sound/oss/ac97.h

   1 /*
   2  * ac97.h
   3  *
   4  * definitions for the AC97, Intel's Audio Codec 97 Spec
   5  * also includes support for a generic AC97 interface
   6  */
   7
   8 #ifndef _AC97_H_
   9 #define _AC97_H_
  10 #include "sound_config.h"
  11 #include "sound_calls.h"
  12
  13 #define  AC97_RESET              0x0000      //
  14 #define  AC97_MASTER_VOL_STEREO  0x0002      // Line Out
  15 #define  AC97_HEADPHONE_VOL      0x0004      //
  16 #define  AC97_MASTER_VOL_MONO    0x0006      // TAD Output
  17 #define  AC97_MASTER_TONE        0x0008      //
  18 #define  AC97_PCBEEP_VOL         0x000a      // none
  19 #define  AC97_PHONE_VOL          0x000c      // TAD Input (mono)
  20 #define  AC97_MIC_VOL            0x000e      // MIC Input (mono)
  21 #define  AC97_LINEIN_VOL         0x0010      // Line Input (stereo)
  22 #define  AC97_CD_VOL             0x0012      // CD Input (stereo)
  23 #define  AC97_VIDEO_VOL          0x0014      // none
  24 #define  AC97_AUX_VOL            0x0016      // Aux Input (stereo)
  25 #define  AC97_PCMOUT_VOL         0x0018      // Wave Output (stereo)
  26 #define  AC97_RECORD_SELECT      0x001a      //
  27 #define  AC97_RECORD_GAIN        0x001c
  28 #define  AC97_RECORD_GAIN_MIC    0x001e
  29 #define  AC97_GENERAL_PURPOSE    0x0020
  30 #define  AC97_3D_CONTROL         0x0022
  31 #define  AC97_MODEM_RATE         0x0024
  32 #define  AC97_POWER_CONTROL      0x0026
  33
  34 /* registers 0x0028 - 0x0058 are reserved */
  35
  36 /* AC'97 2.0 */
  37 #define AC97_EXTENDED_ID        0x0028  /* Extended Audio ID */
  38 #define AC97_EXTENDED_STATUS    0x002A  /* Extended Audio Status */
  39 #define AC97_PCM_FRONT_DAC_RATE 0x002C  /* PCM Front DAC Rate */
  40 #define AC97_PCM_SURR_DAC_RATE  0x002E  /* PCM Surround DAC Rate */
  41 #define AC97_PCM_LFE_DAC_RATE   0x0030  /* PCM LFE DAC Rate */
  42 #define AC97_PCM_LR_ADC_RATE    0x0032  /* PCM LR DAC Rate */
  43 #define AC97_PCM_MIC_ADC_RATE   0x0034  /* PCM MIC ADC Rate */
  44 #define AC97_CENTER_LFE_MASTER  0x0036  /* Center + LFE Master Volume */
  45 #define AC97_SURROUND_MASTER    0x0038  /* Surround (Rear) Master Volume */
  46 #define AC97_RESERVED_3A        0x003A  /* Reserved */
  47 /* range 0x3c-0x58 - MODEM */
  48
  49 /* registers 0x005a - 0x007a are vendor reserved */
  50
  51 #define  AC97_VENDOR_ID1         0x007c
  52 #define  AC97_VENDOR_ID2         0x007e
  53
  54 /* volume control bit defines */
  55
  56 #define AC97_MUTE                0x8000
  57 #define AC97_MICBOOST            0x0040
  58 #define AC97_LEFTVOL             0x3f00
  59 #define AC97_RIGHTVOL            0x003f
  60
  61 /* record mux defines */
  62
  63 #define AC97_RECMUX_MIC          0x0000
  64 #define AC97_RECMUX_CD           0x0101
  65 #define AC97_RECMUX_VIDEO        0x0202      /* not used */
  66 #define AC97_RECMUX_AUX          0x0303
  67 #define AC97_RECMUX_LINE         0x0404
  68 #define AC97_RECMUX_STEREO_MIX   0x0505
  69 #define AC97_RECMUX_MONO_MIX     0x0606
  70 #define AC97_RECMUX_PHONE        0x0707
  71
  72
  73 /* general purpose register bit defines */
  74
  75 #define AC97_GP_LPBK             0x0080      /* Loopback mode */
  76 #define AC97_GP_MS               0x0100      /* Mic Select 0=Mic1, 1=Mic2 */
  77 #define AC97_GP_MIX              0x0200      /* Mono output select 0=Mix, 1=Mic */
  78 #define AC97_GP_RLBK             0x0400      /* Remote Loopback - Modem line codec */
  79 #define AC97_GP_LLBK             0x0800      /* Local Loopback - Modem Line codec */
  80 #define AC97_GP_LD               0x1000      /* Loudness 1=on */
  81 #define AC97_GP_3D               0x2000      /* 3D Enhancement 1=on */
  82 #define AC97_GP_ST               0x4000      /* Stereo Enhancement 1=on */
  83 #define AC97_GP_POP              0x8000      /* Pcm Out Path, 0=pre 3D, 1=post 3D */
  84
  85
  86 /* powerdown control and status bit defines */
  87
  88 /* status */
  89 #define AC97_PWR_MDM             0x0010      /* Modem section ready */
  90 #define AC97_PWR_REF             0x0008      /* Vref nominal */
  91 #define AC97_PWR_ANL             0x0004      /* Analog section ready */
  92 #define AC97_PWR_DAC             0x0002      /* DAC section ready */
  93 #define AC97_PWR_ADC             0x0001      /* ADC section ready */
  94
  95 /* control */
  96 #define AC97_PWR_PR0             0x0100      /* ADC and Mux powerdown */
