Merge remote-tracking branch 's5p/for-next'
[linux-2.6/next.git] / arch / arm / mach-pxa / cm-x255.c
blob93f59f877fc602887435fca577780a8420bedba8
1 /*
2 * linux/arch/arm/mach-pxa/cm-x255.c
4 * Copyright (C) 2007, 2008 CompuLab, Ltd.
5 * Mike Rapoport <mike@compulab.co.il>
7 * This program is free software; you can redistribute it and/or modify
8 * it under the terms of the GNU General Public License version 2 as
9 * published by the Free Software Foundation.
12 #include <linux/platform_device.h>
13 #include <linux/irq.h>
14 #include <linux/gpio.h>
15 #include <linux/mtd/partitions.h>
16 #include <linux/mtd/physmap.h>
17 #include <linux/mtd/nand-gpio.h>
19 #include <linux/spi/spi.h>
20 #include <linux/spi/pxa2xx_spi.h>
22 #include <asm/mach/arch.h>
23 #include <asm/mach-types.h>
24 #include <asm/mach/map.h>
26 #include <mach/pxa25x.h>
28 #include "generic.h"
30 #define GPIO_NAND_CS (5)
31 #define GPIO_NAND_ALE (4)
32 #define GPIO_NAND_CLE (3)
33 #define GPIO_NAND_RB (10)
35 static unsigned long cmx255_pin_config[] = {
36 /* AC'97 */
37 GPIO28_AC97_BITCLK,
38 GPIO29_AC97_SDATA_IN_0,
39 GPIO30_AC97_SDATA_OUT,
40 GPIO31_AC97_SYNC,
42 /* BTUART */
43 GPIO42_BTUART_RXD,
44 GPIO43_BTUART_TXD,
45 GPIO44_BTUART_CTS,
46 GPIO45_BTUART_RTS,
48 /* STUART */
49 GPIO46_STUART_RXD,
50 GPIO47_STUART_TXD,
52 /* LCD */
53 GPIOxx_LCD_TFT_16BPP,
55 /* SSP1 */
56 GPIO23_SSP1_SCLK,
57 GPIO24_SSP1_SFRM,
58 GPIO25_SSP1_TXD,
59 GPIO26_SSP1_RXD,
61 /* SSP2 */
62 GPIO81_SSP2_CLK_OUT,
63 GPIO82_SSP2_FRM_OUT,
64 GPIO83_SSP2_TXD,
65 GPIO84_SSP2_RXD,
67 /* PC Card */
68 GPIO48_nPOE,
69 GPIO49_nPWE,
70 GPIO50_nPIOR,
71 GPIO51_nPIOW,
72 GPIO52_nPCE_1,
73 GPIO53_nPCE_2,
74 GPIO54_nPSKTSEL,
75 GPIO55_nPREG,
76 GPIO56_nPWAIT,
77 GPIO57_nIOIS16,
79 /* SDRAM and local bus */
80 GPIO15_nCS_1,
81 GPIO78_nCS_2,
82 GPIO79_nCS_3,
83 GPIO80_nCS_4,
84 GPIO33_nCS_5,
85 GPIO18_RDY,
87 /* GPIO */
88 GPIO0_GPIO | WAKEUP_ON_EDGE_BOTH,
89 GPIO9_GPIO, /* PC card reset */
91 /* NAND controls */
92 GPIO5_GPIO | MFP_LPM_DRIVE_HIGH, /* NAND CE# */
93 GPIO4_GPIO | MFP_LPM_DRIVE_LOW, /* NAND ALE */
94 GPIO3_GPIO | MFP_LPM_DRIVE_LOW, /* NAND CLE */
95 GPIO10_GPIO, /* NAND Ready/Busy */
97 /* interrupts */
98 GPIO22_GPIO, /* DM9000 interrupt */
101 #if defined(CONFIG_SPI_PXA2XX)
102 static struct pxa2xx_spi_master pxa_ssp_master_info = {
103 .num_chipselect = 1,
106 static struct spi_board_info spi_board_info[] __initdata = {
107 [0] = {
108 .modalias = "rtc-max6902",
109 .max_speed_hz = 1000000,
110 .bus_num = 1,
111 .chip_select = 0,
115 static void __init cmx255_init_rtc(void)
117 pxa2xx_set_spi_info(1, &pxa_ssp_master_info);
118 spi_register_board_info(ARRAY_AND_SIZE(spi_board_info));
120 #else
