEBUG, "azalia_audio: codec viddid: %08x\n", reg32);
254 verb_size = azalia_find_verb(verb_table, verb_table_bytes, reg32, &verb);
256 if (!verb_size) {
257 printk(BIOS_DEBUG, "azalia_audio: No verb!\n");
258 return;
260 printk(BIOS_DEBUG, "azalia_audio: verb_size: %u\n", verb_size);
262 /* 3 */
263 const int rc = azalia_program_verb_table(base, verb, verb_size);
264 if (rc < 0)
265 printk(BIOS_DEBUG, "azalia_audio: verb not loaded.\n");
266 else
267 printk(BIOS_DEBUG, "azalia_audio: verb loaded.\n");
269 mainboard_azalia_program_runtime_verbs(base, reg32);
272 void azalia_codecs_init(u8 *base, u16 codec_mask)
274 int i;
276 for (i = 14; i >= 0; i--) {
277 if (codec_mask & (1 << i))
278 azalia_codec_init(base, i, cim_verb_data, cim_verb_data_size);
281 azalia_program_verb_table(base, pc_beep_verbs, pc_beep_verbs_size);
284 void azalia_audio_init(struct device *dev)
286 u8 *base;
287 struct resource *res;
288 u16 codec_mask;
290 res = probe_resource(dev, PCI_BASE_ADDRESS_0);
291 if (!res)
292 return;
294 // NOTE this will break as soon as the azalia_audio gets a bar above 4G.
295 // Is there anything we can do about it?
296 base = res2mmio(res, 0, 0);
297 printk(BIOS_DEBUG, "azalia_audio: base = %p\n", base);
298 codec_mask = codec_detect(base);
300 if (codec_mask) {
301 printk(BIOS_DEBUG, "azalia_audio: codec_mask = %02x\n", codec_mask);
302 azalia_codecs_init(base, codec_mask);
306 struct device_operations default_azalia_audio_ops = {
307 .read_resources = pci_dev_read_resources,
308 .set_resources = pci_dev_set_resources,
309 .enable_resources = pci_dev_enable_resources,
310 .init = azalia_audio_init,
311 .ops_pci = &pci_dev_ops_pci,