Add linux-next specific files for 20110831
[linux-2.6/next.git] / drivers / usb / host / isp1760-hcd.h
blobfda0f2d54e3dd4629cd3c647ea4b073e70d82f2a
1 #ifndef _ISP1760_HCD_H_
2 #define _ISP1760_HCD_H_
4 /* exports for if */
5 struct usb_hcd *isp1760_register(phys_addr_t res_start, resource_size_t res_len,
6 int irq, unsigned long irqflags,
7 struct device *dev, const char *busname,
8 unsigned int devflags);
9 int init_kmem_once(void);
10 void deinit_kmem_cache(void);
12 /* EHCI capability registers */
13 #define HC_CAPLENGTH 0x00
14 #define HC_HCSPARAMS 0x04
15 #define HC_HCCPARAMS 0x08
17 /* EHCI operational registers */
18 #define HC_USBCMD 0x20
19 #define HC_USBSTS 0x24
20 #define HC_FRINDEX 0x2c
21 #define HC_CONFIGFLAG 0x60
22 #define HC_PORTSC1 0x64
23 #define HC_ISO_PTD_DONEMAP_REG 0x130
24 #define HC_ISO_PTD_SKIPMAP_REG 0x134
25 #define HC_ISO_PTD_LASTPTD_REG 0x138
26 #define HC_INT_PTD_DONEMAP_REG 0x140
27 #define HC_INT_PTD_SKIPMAP_REG 0x144
28 #define HC_INT_PTD_LASTPTD_REG 0x148
29 #define HC_ATL_PTD_DONEMAP_REG 0x150
30 #define HC_ATL_PTD_SKIPMAP_REG 0x154
31 #define HC_ATL_PTD_LASTPTD_REG 0x158
33 /* Configuration Register */
34 #define HC_HW_MODE_CTRL 0x300
35 #define ALL_ATX_RESET (1 << 31)
36 #define HW_ANA_DIGI_OC (1 << 15)
37 #define HW_DATA_BUS_32BIT (1 << 8)
38 #define HW_DACK_POL_HIGH (1 << 6)
39 #define HW_DREQ_POL_HIGH (1 << 5)
40 #define HW_INTR_HIGH_ACT (1 << 2)
41 #define HW_INTR_EDGE_TRIG (1 << 1)
42 #define HW_GLOBAL_INTR_EN (1 << 0)
44 #define HC_CHIP_ID_REG 0x304
45 #define HC_SCRATCH_REG 0x308
47 #define HC_RESET_REG 0x30c
48 #define SW_RESET_RESET_HC (1 << 1)
49 #define SW_RESET_RESET_ALL (1 << 0)
51 #define HC_BUFFER_STATUS_REG 0x334
52 #define ISO_BUF_FILL (1 << 2)
53 #define INT_BUF_FILL (1 << 1)
54 #define ATL_BUF_FILL (1 << 0)
56 #define HC_MEMORY_REG 0x33c
57 #define ISP_BANK(x) ((x) << 16)
59 #define HC_PORT1_CTRL 0x374
60 #define PORT1_POWER (3 << 3)
61 #define PORT1_INIT1 (1 << 7)
62 #define PORT1_INIT2 (1 << 23)
63 #define HW_OTG_CTRL_SET 0x374
64 #define HW_OTG_CTRL_CLR 0x376
66 /* Interrupt Register */
67 #define HC_INTERRUPT_REG 0x310
69 #define HC_INTERRUPT_ENABLE 0x314
70 #define HC_ISO_INT (1 << 9)
71 #define HC_ATL_INT (1 << 8)
72 #define HC_INTL_INT (1 << 7)
73 #define HC_EOT_INT (1 << 3)
74 #define HC_SOT_INT (1 << 1)
75 #define INTERRUPT_ENABLE_MASK (HC_INTL_INT | HC_ATL_INT)
77 #define HC_ISO_IRQ_MASK_OR_REG 0x318
78 #define HC_INT_IRQ_MASK_OR_REG 0x31C
79 #define HC_ATL_IRQ_MASK_OR_REG 0x320
80 #define HC_ISO_IRQ_MASK_AND_REG 0x324
81 #define HC_INT_IRQ_MASK_AND_REG 0x328
82 #define HC_ATL_IRQ_MASK_AND_REG 0x32C
84 /* urb state*/
85 #define DELETE_URB (0x0008)
86 #define NO_TRANSFER_ACTIVE (0xffffffff)
88 /* Philips Proprietary Transfer Descriptor (PTD) */
89 typedef __u32 __bitwise __dw;
90 struct ptd {
91 __dw dw0;
92 __dw dw1;
93 __dw dw2;
94 __dw dw3;
95 __dw dw4;
96 __dw dw5;
97 __dw dw6;
98 __dw dw7;
100 #define PTD_OFFSET 0x0400
101 #define ISO_PTD_OFFSET 0x0400
102 #define INT_PTD_OFFSET 0x0800
103 #define ATL_PTD_OFFSET 0x0c00
104 #define PAYLOAD_OFFSET 0x1000
106 struct slotinfo {
107 struct isp1760_qh *qh;
108 struct isp1760_qtd *qtd;
109 unsigned long timestamp;
113 typedef void (packet_enqueue)(struct usb_hcd *hcd, struct isp1760_qh *qh,
114 struct isp1760_qtd *qtd);
117 * Device flags that can vary from board to board. All of these
118 * indicate the most "atypical" case, so that a devflags of 0 is
119 * a sane default configuration.
