[NET]: Move netlink interface bits to linux/if.h
[hh.org.git] / drivers / net / sk_mca.h
blobd6fa1823dfa625973867c49703785fea944dda39
1 #ifndef _SK_MCA_INCLUDE_
2 #define _SK_MCA_INCLUDE_
4 #ifdef _SK_MCA_DRIVER_
6 /* Adapter ID's */
7 #define SKNET_MCA_ID 0x6afd
8 #define SKNET_JUNIOR_MCA_ID 0x6be9
10 /* media enumeration - defined in a way that it fits onto the MC2+'s
11 POS registers... */
13 typedef enum { Media_10Base2, Media_10BaseT,
14 Media_10Base5, Media_Unknown, Media_Count
15 } skmca_medium;
17 /* private structure */
18 typedef struct {
19 unsigned int slot; /* MCA-Slot-# */
20 void __iomem *base;
21 void __iomem *macbase; /* base address of MAC address PROM */
22 void __iomem *ioregaddr;/* address of I/O-register (Lo) */
23 void __iomem *ctrladdr; /* address of control/stat register */
24 void __iomem *cmdaddr; /* address of I/O-command register */
25 int nextrx; /* index of next RX descriptor to
26 be read */
27 int nexttxput; /* index of next free TX descriptor */
28 int nexttxdone; /* index of next TX descriptor to
29 be finished */
30 int txbusy; /* # of busy TX descriptors */
31 struct net_device_stats stat; /* packet statistics */
32 int realirq; /* memorizes actual IRQ, even when
33 currently not allocated */
34 skmca_medium medium; /* physical cannector */
35 spinlock_t lock;
36 } skmca_priv;
38 /* card registers: control/status register bits */
40 #define CTRL_ADR_DATA 0 /* Bit 0 = 0 ->access data register */
41 #define CTRL_ADR_RAP 1 /* Bit 0 = 1 ->access RAP register */
42 #define CTRL_RW_WRITE 0 /* Bit 1 = 0 ->write register */
43 #define CTRL_RW_READ 2 /* Bit 1 = 1 ->read register */
44 #define CTRL_RESET_ON 0 /* Bit 3 = 0 ->reset board */
45 #define CTRL_RESET_OFF 8 /* Bit 3 = 1 ->no reset of board */
47 #define STAT_ADR_DATA 0 /* Bit 0 of ctrl register read back */
48 #define STAT_ADR_RAP 1
49 #define STAT_RW_WRITE 0 /* Bit 1 of ctrl register read back */
50 #define STAT_RW_READ 2
51 #define STAT_RESET_ON 0 /* Bit 3 of ctrl register read back */
52 #define STAT_RESET_OFF 8
53 #define STAT_IRQ_ACT 0 /* interrupt pending */
54 #define STAT_IRQ_NOACT 16 /* no interrupt pending */
55 #define STAT_IO_NOBUSY 0 /* no transfer busy */
56 #define STAT_IO_BUSY 32 /* transfer busy */
58 /* I/O command register bits */
60 #define IOCMD_GO 128 /* Bit 7 = 1 -> start register xfer */
62 /* LANCE registers */
64 #define LANCE_CSR0 0 /* Status/Control */
66 #define CSR0_ERR 0x8000 /* general error flag */
67 #define CSR0_BABL 0x4000 /* transmitter timeout */
68 #define CSR0_CERR 0x2000 /* collision error */
69 #define CSR0_MISS 0x1000 /* lost Rx block */
70 #define CSR0_MERR 0x0800 /* memory access error */
71 #define CSR0_RINT 0x0400 /* receiver interrupt */
72 #define CSR0_TINT 0x0200 /* transmitter interrupt */
73 #define CSR0_IDON 0x0100 /* initialization done */
74 #define CSR0_INTR 0x0080 /* general interrupt flag */
75 #define CSR0_INEA 0x0040 /* interrupt enable */
76 #define CSR0_RXON 0x0020 /* receiver enabled */
77 #define CSR0_TXON 0x0010 /* transmitter enabled */
78 #define CSR0_TDMD 0x0008 /* force transmission now */
79 #define CSR0_STOP 0x0004 /* stop LANCE */
80 #define CSR0_STRT 0x0002 /* start LANCE */
81 #define CSR0_INIT 0x0001 /* read initialization block */
83 #define LANCE_CSR1 1 /* addr bit 0..15 of initialization */
84 #define LANCE_CSR2 2 /* 16..23 block */
86 #define LANCE_CSR3 3 /* Bus control */
87 #define CSR3_BCON_HOLD 0 /* Bit 0 = 0 -> BM1,BM0,HOLD */
