manual/main_menu/recording_screen.tex

   1 % $Id$ %
   2 \section{\label{ref:Recording}Recording}
   3 \subsection{\label{ref:while_recording_screen}While Recording Screen}
   4 \screenshot{main_menu/images/ss-while-recording-screen}{The while recording
   5   screen}{}
   6
   7 Selecting the \setting{Recording} option in the \setting{Main Menu} enters
   8 the \setting{Recording Screen}, whilst pressing \ActionStdContext{} enters the
   9 \setting{Recording Settings} (see \reference{ref:Recordingsettings}).
  10 The \setting{Recording Screen}
  11 shows the time elapsed and the size of the file being recorded. A peak meter
  12 is present to allow you set gain correctly. There is also a volume setting,
  13 this will only affect the output level of the \dap{} and does \emph{not}
  14 affect the recorded sound. If enabled in the peak meter settings, a counter in
  15 front of the peak meters shows the number of times the clip indicator was
  16 activated during recording. The counter is reset to zero when starting a new
  17 recording.\\*
  18
  19 \opt{recording_swcodec}{
  20 \opt{disk_storage}{
  21 \note{When you start a recording, the hard disk will spin up. This will cause
  22 the peak meters to freeze in the process. This is expected behaviour, and
  23 nothing to worry about. The recording continues during the spin up.\\*}}}
  24
  25 \opt{recording_hwcodec}{The frequency, channels and quality}
  26 \opt{recording_swcodec}{The frequency and channels} settings are shown in the
  27 status bar.\\*
  28
  29 The controls for this screen are:
  30 \begin{table}
  31   \begin{btnmap}{}{}
  32
  33     \ActionRecPrev{} / \ActionRecNext
  34     \opt{HAVEREMOTEKEYMAP}{& \ActionRCRecPrev{} / \ActionRCRecNext}
  35     & Select setting.\\
  36     %
  37     \ActionRecSettingsDec{} / \ActionRecSettingsInc
  38     \opt{HAVEREMOTEKEYMAP}{& \ActionRCRecSettingsDec{} / \ActionRecSettingsInc}
  39     & Adjust selected setting.\\
  40     %
  41     \ActionRecPause
  42     \opt{HAVEREMOTEKEYMAP}{& \ActionRCRecPause}
  43                     & Start recording.\\
  44                     & \opt{HAVEREMOTEKEYMAP}{&}
  45                       While recording: pause recording (press again to
  46                       continue).\\
  47     %
  48     \ActionRecExit
  49     \opt{HAVEREMOTEKEYMAP}{& \ActionRCRecExit}
  50                     & Exit \setting{Recording Screen}.\\
  51                     & \opt{HAVEREMOTEKEYMAP}{&}
  52                       While recording: Stop recording.\\
  53     %
  54     \opt{IRIVER_H10_PAD,IRIVER_H100_PAD,IRIVER_H300_PAD,IAUDIO_X5_PAD,%
  55          SANSA_E200_PAD,IPOD_4G_PAD,SANSA_C200_PAD}{
  56       \ActionRecNewfile
  57       \opt{HAVEREMOTEKEYMAP}{& \ActionRCRecNewfile}
  58                      & While recording: close the current file and open
  59                      a new one.\\
  60     }
  61     %
  62     \ActionRecMenu
  63     \opt{HAVEREMOTEKEYMAP}{& \ActionRCRecMenu}
  64                        & Open \setting{Recording Settings} (see
  65                        \reference{ref:Recordingsettings}).\\
  66     %
  67     \opt{RECORDER_PAD}{
  68       \ActionRecFTwo & Quick menu for recording settings. A quick press will
  69       leave the screen up (press \ActionRecFTwo{} again to exit), while holding
  70       it will close the screen when you release it.\\
  71     }
  72     %
  73     \opt{RECORDER_PAD}{
  74       \ActionRecFThree & Quick menu for source setting.\\
  75       & Quick/hold works as for \ActionRecFTwo.\\
  76       & While recording: Start a new recording file.\\
  77     }
  78   \end{btnmap}
  79 \end{table}