121 #define ISP1760_FLAG_BUS_WIDTH_16 0x00000002 /* 16-bit data bus width */
122 #define ISP1760_FLAG_OTG_EN 0x00000004 /* Port 1 supports OTG */
123 #define ISP1760_FLAG_ANALOG_OC 0x00000008 /* Analog overcurrent */
124 #define ISP1760_FLAG_DACK_POL_HIGH 0x00000010 /* DACK active high */
125 #define ISP1760_FLAG_DREQ_POL_HIGH 0x00000020 /* DREQ active high */
126 #define ISP1760_FLAG_ISP1761 0x00000040 /* Chip is ISP1761 */
127 #define ISP1760_FLAG_INTR_POL_HIGH 0x00000080 /* Interrupt polarity active high */
128 #define ISP1760_FLAG_INTR_EDGE_TRIG 0x00000100 /* Interrupt edge triggered */
130 /* chip memory management */
131 struct memory_chunk {
132 unsigned int start;
133 unsigned int size;
134 unsigned int free;
138 * 60kb divided in:
139 * - 32 blocks @ 256 bytes
140 * - 20 blocks @ 1024 bytes
141 * - 4 blocks @ 8192 bytes
144 #define BLOCK_1_NUM 32
145 #define BLOCK_2_NUM 20
146 #define BLOCK_3_NUM 4
148 #define BLOCK_1_SIZE 256
149 #define BLOCK_2_SIZE 1024
150 #define BLOCK_3_SIZE 8192
151 #define BLOCKS (BLOCK_1_NUM + BLOCK_2_NUM + BLOCK_3_NUM)
152 #define MAX_PAYLOAD_SIZE BLOCK_3_SIZE
153 #define PAYLOAD_AREA_SIZE 0xf000
155 /* ATL */
156 /* DW0 */
157 #define DW0_VALID_BIT 1
158 #define FROM_DW0_VALID(x) ((x) & 0x01)
159 #define TO_DW0_LENGTH(x) (((u32) x) << 3)
160 #define TO_DW0_MAXPACKET(x) (((u32) x) << 18)
161 #define TO_DW0_MULTI(x) (((u32) x) << 29)
162 #define TO_DW0_ENDPOINT(x) (((u32) x) << 31)
163 /* DW1 */
164 #define TO_DW1_DEVICE_ADDR(x) (((u32) x) << 3)
165 #define TO_DW1_PID_TOKEN(x) (((u32) x) << 10)
166 #define DW1_TRANS_BULK ((u32) 2 << 12)
167 #define DW1_TRANS_INT ((u32) 3 << 12)
168 #define DW1_TRANS_SPLIT ((u32) 1 << 14)
169 #define DW1_SE_USB_LOSPEED ((u32) 2 << 16)
170 #define TO_DW1_PORT_NUM(x) (((u32) x) << 18)
171 #define TO_DW1_HUB_NUM(x) (((u32) x) << 25)
172 /* DW2 */
173 #define TO_DW2_DATA_START_ADDR(x) (((u32) x) << 8)
174 #define TO_DW2_RL(x) ((x) << 25)
175 #define FROM_DW2_RL(x) (((x) >> 25) & 0xf)
176 /* DW3 */
177 #define FROM_DW3_NRBYTESTRANSFERRED(x) ((x) & 0x7fff)
178 #define FROM_DW3_SCS_NRBYTESTRANSFERRED(x) ((x) & 0x07ff)
179 #define TO_DW3_NAKCOUNT(x) ((x) << 19)
180 #define FROM_DW3_NAKCOUNT(x) (((x) >> 19) & 0xf)
181 #define TO_DW3_CERR(x) ((x) << 23)
182 #define FROM_DW3_CERR(x) (((x) >> 23) & 0x3)
183 #define TO_DW3_DATA_TOGGLE(x) ((x) << 25)
184 #define FROM_DW3_DATA_TOGGLE(x) (((x) >> 25) & 0x1)
185 #define TO_DW3_PING(x) ((x) << 26)
186 #define FROM_DW3_PING(x) (((x) >> 26) & 0x1)
187 #define DW3_ERROR_BIT (1 << 28)
188 #define DW3_BABBLE_BIT (1 << 29)
189 #define DW3_HALT_BIT (1 << 30)
190 #define DW3_ACTIVE_BIT (1 << 31)
191 #define FROM_DW3_ACTIVE(x) (((x) >> 31) & 0x01)
193 #define INT_UNDERRUN (1 << 2)
194 #define INT_BABBLE (1 << 1)
195 #define INT_EXACT (1 << 0)
197 #define SETUP_PID (2)
198 #define IN_PID (1)
199 #define OUT_PID (0)
201 /* Errata 1 */
202 #define RL_COUNTER (0)
203 #define NAK_COUNTER (0)
204 #define ERR_COUNTER (2)
206 #endif /* _ISP1760_HCD_H_ */