Add linux-next specific files for 20110421
[linux-2.6/next.git] / drivers / usb / serial / ti_usb_3410_5052.h
blob2aac1953993b1c9508283a8ecfef303c9fa26f1e
1 /* vi: ts=8 sw=8
3 * TI 3410/5052 USB Serial Driver Header
5 * Copyright (C) 2004 Texas Instruments
7 * This driver is based on the Linux io_ti driver, which is
8 * Copyright (C) 2000-2002 Inside Out Networks
9 * Copyright (C) 2001-2002 Greg Kroah-Hartman
11 * This program is free software; you can redistribute it and/or modify
12 * it under the terms of the GNU General Public License as published by
13 * the Free Software Foundation; either version 2 of the License, or
14 * (at your option) any later version.
16 * For questions or problems with this driver, contact Texas Instruments
17 * technical support, or Al Borchers <alborchers@steinerpoint.com>, or
18 * Peter Berger <pberger@brimson.com>.
21 #ifndef _TI_3410_5052_H_
22 #define _TI_3410_5052_H_
24 /* Configuration ids */
25 #define TI_BOOT_CONFIG 1
26 #define TI_ACTIVE_CONFIG 2
28 /* Vendor and product ids */
29 #define TI_VENDOR_ID 0x0451
30 #define IBM_VENDOR_ID 0x04b3
31 #define TI_3410_PRODUCT_ID 0x3410
32 #define IBM_4543_PRODUCT_ID 0x4543
33 #define IBM_454B_PRODUCT_ID 0x454b
34 #define IBM_454C_PRODUCT_ID 0x454c
35 #define TI_3410_EZ430_ID 0xF430 /* TI ez430 development tool */
36 #define TI_5052_BOOT_PRODUCT_ID 0x5052 /* no EEPROM, no firmware */
37 #define TI_5152_BOOT_PRODUCT_ID 0x5152 /* no EEPROM, no firmware */
38 #define TI_5052_EEPROM_PRODUCT_ID 0x505A /* EEPROM, no firmware */
39 #define TI_5052_FIRMWARE_PRODUCT_ID 0x505F /* firmware is running */
41 /* Multi-Tech vendor and product ids */
42 #define MTS_VENDOR_ID 0x06E0
43 #define MTS_GSM_NO_FW_PRODUCT_ID 0xF108
44 #define MTS_CDMA_NO_FW_PRODUCT_ID 0xF109
45 #define MTS_CDMA_PRODUCT_ID 0xF110
46 #define MTS_GSM_PRODUCT_ID 0xF111
47 #define MTS_EDGE_PRODUCT_ID 0xF112
48 #define MTS_MT9234MU_PRODUCT_ID 0xF114
49 #define MTS_MT9234ZBA_PRODUCT_ID 0xF115
50 #define MTS_MT9234ZBAOLD_PRODUCT_ID 0x0319
52 /* Commands */
53 #define TI_GET_VERSION 0x01
54 #define TI_GET_PORT_STATUS 0x02
55 #define TI_GET_PORT_DEV_INFO 0x03
56 #define TI_GET_CONFIG 0x04
57 #define TI_SET_CONFIG 0x05
58 #define TI_OPEN_PORT 0x06
59 #define TI_CLOSE_PORT 0x07
60 #define TI_START_PORT 0x08
61 #define TI_STOP_PORT 0x09
62 #define TI_TEST_PORT 0x0A
63 #define TI_PURGE_PORT 0x0B
64 #define TI_RESET_EXT_DEVICE 0x0C
65 #define TI_WRITE_DATA 0x80
66 #define TI_READ_DATA 0x81
67 #define TI_REQ_TYPE_CLASS 0x82
69 /* Module identifiers */
70 #define TI_I2C_PORT 0x01
71 #define TI_IEEE1284_PORT 0x02
72 #define TI_UART1_PORT 0x03
73 #define TI_UART2_PORT 0x04
74 #define TI_RAM_PORT 0x05
76 /* Modem status */
77 #define TI_MSR_DELTA_CTS 0x01
78 #define TI_MSR_DELTA_DSR 0x02
79 #define TI_MSR_DELTA_RI 0x04
80 #define TI_MSR_DELTA_CD 0x08
81 #define TI_MSR_CTS 0x10
82 #define TI_MSR_DSR 0x20
83 #define TI_MSR_RI 0x40
84 #define TI_MSR_CD 0x80
85 #define TI_MSR_DELTA_MASK 0x0F
86 #define TI_MSR_MASK 0xF0
88 /* Line status */
89 #define TI_LSR_OVERRUN_ERROR 0x01
90 #define TI_LSR_PARITY_ERROR 0x02
91 #define TI_LSR_FRAMING_ERROR 0x04
92 #define TI_LSR_BREAK 0x08
93 #define TI_LSR_ERROR 0x0F
94 #define TI_LSR_RX_FULL 0x10
95 #define TI_LSR_TX_EMPTY 0x20
97 /* Line control */
98 #define TI_LCR_BREAK 0x40
100 /* Modem control */
101 #define TI_MCR_LOOP 0x04
102 #define TI_MCR_DTR 0x10
103 #define TI_MCR_RTS 0x20
105 /* Mask settings */
106 #define TI_UART_ENABLE_RTS_IN 0x0001
107 #define TI_UART_DISABLE_RTS 0x0002
108 #define TI_UART_ENABLE_PARITY_CHECKING 0x0008
109 #define TI_UART_ENABLE_DSR_OUT 0x0010