  97 #define AC97_PWR_PR1             0x0200      /* DAC powerdown */
  98 #define AC97_PWR_PR2             0x0400      /* Output mixer powerdown (Vref on) */
  99 #define AC97_PWR_PR3             0x0800      /* Output mixer powerdown (Vref off) */
 100 #define AC97_PWR_PR4             0x1000      /* AC-link powerdown */
 101 #define AC97_PWR_PR5             0x2000      /* Internal Clk disable */
 102 #define AC97_PWR_PR6             0x4000      /* HP amp powerdown */
 103 #define AC97_PWR_PR7             0x8000      /* Modem off - if supported */
 104
 105 /* useful power states */
 106 #define AC97_PWR_D0              0x0000      /* everything on */
 107 #define AC97_PWR_D1              AC97_PWR_PR0|AC97_PWR_PR1|AC97_PWR_PR4
 108 #define AC97_PWR_D2              AC97_PWR_PR0|AC97_PWR_PR1|AC97_PWR_PR2|AC97_PWR_PR3|AC97_PWR_PR4
 109 #define AC97_PWR_D3              AC97_PWR_PR0|AC97_PWR_PR1|AC97_PWR_PR2|AC97_PWR_PR3|AC97_PWR_PR4
 110 #define AC97_PWR_ANLOFF          AC97_PWR_PR2|AC97_PWR_PR3  /* analog section off */
 111
 112 /* Total number of defined registers.  */
 113 #define AC97_REG_CNT 64
 114
 115 /* Generic AC97 mixer interface. */
 116
 117 /* Structure describing access to the hardware. */
 118 struct ac97_hwint
 119 {
 120     /* Perform any hardware-specific reset and initialization.  Returns
 121      0 on success, or a negative error code.  */
 122     int (*reset_device) (struct ac97_hwint *dev);
 123
 124     /* Returns the contents of the specified register REG.  The caller
 125        should check to see if the desired contents are available in
 126        the cache first, if applicable. Returns a positive unsigned value
 127        representing the contents of the register, or a negative error
 128        code.  */
 129     int (*read_reg) (struct ac97_hwint *dev, u8 reg);
 130
 131     /* Writes VALUE to register REG.  Returns 0 on success, or a
 132        negative error code.  */
 133     int (*write_reg) (struct ac97_hwint *dev, u8 reg, u16 value);
 134
 135     /* Hardware-specific information. */
 136     void *driver_private;
 137
 138     /* Three OSS masks. */
 139     int mixer_devmask;
 140     int mixer_stereomask;
 141     int mixer_recmask;
 142
 143     /* The mixer cache. The indices correspond to the AC97 hardware register
 144        number / 2, since the register numbers are always an even number.
 145
 146        Unknown values are set to -1; unsupported registers contain a
 147        -2.  */
 148     int last_written_mixer_values[AC97_REG_CNT];
 149
 150     /* A cache of values written via OSS; we need these so we can return
 151        the values originally written by the user.
 152
 153        Why the original user values?  Because the real-world hardware
 154        has less precision, and some existing applications assume that
 155        they will get back the exact value that they wrote (aumix).
 156
 157        A -1 value indicates that no value has been written to this mixer
 158        channel via OSS.  */
 159     int last_written_OSS_values[SOUND_MIXER_NRDEVICES];
 160 };
 161
 162 /* Values stored in the register cache.  */
 163 #define AC97_REGVAL_UNKNOWN -1
 164 #define AC97_REG_UNSUPPORTED -2
 165
 166 struct ac97_mixer_value_list
 167 {
 168     /* Mixer channel to set.  List is terminated by a value of -1.  */
 169     int oss_channel;
 170     /* The scaled value to set it to; values generally range from 0-100. */
 171     union {
 172         struct {
 173             u8 left, right;
 174         } stereo;
 175         u8 mono;
 176     } value;
 177 };
 178
 179 /* Initialize the ac97 mixer by resetting it.  */
 180 extern int ac97_init (struct ac97_hwint *dev);
 181
 182 /* Sets the mixer DEV to the values in VALUE_LIST.  Returns 0 on success,
 183    or a negative error code.  */
 184 extern int ac97_set_values (struct ac97_hwint *dev,
 185                             struct ac97_mixer_value_list *value_list);
 186
 187 /* Writes the specified VALUE to the AC97 register REG in the mixer.
 188    Takes care of setting the last-written cache as well.  */
 189 extern int ac97_put_register (struct ac97_hwint *dev, u8 reg, u16 value);
 190
 191 /* Default ioctl. */
 192 extern int ac97_mixer_ioctl (struct ac97_hwint *dev, unsigned int cmd,
 193                              void __user * arg);
 194
 195 #endif
 196 \f
 197 /*
 198  * Local variables:
 199  *  c-basic-offset: 4
 200  * End:
 201  */