Add linux-next specific files for 20110801
[linux-2.6/next.git] / drivers / video / dnfb.c
blobec56d2544c734aea151fd49ad97b88092b7beb5e
1 #include <linux/kernel.h>
2 #include <linux/errno.h>
3 #include <linux/string.h>
4 #include <linux/mm.h>
5 #include <linux/delay.h>
6 #include <linux/interrupt.h>
7 #include <linux/platform_device.h>
9 #include <asm/setup.h>
10 #include <asm/system.h>
11 #include <asm/irq.h>
12 #include <asm/amigahw.h>
13 #include <asm/amigaints.h>
14 #include <asm/apollohw.h>
15 #include <linux/fb.h>
16 #include <linux/module.h>
18 /* apollo video HW definitions */
21 * Control Registers. IOBASE + $x
23 * Note: these are the Memory/IO BASE definitions for a mono card set to the
24 * alternate address
26 * Control 3A and 3B serve identical functions except that 3A
27 * deals with control 1 and 3b deals with Color LUT reg.
30 #define AP_IOBASE 0x3b0 /* Base address of 1 plane board. */
31 #define AP_STATUS isaIO2mem(AP_IOBASE+0) /* Status register. Read */
32 #define AP_WRITE_ENABLE isaIO2mem(AP_IOBASE+0) /* Write Enable Register Write */
33 #define AP_DEVICE_ID isaIO2mem(AP_IOBASE+1) /* Device ID Register. Read */
34 #define AP_ROP_1 isaIO2mem(AP_IOBASE+2) /* Raster Operation reg. Write Word */
35 #define AP_DIAG_MEM_REQ isaIO2mem(AP_IOBASE+4) /* Diagnostic Memory Request. Write Word */
36 #define AP_CONTROL_0 isaIO2mem(AP_IOBASE+8) /* Control Register 0. Read/Write */
37 #define AP_CONTROL_1 isaIO2mem(AP_IOBASE+0xa) /* Control Register 1. Read/Write */
38 #define AP_CONTROL_3A isaIO2mem(AP_IOBASE+0xe) /* Control Register 3a. Read/Write */
39 #define AP_CONTROL_2 isaIO2mem(AP_IOBASE+0xc) /* Control Register 2. Read/Write */
42 #define FRAME_BUFFER_START 0x0FA0000
43 #define FRAME_BUFFER_LEN 0x40000
45 /* CREG 0 */
46 #define VECTOR_MODE 0x40 /* 010x.xxxx */
47 #define DBLT_MODE 0x80 /* 100x.xxxx */
48 #define NORMAL_MODE 0xE0 /* 111x.xxxx */
49 #define SHIFT_BITS 0x1F /* xxx1.1111 */
50 /* other bits are Shift value */
52 /* CREG 1 */
53 #define AD_BLT 0x80 /* 1xxx.xxxx */
54 #define NORMAL 0x80 /* 1xxx.xxxx */ /* What is happening here ?? */
55 #define INVERSE 0x00 /* 0xxx.xxxx */ /* Clearing this reverses the screen */
56 #define PIX_BLT 0x00 /* 0xxx.xxxx */
58 #define AD_HIBIT 0x40 /* xIxx.xxxx */
60 #define ROP_EN 0x10 /* xxx1.xxxx */
61 #define DST_EQ_SRC 0x00 /* xxx0.xxxx */
62 #define nRESET_SYNC 0x08 /* xxxx.1xxx */
63 #define SYNC_ENAB 0x02 /* xxxx.xx1x */
65 #define BLANK_DISP 0x00 /* xxxx.xxx0 */
66 #define ENAB_DISP 0x01 /* xxxx.xxx1 */
68 #define NORM_CREG1 (nRESET_SYNC | SYNC_ENAB | ENAB_DISP) /* no reset sync */
70 /* CREG 2 */
73 * Following 3 defines are common to 1, 4 and 8 plane.