121 static inline void cmx255_init_rtc(void) {}
122 #endif
124 #if defined(CONFIG_MTD_PHYSMAP) || defined(CONFIG_MTD_PHYSMAP_MODULE)
125 static struct mtd_partition cmx255_nor_partitions[] = {
127 .name = "ARMmon",
128 .size = 0x00030000,
129 .offset = 0,
130 .mask_flags = MTD_WRITEABLE /* force read-only */
131 } , {
132 .name = "ARMmon setup block",
133 .size = 0x00010000,
134 .offset = MTDPART_OFS_APPEND,
135 .mask_flags = MTD_WRITEABLE /* force read-only */
136 } , {
137 .name = "kernel",
138 .size = 0x00160000,
139 .offset = MTDPART_OFS_APPEND,
140 } , {
141 .name = "ramdisk",
142 .size = MTDPART_SIZ_FULL,
143 .offset = MTDPART_OFS_APPEND
147 static struct physmap_flash_data cmx255_nor_flash_data[] = {
149 .width = 2, /* bankwidth in bytes */
150 .parts = cmx255_nor_partitions,
151 .nr_parts = ARRAY_SIZE(cmx255_nor_partitions)
155 static struct resource cmx255_nor_resource = {
156 .start = PXA_CS0_PHYS,
157 .end = PXA_CS0_PHYS + SZ_8M - 1,
158 .flags = IORESOURCE_MEM,
161 static struct platform_device cmx255_nor = {
162 .name = "physmap-flash",
163 .id = -1,
164 .dev = {
165 .platform_data = cmx255_nor_flash_data,
167 .resource = &cmx255_nor_resource,
168 .num_resources = 1,
171 static void __init cmx255_init_nor(void)
173 platform_device_register(&cmx255_nor);
175 #else
176 static inline void cmx255_init_nor(void) {}
177 #endif
179 #if defined(CONFIG_MTD_NAND_GPIO) || defined(CONFIG_MTD_NAND_GPIO_MODULE)
180 static struct resource cmx255_nand_resource[] = {
181 [0] = {
182 .start = PXA_CS1_PHYS,
183 .end = PXA_CS1_PHYS + 11,
184 .flags = IORESOURCE_MEM,
186 [1] = {
187 .start = PXA_CS5_PHYS,
188 .end = PXA_CS5_PHYS + 3,
189 .flags = IORESOURCE_MEM,
193 static struct mtd_partition cmx255_nand_parts[] = {
194 [0] = {
195 .name = "cmx255-nand",
196 .size = MTDPART_SIZ_FULL,
197 .offset = 0,
201 static struct gpio_nand_platdata cmx255_nand_platdata = {
202 .gpio_nce = GPIO_NAND_CS,
203 .gpio_cle = GPIO_NAND_CLE,
204 .gpio_ale = GPIO_NAND_ALE,
205 .gpio_rdy = GPIO_NAND_RB,
206 .gpio_nwp = -1,
207 .parts = cmx255_nand_parts,
208 .num_parts = ARRAY_SIZE(cmx255_nand_parts),
209 .chip_delay = 25,
212 static struct platform_device cmx255_nand = {
213 .name = "gpio-nand",
214 .num_resources = ARRAY_SIZE(cmx255_nand_resource),
215 .resource = cmx255_nand_resource,
216 .id = -1,
217 .dev = {
218 .platform_data = &cmx255_nand_platdata,
222 static void __init cmx255_init_nand(void)
224 platform_device_register(&cmx255_nand);
226 #else
227 static inline void cmx255_init_nand(void) {}
228 #endif
230 void __init cmx255_init(void)
232 pxa2xx_mfp_config(ARRAY_AND_SIZE(cmx255_pin_config));
234 cmx255_init_rtc();
235 cmx255_init_nor();
236 cmx255_init_nand();