88 #define CSR3_BCON_BUSRQ 1 /* Bit 0 = 1 -> BUSAK0,BYTE,BUSRQ */
89 #define CSR3_ALE_HIGH 0 /* Bit 1 = 0 -> ALE asserted high */
90 #define CSR3_ALE_LOW 2 /* Bit 1 = 1 -> ALE asserted low */
91 #define CSR3_BSWAP_OFF 0 /* Bit 2 = 0 -> no byte swap */
92 #define CSR3_BSWAP_ON 4 /* Bit 2 = 1 -> byte swap */
94 /* LANCE structures */
96 typedef struct { /* LANCE initialization block */
97 u16 Mode; /* mode flags */
98 u8 PAdr[6]; /* MAC address */
99 u8 LAdrF[8]; /* Multicast filter */
100 u32 RdrP; /* Receive descriptor */
101 u32 TdrP; /* Transmit descriptor */
102 } LANCE_InitBlock;
104 /* Mode flags init block */
106 #define LANCE_INIT_PROM 0x8000 /* enable promiscous mode */
107 #define LANCE_INIT_INTL 0x0040 /* internal loopback */
108 #define LANCE_INIT_DRTY 0x0020 /* disable retry */
109 #define LANCE_INIT_COLL 0x0010 /* force collision */
110 #define LANCE_INIT_DTCR 0x0008 /* disable transmit CRC */
111 #define LANCE_INIT_LOOP 0x0004 /* loopback */
112 #define LANCE_INIT_DTX 0x0002 /* disable transmitter */
113 #define LANCE_INIT_DRX 0x0001 /* disable receiver */
115 typedef struct { /* LANCE Tx descriptor */
116 u16 LowAddr; /* bit 0..15 of address */
117 u16 Flags; /* bit 16..23 of address + Flags */
118 u16 Len; /* 2s complement of packet length */
119 u16 Status; /* Result of transmission */
120 } LANCE_TxDescr;
122 #define TXDSCR_FLAGS_OWN 0x8000 /* LANCE owns descriptor */
123 #define TXDSCR_FLAGS_ERR 0x4000 /* summary error flag */
124 #define TXDSCR_FLAGS_MORE 0x1000 /* more than one retry needed? */
125 #define TXDSCR_FLAGS_ONE 0x0800 /* one retry? */
126 #define TXDSCR_FLAGS_DEF 0x0400 /* transmission deferred? */
127 #define TXDSCR_FLAGS_STP 0x0200 /* first packet in chain? */
128 #define TXDSCR_FLAGS_ENP 0x0100 /* last packet in chain? */
130 #define TXDSCR_STATUS_BUFF 0x8000 /* buffer error? */
131 #define TXDSCR_STATUS_UFLO 0x4000 /* silo underflow during transmit? */
132 #define TXDSCR_STATUS_LCOL 0x1000 /* late collision? */
133 #define TXDSCR_STATUS_LCAR 0x0800 /* loss of carrier? */
134 #define TXDSCR_STATUS_RTRY 0x0400 /* retry error? */
136 typedef struct { /* LANCE Rx descriptor */
137 u16 LowAddr; /* bit 0..15 of address */
138 u16 Flags; /* bit 16..23 of address + Flags */
139 u16 MaxLen; /* 2s complement of buffer length */
140 u16 Len; /* packet length */
141 } LANCE_RxDescr;
143 #define RXDSCR_FLAGS_OWN 0x8000 /* LANCE owns descriptor */
144 #define RXDSCR_FLAGS_ERR 0x4000 /* summary error flag */
145 #define RXDSCR_FLAGS_FRAM 0x2000 /* framing error flag */
146 #define RXDSCR_FLAGS_OFLO 0x1000 /* FIFO overflow? */
147 #define RXDSCR_FLAGS_CRC 0x0800 /* CRC error? */
148 #define RXDSCR_FLAGS_BUFF 0x0400 /* buffer error? */
149 #define RXDSCR_FLAGS_STP 0x0200 /* first packet in chain? */
150 #define RXDCSR_FLAGS_ENP 0x0100 /* last packet in chain? */
152 /* RAM layout */
154 #define TXCOUNT 4 /* length of TX descriptor queue */
155 #define LTXCOUNT 2 /* log2 of it */
156 #define RXCOUNT 4 /* length of RX descriptor queue */
157 #define LRXCOUNT 2 /* log2 of it */
159 #define RAM_INITBASE 0 /* LANCE init block */
160 #define RAM_TXBASE 24 /* Start of TX descriptor queue */
161 #define RAM_RXBASE \
162 (RAM_TXBASE + (TXCOUNT * 8)) /* Start of RX descriptor queue */
163 #define RAM_DATABASE \
164 (RAM_RXBASE + (RXCOUNT * 8)) /* Start of data area for frames */
165 #define RAM_BUFSIZE 1580 /* max. frame size - should never be
166 reached */
168 #endif /* _SK_MCA_DRIVER_ */
170 #endif /* _SK_MCA_INCLUDE_ */