76 #define S_DATA_1s 0x00 /* 00xx.xxxx */ /* set source to all 1's -- vector drawing */
77 #define S_DATA_PIX 0x40 /* 01xx.xxxx */ /* takes source from ls-bits and replicates over 16 bits */
78 #define S_DATA_PLN 0xC0 /* 11xx.xxxx */ /* normal, each data access =16-bits in
79 one plane of image mem */
81 /* CREG 3A/CREG 3B */
82 # define RESET_CREG 0x80 /* 1000.0000 */
84 /* ROP REG - all one nibble */
85 /* ********* NOTE : this is used r0,r1,r2,r3 *********** */
86 #define ROP(r2,r3,r0,r1) ( (U_SHORT)((r0)|((r1)<<4)|((r2)<<8)|((r3)<<12)) )
87 #define DEST_ZERO 0x0
88 #define SRC_AND_DEST 0x1
89 #define SRC_AND_nDEST 0x2
90 #define SRC 0x3
91 #define nSRC_AND_DEST 0x4
92 #define DEST 0x5
93 #define SRC_XOR_DEST 0x6
94 #define SRC_OR_DEST 0x7
95 #define SRC_NOR_DEST 0x8
96 #define SRC_XNOR_DEST 0x9
97 #define nDEST 0xA
98 #define SRC_OR_nDEST 0xB
99 #define nSRC 0xC
100 #define nSRC_OR_DEST 0xD
101 #define SRC_NAND_DEST 0xE
102 #define DEST_ONE 0xF
104 #define SWAP(A) ((A>>8) | ((A&0xff) <<8))
106 /* frame buffer operations */
108 static int dnfb_blank(int blank, struct fb_info *info);
109 static void dnfb_copyarea(struct fb_info *info, const struct fb_copyarea *area);
111 static struct fb_ops dn_fb_ops = {
112 .owner = THIS_MODULE,
113 .fb_blank = dnfb_blank,
114 .fb_fillrect = cfb_fillrect,
115 .fb_copyarea = dnfb_copyarea,
116 .fb_imageblit = cfb_imageblit,
119 struct fb_var_screeninfo dnfb_var __devinitdata = {
120 .xres = 1280,
121 .yres = 1024,
122 .xres_virtual = 2048,
123 .yres_virtual = 1024,
124 .bits_per_pixel = 1,
125 .height = -1,
126 .width = -1,
127 .vmode = FB_VMODE_NONINTERLACED,
130 static struct fb_fix_screeninfo dnfb_fix __devinitdata = {
131 .id = "Apollo Mono",
132 .smem_start = (FRAME_BUFFER_START + IO_BASE),
133 .smem_len = FRAME_BUFFER_LEN,
134 .type = FB_TYPE_PACKED_PIXELS,
135 .visual = FB_VISUAL_MONO10,
136 .line_length = 256,
139 static int dnfb_blank(int blank, struct fb_info *info)
141 if (blank)
142 out_8(AP_CONTROL_3A, 0x0);
143 else
144 out_8(AP_CONTROL_3A, 0x1);
145 return 0;
148 static
149 void dnfb_copyarea(struct fb_info *info, const struct fb_copyarea *area)
152 int incr, y_delta, pre_read = 0, x_end, x_word_count;
153 uint start_mask, end_mask, dest;
154 ushort *src, dummy;
155 short i, j;
157 incr = (area->dy <= area->sy) ? 1 : -1;
159 src = (ushort *)(info->screen_base + area->sy * info->fix.line_length +
160 (area->sx >> 4));
161 dest = area->dy * (info->fix.line_length >> 1) + (area->dx >> 4);
163 if (incr > 0) {
164 y_delta = (info->fix.line_length * 8) - area->sx - area->width;
165 x_end = area->dx + area->width - 1;
166 x_word_count = (x_end >> 4) - (area->dx >> 4) + 1;
167 start_mask = 0xffff0000 >> (area->dx & 0xf);
168 end_mask = 0x7ffff >> (x_end & 0xf);
169 out_8(AP_CONTROL_0,
170 (((area->dx & 0xf) - (area->sx & 0xf)) % 16) | (0x4 << 5));
