[SPARC64]: Fix cpu trampoline et al. mismatch warnings.
[linux-2.6/openmoko-kernel/knife-kernel.git] / include / asm-x86 / kvm_x86_emulate.h
blob7db91b9bdcd4c59d950485497fef97b4dc53c43b
1 /******************************************************************************
2 * x86_emulate.h
4 * Generic x86 (32-bit and 64-bit) instruction decoder and emulator.
6 * Copyright (c) 2005 Keir Fraser
8 * From: xen-unstable 10676:af9809f51f81a3c43f276f00c81a52ef558afda4
9 */
11 #ifndef __X86_EMULATE_H__
12 #define __X86_EMULATE_H__
14 struct x86_emulate_ctxt;
17 * x86_emulate_ops:
19 * These operations represent the instruction emulator's interface to memory.
20 * There are two categories of operation: those that act on ordinary memory
21 * regions (*_std), and those that act on memory regions known to require
22 * special treatment or emulation (*_emulated).
24 * The emulator assumes that an instruction accesses only one 'emulated memory'
25 * location, that this location is the given linear faulting address (cr2), and
26 * that this is one of the instruction's data operands. Instruction fetches and
27 * stack operations are assumed never to access emulated memory. The emulator
28 * automatically deduces which operand of a string-move operation is accessing
29 * emulated memory, and assumes that the other operand accesses normal memory.
31 * NOTES:
32 * 1. The emulator isn't very smart about emulated vs. standard memory.
33 * 'Emulated memory' access addresses should be checked for sanity.
34 * 'Normal memory' accesses may fault, and the caller must arrange to
35 * detect and handle reentrancy into the emulator via recursive faults.
36 * Accesses may be unaligned and may cross page boundaries.
37 * 2. If the access fails (cannot emulate, or a standard access faults) then
38 * it is up to the memop to propagate the fault to the guest VM via
39 * some out-of-band mechanism, unknown to the emulator. The memop signals
40 * failure by returning X86EMUL_PROPAGATE_FAULT to the emulator, which will
41 * then immediately bail.
42 * 3. Valid access sizes are 1, 2, 4 and 8 bytes. On x86/32 systems only
43 * cmpxchg8b_emulated need support 8-byte accesses.
44 * 4. The emulator cannot handle 64-bit mode emulation on an x86/32 system.
46 /* Access completed successfully: continue emulation as normal. */
47 #define X86EMUL_CONTINUE 0
48 /* Access is unhandleable: bail from emulation and return error to caller. */
49 #define X86EMUL_UNHANDLEABLE 1
50 /* Terminate emulation but return success to the caller. */
51 #define X86EMUL_PROPAGATE_FAULT 2 /* propagate a generated fault to guest */
52 #define X86EMUL_RETRY_INSTR 2 /* retry the instruction for some reason */
53 #define X86EMUL_CMPXCHG_FAILED 2 /* cmpxchg did not see expected value */
54 struct x86_emulate_ops {
56 * read_std: Read bytes of standard (non-emulated/special) memory.
57 * Used for instruction fetch, stack operations, and others.
58 * @addr: [IN ] Linear address from which to read.
59 * @val: [OUT] Value read from memory, zero-extended to 'u_long'.
60 * @bytes: [IN ] Number of bytes to read from memory.
62 int (*read_std)(unsigned long addr, void *val,
63 unsigned int bytes, struct kvm_vcpu *vcpu);
66 * read_emulated: Read bytes from emulated/special memory area.
67 * @addr: [IN ] Linear address from which to read.
68 * @val: [OUT] Value read from memory, zero-extended to 'u_long'.
69 * @bytes: [IN ] Number of bytes to read from memory.
71 int (*read_emulated) (unsigned long addr,
72 void *val,
73 unsigned int bytes,
74 struct kvm_vcpu *vcpu);
77 * write_emulated: Read bytes from emulated/special memory area.
78 * @addr: [IN ] Linear address to which to write.
79 * @val: [IN ] Value to write to memory (low-order bytes used as
80 * required).
81 * @bytes: [IN ] Number of bytes to write to memory.
83 int (*write_emulated) (unsigned long addr,
84 const void *val,
85 unsigned int bytes,
86 struct kvm_vcpu *vcpu);
89 * cmpxchg_emulated: Emulate an atomic (LOCKed) CMPXCHG operation on an
90 * emulated/special memory area.
91 * @addr: [IN ] Linear address to access.
92 * @old: [IN ] Value expected to be current at @addr.
93 * @new: [IN ] Value to write to @addr.
94 * @bytes: [IN ] Number of bytes to access using CMPXCHG.
96 int (*cmpxchg_emulated) (unsigned long addr,
97 const void *old,
98 const void *new,
99 unsigned int bytes,
100 struct kvm_vcpu *vcpu);
104 /* Type, address-of, and value of an instruction's operand. */
105 struct operand {
106 enum { OP_REG, OP_MEM, OP_IMM, OP_NONE } type;
107 unsigned int bytes;
108 unsigned long val, orig_val, *ptr;
111 struct fetch_cache {
112 u8 data[15];
113 unsigned long start;
114 unsigned long end;
117 struct decode_cache {
118 u8 twobyte;
119 u8 b;
120 u8 lock_prefix;
121 u8 rep_prefix;
122 u8 op_bytes;
123 u8 ad_bytes;
124 u8 rex_prefix;
125 struct operand src;
126 struct operand dst;
127 unsigned long *override_base;
128 unsigned int d;
129 unsigned long regs[NR_VCPU_REGS];
130 unsigned long eip;
131 /* modrm */
132 u8 modrm;
133 u8 modrm_mod;
134 u8 modrm_reg;
135 u8 modrm_rm;
136 u8 use_modrm_ea;
137 unsigned long modrm_ea;
138 unsigned long modrm_val;
139 struct fetch_cache fetch;
142 struct x86_emulate_ctxt {
143 /* Register state before/after emulation. */
144 struct kvm_vcpu *vcpu;
146 /* Linear faulting address (if emulating a page-faulting instruction). */
147 unsigned long eflags;
149 /* Emulated execution mode, represented by an X86EMUL_MODE value. */
150 int mode;
152 unsigned long cs_base;
153 unsigned long ds_base;
154 unsigned long es_base;
155 unsigned long ss_base;
156 unsigned long gs_base;
157 unsigned long fs_base;
159 /* decode cache */
161 struct decode_cache decode;
164 /* Repeat String Operation Prefix */
165 #define REPE_PREFIX 1
166 #define REPNE_PREFIX 2
168 /* Execution mode, passed to the emulator. */
169 #define X86EMUL_MODE_REAL 0 /* Real mode. */
170 #define X86EMUL_MODE_PROT16 2 /* 16-bit protected mode. */
171 #define X86EMUL_MODE_PROT32 4 /* 32-bit protected mode. */
172 #define X86EMUL_MODE_PROT64 8 /* 64-bit (long) mode. */
174 /* Host execution mode. */
175 #if defined(__i386__)
176 #define X86EMUL_MODE_HOST X86EMUL_MODE_PROT32
177 #elif defined(CONFIG_X86_64)
178 #define X86EMUL_MODE_HOST X86EMUL_MODE_PROT64
179 #endif
181 int x86_decode_insn(struct x86_emulate_ctxt *ctxt,
182 struct x86_emulate_ops *ops);
183 int x86_emulate_insn(struct x86_emulate_ctxt *ctxt,
184 struct x86_emulate_ops *ops);
186 #endif /* __X86_EMULATE_H__ */