Add linux-next specific files for 20110831
[linux-2.6/next.git] / arch / mips / mti-malta / malta-smtc.c
blob1efc8c3944860d29a6861231ad5bcacd5e917a99
1 /*
2 * Malta Platform-specific hooks for SMP operation
3 */
4 #include <linux/irq.h>
5 #include <linux/init.h>
7 #include <asm/mipsregs.h>
8 #include <asm/mipsmtregs.h>
9 #include <asm/smtc.h>
10 #include <asm/smtc_ipi.h>
12 /* VPE/SMP Prototype implements platform interfaces directly */
15 * Cause the specified action to be performed on a targeted "CPU"
18 static void msmtc_send_ipi_single(int cpu, unsigned int action)
20 /* "CPU" may be TC of same VPE, VPE of same CPU, or different CPU */
21 smtc_send_ipi(cpu, LINUX_SMP_IPI, action);
24 static void msmtc_send_ipi_mask(const struct cpumask *mask, unsigned int action)
26 unsigned int i;
28 for_each_cpu(i, mask)
29 msmtc_send_ipi_single(i, action);
33 * Post-config but pre-boot cleanup entry point
35 static void __cpuinit msmtc_init_secondary(void)
37 int myvpe;
39 /* Don't enable Malta I/O interrupts (IP2) for secondary VPEs */
40 myvpe = read_c0_tcbind() & TCBIND_CURVPE;
41 if (myvpe != 0) {
42 /* Ideally, this should be done only once per VPE, but... */
43 clear_c0_status(ST0_IM);
44 set_c0_status((0x100 << cp0_compare_irq)
45 | (0x100 << MIPS_CPU_IPI_IRQ));
46 if (cp0_perfcount_irq >= 0)
47 set_c0_status(0x100 << cp0_perfcount_irq);
50 smtc_init_secondary();
54 * Platform "CPU" startup hook
56 static void __cpuinit msmtc_boot_secondary(int cpu, struct task_struct *idle)
58 smtc_boot_secondary(cpu, idle);
62 * SMP initialization finalization entry point
64 static void __cpuinit msmtc_smp_finish(void)
66 smtc_smp_finish();
70 * Hook for after all CPUs are online
73 static void msmtc_cpus_done(void)
78 * Platform SMP pre-initialization
80 * As noted above, we can assume a single CPU for now
81 * but it may be multithreaded.
84 static void __init msmtc_smp_setup(void)
87 * we won't get the definitive value until
88 * we've run smtc_prepare_cpus later, but
89 * we would appear to need an upper bound now.
91 smp_num_siblings = smtc_build_cpu_map(0);
94 static void __init msmtc_prepare_cpus(unsigned int max_cpus)
96 smtc_prepare_cpus(max_cpus);
99 struct plat_smp_ops msmtc_smp_ops = {
100 .send_ipi_single = msmtc_send_ipi_single,
101 .send_ipi_mask = msmtc_send_ipi_mask,
102 .init_secondary = msmtc_init_secondary,
103 .smp_finish = msmtc_smp_finish,
104 .cpus_done = msmtc_cpus_done,
105 .boot_secondary = msmtc_boot_secondary,
106 .smp_setup = msmtc_smp_setup,
107 .prepare_cpus = msmtc_prepare_cpus,
110 #ifdef CONFIG_MIPS_MT_SMTC_IRQAFF
112 * IRQ affinity hook
116 int plat_set_irq_affinity(struct irq_data *d, const struct cpumask *affinity,
117 bool force)
119 cpumask_t tmask;
120 int cpu = 0;
121 void smtc_set_irq_affinity(unsigned int irq, cpumask_t aff);
124 * On the legacy Malta development board, all I/O interrupts
125 * are routed through the 8259 and combined in a single signal
126 * to the CPU daughterboard, and on the CoreFPGA2/3 34K models,
127 * that signal is brought to IP2 of both VPEs. To avoid racing
128 * concurrent interrupt service events, IP2 is enabled only on
129 * one VPE, by convention VPE0. So long as no bits are ever
130 * cleared in the affinity mask, there will never be any
131 * interrupt forwarding. But as soon as a program or operator
132 * sets affinity for one of the related IRQs, we need to make
133 * sure that we don't ever try to forward across the VPE boundary,
134 * at least not until we engineer a system where the interrupt
135 * _ack() or _end() function can somehow know that it corresponds
136 * to an interrupt taken on another VPE, and perform the appropriate
137 * restoration of Status.IM state using MFTR/MTTR instead of the
138 * normal local behavior. We also ensure that no attempt will
139 * be made to forward to an offline "CPU".
142 cpumask_copy(&tmask, affinity);
143 for_each_cpu(cpu, affinity) {
144 if ((cpu_data[cpu].vpe_id != 0) || !cpu_online(cpu))
145 cpu_clear(cpu, tmask);
147 cpumask_copy(d->affinity, &tmask);
149 if (cpus_empty(tmask))
151 * We could restore a default mask here, but the
152 * runtime code can anyway deal with the null set
154 printk(KERN_WARNING
155 "IRQ affinity leaves no legal CPU for IRQ %d\n", d->irq);
157 /* Do any generic SMTC IRQ affinity setup */
158 smtc_set_irq_affinity(d->irq, tmask);
160 return IRQ_SET_MASK_OK_NOCOPY;
162 #endif /* CONFIG_MIPS_MT_SMTC_IRQAFF */