171 if ((area->dx & 0xf) < (area->sx & 0xf))
172 pre_read = 1;
173 } else {
174 y_delta = -((info->fix.line_length * 8) - area->sx - area->width);
175 x_end = area->dx - area->width + 1;
176 x_word_count = (area->dx >> 4) - (x_end >> 4) + 1;
177 start_mask = 0x7ffff >> (area->dx & 0xf);
178 end_mask = 0xffff0000 >> (x_end & 0xf);
179 out_8(AP_CONTROL_0,
180 ((-((area->sx & 0xf) - (area->dx & 0xf))) % 16) |
181 (0x4 << 5));
182 if ((area->dx & 0xf) > (area->sx & 0xf))
183 pre_read = 1;
186 for (i = 0; i < area->height; i++) {
188 out_8(AP_CONTROL_3A, 0xc | (dest >> 16));
190 if (pre_read) {
191 dummy = *src;
192 src += incr;
195 if (x_word_count) {
196 out_8(AP_WRITE_ENABLE, start_mask);
197 *src = dest;
198 src += incr;
199 dest += incr;
200 out_8(AP_WRITE_ENABLE, 0);
202 for (j = 1; j < (x_word_count - 1); j++) {
203 *src = dest;
204 src += incr;
205 dest += incr;
208 out_8(AP_WRITE_ENABLE, start_mask);
209 *src = dest;
210 dest += incr;
211 src += incr;
212 } else {
213 out_8(AP_WRITE_ENABLE, start_mask | end_mask);
214 *src = dest;
215 dest += incr;
216 src += incr;
218 src += (y_delta / 16);
219 dest += (y_delta / 16);
221 out_8(AP_CONTROL_0, NORMAL_MODE);
225 * Initialization
228 static int __devinit dnfb_probe(struct platform_device *dev)
230 struct fb_info *info;
231 int err = 0;
233 info = framebuffer_alloc(0, &dev->dev);
234 if (!info)
235 return -ENOMEM;
237 info->fbops = &dn_fb_ops;
238 info->fix = dnfb_fix;
239 info->var = dnfb_var;
240 info->var.red.length = 1;
241 info->var.red.offset = 0;
242 info->var.green = info->var.blue = info->var.red;
243 info->screen_base = (u_char *) info->fix.smem_start;
245 err = fb_alloc_cmap(&info->cmap, 2, 0);
246 if (err < 0) {
247 framebuffer_release(info);
248 return err;
251 err = register_framebuffer(info);
252 if (err < 0) {
253 fb_dealloc_cmap(&info->cmap);
254 framebuffer_release(info);
255 return err;
257 platform_set_drvdata(dev, info);
259 /* now we have registered we can safely setup the hardware */
260 out_8(AP_CONTROL_3A, RESET_CREG);
261 out_be16(AP_WRITE_ENABLE, 0x0);
262 out_8(AP_CONTROL_0, NORMAL_MODE);
263 out_8(AP_CONTROL_1, (AD_BLT | DST_EQ_SRC | NORM_CREG1));
264 out_8(AP_CONTROL_2, S_DATA_PLN);
265 out_be16(AP_ROP_1, SWAP(0x3));
267 printk("apollo frame buffer alive and kicking !\n");
268 return err;
271 static struct platform_driver dnfb_driver = {
272 .probe = dnfb_probe,
273 .driver = {
274 .name = "dnfb",
278 static struct platform_device dnfb_device = {
279 .name = "dnfb",
282 int __init dnfb_init(void)
284 int ret;
286 if (!MACH_IS_APOLLO)
287 return -ENODEV;
289 if (fb_get_options("dnfb", NULL))
290 return -ENODEV;
292 ret = platform_driver_register(&dnfb_driver);
294 if (!ret) {
295 ret = platform_device_register(&dnfb_device);
296 if (ret)
297 platform_driver_unregister(&dnfb_driver);
299 return ret;
302 module_init(dnfb_init);
304 MODULE_LICENSE("GPL");