110 #define TI_UART_ENABLE_CTS_OUT 0x0020
111 #define TI_UART_ENABLE_X_OUT 0x0040
112 #define TI_UART_ENABLE_XA_OUT 0x0080
113 #define TI_UART_ENABLE_X_IN 0x0100
114 #define TI_UART_ENABLE_DTR_IN 0x0800
115 #define TI_UART_DISABLE_DTR 0x1000
116 #define TI_UART_ENABLE_MS_INTS 0x2000
117 #define TI_UART_ENABLE_AUTO_START_DMA 0x4000
119 /* Parity */
120 #define TI_UART_NO_PARITY 0x00
121 #define TI_UART_ODD_PARITY 0x01
122 #define TI_UART_EVEN_PARITY 0x02
123 #define TI_UART_MARK_PARITY 0x03
124 #define TI_UART_SPACE_PARITY 0x04
126 /* Stop bits */
127 #define TI_UART_1_STOP_BITS 0x00
128 #define TI_UART_1_5_STOP_BITS 0x01
129 #define TI_UART_2_STOP_BITS 0x02
131 /* Bits per character */
132 #define TI_UART_5_DATA_BITS 0x00
133 #define TI_UART_6_DATA_BITS 0x01
134 #define TI_UART_7_DATA_BITS 0x02
135 #define TI_UART_8_DATA_BITS 0x03
137 /* 232/485 modes */
138 #define TI_UART_232 0x00
139 #define TI_UART_485_RECEIVER_DISABLED 0x01
140 #define TI_UART_485_RECEIVER_ENABLED 0x02
142 /* Pipe transfer mode and timeout */
143 #define TI_PIPE_MODE_CONTINOUS 0x01
144 #define TI_PIPE_MODE_MASK 0x03
145 #define TI_PIPE_TIMEOUT_MASK 0x7C
146 #define TI_PIPE_TIMEOUT_ENABLE 0x80
148 /* Config struct */
149 struct ti_uart_config {
150 __u16 wBaudRate;
151 __u16 wFlags;
152 __u8 bDataBits;
153 __u8 bParity;
154 __u8 bStopBits;
155 char cXon;
156 char cXoff;
157 __u8 bUartMode;
158 } __attribute__((packed));
160 /* Get port status */
161 struct ti_port_status {
162 __u8 bCmdCode;
163 __u8 bModuleId;
164 __u8 bErrorCode;
165 __u8 bMSR;
166 __u8 bLSR;
167 } __attribute__((packed));
169 /* Purge modes */
170 #define TI_PURGE_OUTPUT 0x00
171 #define TI_PURGE_INPUT 0x80
173 /* Read/Write data */
174 #define TI_RW_DATA_ADDR_SFR 0x10
175 #define TI_RW_DATA_ADDR_IDATA 0x20
176 #define TI_RW_DATA_ADDR_XDATA 0x30
177 #define TI_RW_DATA_ADDR_CODE 0x40
178 #define TI_RW_DATA_ADDR_GPIO 0x50
179 #define TI_RW_DATA_ADDR_I2C 0x60
180 #define TI_RW_DATA_ADDR_FLASH 0x70
181 #define TI_RW_DATA_ADDR_DSP 0x80
183 #define TI_RW_DATA_UNSPECIFIED 0x00
184 #define TI_RW_DATA_BYTE 0x01
185 #define TI_RW_DATA_WORD 0x02
186 #define TI_RW_DATA_DOUBLE_WORD 0x04
188 struct ti_write_data_bytes {
189 __u8 bAddrType;
190 __u8 bDataType;
191 __u8 bDataCounter;
192 __be16 wBaseAddrHi;
193 __be16 wBaseAddrLo;
194 __u8 bData[0];
195 } __attribute__((packed));
197 struct ti_read_data_request {
198 __u8 bAddrType;
199 __u8 bDataType;
200 __u8 bDataCounter;
201 __be16 wBaseAddrHi;
202 __be16 wBaseAddrLo;
203 } __attribute__((packed));
205 struct ti_read_data_bytes {
206 __u8 bCmdCode;
207 __u8 bModuleId;
208 __u8 bErrorCode;
209 __u8 bData[0];
210 } __attribute__((packed));
212 /* Interrupt struct */
213 struct ti_interrupt {
214 __u8 bICode;
215 __u8 bIInfo;
216 } __attribute__((packed));
218 /* Interrupt codes */
219 #define TI_GET_PORT_FROM_CODE(c) (((c) >> 4) - 3)
220 #define TI_GET_FUNC_FROM_CODE(c) ((c) & 0x0f)
221 #define TI_CODE_HARDWARE_ERROR 0xFF
222 #define TI_CODE_DATA_ERROR 0x03
223 #define TI_CODE_MODEM_STATUS 0x04
225 /* Download firmware max packet size */
226 #define TI_DOWNLOAD_MAX_PACKET_SIZE 64
228 /* Firmware image header */
229 struct ti_firmware_header {
230 __le16 wLength;
231 __u8 bCheckSum;
232 } __attribute__((packed));
234 /* UART addresses */
235 #define TI_UART1_BASE_ADDR 0xFFA0 /* UART 1 base address */
236 #define TI_UART2_BASE_ADDR 0xFFB0 /* UART 2 base address */
237 #define TI_UART_OFFSET_LCR 0x0002 /* UART MCR register offset */
238 #define TI_UART_OFFSET_MCR 0x0004 /* UART MCR register offset */
240 #endif /* _TI_3410_5052_H_ */