include/asm-blackfin/mach-bf548/anomaly.h

   1 /*
   2  * File: include/asm-blackfin/mach-bf548/anomaly.h
   3  * Bugs: Enter bugs at http://blackfin.uclinux.org/
   4  *
   5  * Copyright (C) 2004-2007 Analog Devices Inc.
   6  * Licensed under the GPL-2 or later.
   7  */
   8
   9 /* This file shoule be up to date with:
  10  *  - Revision C, July 16, 2007; ADSP-BF549 Silicon Anomaly List
  11  */
  12
  13 #ifndef _MACH_ANOMALY_H_
  14 #define _MACH_ANOMALY_H_
  15
  16 /* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot 2 Not Supported */
  17 #define ANOMALY_05000074 (1)
  18 /* DMA_RUN Bit Is Not Valid after a Peripheral Receive Channel DMA Stops */
  19 #define ANOMALY_05000119 (1)
  20 /* Rx.H Cannot Be Used to Access 16-bit System MMR Registers */
  21 #define ANOMALY_05000122 (1)
  22 /* Spurious Hardware Error from an Access in the Shadow of a Conditional Branch */
  23 #define ANOMALY_05000245 (1)
  24 /* Sensitivity To Noise with Slow Input Edge Rates on External SPORT TX and RX Clocks */
  25 #define ANOMALY_05000265 (1)
  26 /* Certain Data Cache Writethrough Modes Fail for Vddint <= 0.9V */
  27 #define ANOMALY_05000272 (1)
  28 /* False Hardware Error Exception when ISR context is not restored */
  29 #define ANOMALY_05000281 (1)
  30 /* SSYNCs After Writes To CAN/DMA MMR Registers Are Not Always Handled Correctly */
  31 #define ANOMALY_05000304 (1)
  32 /* False Hardware Errors Caused by Fetches at the Boundary of Reserved Memory */
  33 #define ANOMALY_05000310 (1)
  34 /* Errors When SSYNC, CSYNC, or Loads to LT, LB and LC Registers Are Interrupted */
  35 #define ANOMALY_05000312 (1)
  36 /* TWI Slave Boot Mode Is Not Functional */
  37 #define ANOMALY_05000324 (1)
  38 /* External FIFO Boot Mode Is Not Functional */
  39 #define ANOMALY_05000325 (1)
  40 /* Data Lost When Core and DMA Accesses Are Made to the USB FIFO Simultaneously */
  41 #define ANOMALY_05000327 (1)
  42 /* Incorrect Access of OTP_STATUS During otp_write() Function */
  43 #define ANOMALY_05000328 (1)
  44 /* Synchronous Burst Flash Boot Mode Is Not Functional */
  45 #define ANOMALY_05000329 (1)
  46 /* Host DMA Boot Mode Is Not Functional */
  47 #define ANOMALY_05000330 (1)
  48 /* Inadequate Timing Margins on DDR DQS to DQ and DQM Skew */
  49 #define ANOMALY_05000334 (1)
  50 /* Inadequate Rotary Debounce Logic Duration */
  51 #define ANOMALY_05000335 (1)
  52 /* Phantom Interrupt Occurs After First Configuration of Host DMA Port */
  53 #define ANOMALY_05000336 (1)
  54 /* Disallowed Configuration Prevents Subsequent Allowed Configuration on Host DMA Port */
  55 #define ANOMALY_05000337 (1)
  56 /* Slave-Mode SPI0 MISO Failure With CPHA = 0 */
  57 #define ANOMALY_05000338 (1)
  58 /* If Memory Reads Are Enabled on SDH or HOSTDP, Other DMAC1 Peripherals Cannot Read */
  59 #define ANOMALY_05000340 (1)
  60 /* Boot Host Wait (HWAIT) and Boot Host Wait Alternate (HWAITA) Signals Are Swapped */
  61 #define ANOMALY_05000344 (1)
  62 /* USB Calibration Value Is Not Intialized */
  63 #define ANOMALY_05000346 (1)
  64 /* Boot ROM Kernel Incorrectly Alters Reset Value of USB Register */
  65 #define ANOMALY_05000347 (1)
  66 /* Data Lost when Core Reads SDH Data FIFO */
  67 #define ANOMALY_05000349 (1)
  68 /* PLL Status Register Is Inaccurate */
  69 #define ANOMALY_05000351 (1)
  70
  71 /* Anomalies that don't exist on this proc */
  72 #define ANOMALY_05000125 (0)
  73 #define ANOMALY_05000158 (0)
  74 #define ANOMALY_05000183 (0)
  75 #define ANOMALY_05000198 (0)
  76 #define ANOMALY_05000230 (0)
  77 #define ANOMALY_05000244 (0)
  78 #define ANOMALY_05000261 (0)
  79 #define ANOMALY_05000263 (0)
  80 #define ANOMALY_05000266 (0)
  81 #define ANOMALY_05000273 (0)
  82 #define ANOMALY_05000311 (0)
  83 #define ANOMALY_05000323 (0)
  84
  85 #endif