drivers/mtd/maps/scb2_flash.c

   1 /*
   2  * MTD map driver for BIOS Flash on Intel SCB2 boards
   3  * $Id: scb2_flash.c,v 1.11 2004/11/28 09:40:40 dwmw2 Exp $
   4  * Copyright (C) 2002 Sun Microsystems, Inc.
   5  * Tim Hockin <thockin@sun.com>
   6  *
   7  * A few notes on this MTD map:
   8  *
   9  * This was developed with a small number of SCB2 boards to test on.
  10  * Hopefully, Intel has not introducted too many unaccounted variables in the
  11  * making of this board.
  12  *
  13  * The BIOS marks its own memory region as 'reserved' in the e820 map.  We
  14  * try to request it here, but if it fails, we carry on anyway.
  15  *
  16  * This is how the chip is attached, so said the schematic:
  17  * * a 4 MiB (32 Mib) 16 bit chip
  18  * * a 1 MiB memory region
  19  * * A20 and A21 pulled up
  20  * * D8-D15 ignored
  21  * What this means is that, while we are addressing bytes linearly, we are
  22  * really addressing words, and discarding the other byte.  This means that
  23  * the chip MUST BE at least 2 MiB.  This also means that every block is
  24  * actually half as big as the chip reports.  It also means that accesses of
  25  * logical address 0 hit higher-address sections of the chip, not physical 0.
  26  * One can only hope that these 4MiB x16 chips were a lot cheaper than 1MiB x8
  27  * chips.
  28  *
  29  * This driver assumes the chip is not write-protected by an external signal.
  30  * As of the this writing, that is true, but may change, just to spite me.
  31  *
  32  * The actual BIOS layout has been mostly reverse engineered.  Intel BIOS
  33  * updates for this board include 10 related (*.bio - &.bi9) binary files and
  34  * another separate (*.bbo) binary file.  The 10 files are 64k of data + a
  35  * small header.  If the headers are stripped off, the 10 64k files can be
  36  * concatenated into a 640k image.  This is your BIOS image, proper.  The
  37  * separate .bbo file also has a small header.  It is the 'Boot Block'
  38  * recovery BIOS.  Once the header is stripped, no further prep is needed.
  39  * As best I can tell, the BIOS is arranged as such:
  40  * offset 0x00000 to 0x4ffff (320k):  unknown - SCSI BIOS, etc?
  41  * offset 0x50000 to 0xeffff (640k):  BIOS proper
  42  * offset 0xf0000 ty 0xfffff (64k):   Boot Block region
  43  *
  44  * Intel's BIOS update program flashes the BIOS and Boot Block in separate
  45  * steps.  Probably a wise thing to do.
  46  */
  47
  48 #include <linux/module.h>
  49 #include <linux/types.h>
  50 #include <linux/kernel.h>
  51 #include <linux/init.h>
  52 #include <asm/io.h>
  53 #include <linux/mtd/mtd.h>
  54 #include <linux/mtd/map.h>
  55 #include <linux/mtd/cfi.h>
  56 #include <linux/config.h>
  57 #include <linux/pci.h>
  58 #include <linux/pci_ids.h>
  59
  60 #define MODNAME         "scb2_flash"
  61 #define SCB2_ADDR       0xfff00000
  62 #define SCB2_WINDOW     0x00100000
  63
  64
  65 static void __iomem *scb2_ioaddr;
  66 static struct mtd_info *scb2_mtd;
  67 static struct map_info scb2_map = {
  68         .name =      "SCB2 BIOS Flash",
  69         .size =      0,
  70         .bankwidth =  1,
  71 };
  72 static int region_fail;
  73
  74 static int __devinit
  75 scb2_fixup_mtd(struct mtd_info *mtd)
  76 {
  77         int i;
  78         int done = 0;
  79         struct map_info *map = mtd->priv;
  80         struct cfi_private *cfi = map->fldrv_priv;
  81
  82         /* barf if this doesn't look right */
  83         if (cfi->cfiq->InterfaceDesc != 1) {
  84                 printk(KERN_ERR MODNAME ": unsupported InterfaceDesc: %#x\n",
  85                     cfi->cfiq->InterfaceDesc);
  86                 return -1;
  87         }
  88
  89         /* I wasn't here. I didn't see. dwmw2. */
  90
  91         /* the chip is sometimes bigger than the map - what a waste */
  92         mtd->size = map->size;
  93
  94         /*
  95          * We only REALLY get half the chip, due to the way it is
  96          * wired up - D8-D15 are tossed away.  We read linear bytes,
  97          * but in reality we are getting 1/2 of each 16-bit read,
  98          * which LOOKS linear to us.  Because CFI code accounts for
  99          * things like lock/unlock/erase by eraseregions, we need to
 100          * fudge them to reflect this.  Erases go like this:
 101          *   * send an erase to an address
 102          *   * the chip samples the address and erases the block
 103          *   * add the block erasesize to the address and repeat
 104          *   -- the problem is that addresses are 16-bit addressable
 105          *   -- we end up erasing every-other block
 106          */
 107         mtd->erasesize /= 2;
 108         for (i = 0; i < mtd->numeraseregions; i++) {
 109                 struct mtd_erase_region_info *region = &mtd->eraseregions[i];
 110                 region->erasesize /= 2;
 111         }
 112
 113         /*
 114          * If the chip is bigger than the map, it is wired with the high
 115          * address lines pulled up.  This makes us access the top portion of
 116          * the chip, so all our erase-region info is wrong.  Start cutting from
 117          * the bottom.
 118          */
 119         for (i = 0; !done && i < mtd->numeraseregions; i++) {
 120                 struct mtd_erase_region_info *region = &mtd->eraseregions[i];
 121
 122                 if (region->numblocks * region->erasesize > mtd->size) {
 123                         region->numblocks = (mtd->size / region->erasesize);
 124                         done = 1;
 125                 } else {
 126                         region->numblocks = 0;
 127                 }
 128                 region->offset = 0;
 129         }
 130
 131         return 0;
 132 }
 133
 134 /* CSB5's 'Function Control Register' has bits for decoding @ >= 0xffc00000 */
 135 #define CSB5_FCR        0x41
 136 #define CSB5_FCR_DECODE_ALL 0x0e
 137 static int __devinit
 138 scb2_flash_probe(struct pci_dev *dev, const struct pci_device_id *ent)
 139 {
 140         u8 reg;
 141
 142         /* enable decoding of the flash region in the south bridge */
 143         pci_read_config_byte(dev, CSB5_FCR, &reg);
 144         pci_write_config_byte(dev, CSB5_FCR, reg | CSB5_FCR_DECODE_ALL);
 145
 146         if (!request_mem_region(SCB2_ADDR, SCB2_WINDOW, scb2_map.name)) {
 147                 /*
 148                  * The BIOS seems to mark the flash region as 'reserved'
 149                  * in the e820 map.  Warn and go about our business.
 150                  */
 151                 printk(KERN_WARNING MODNAME
 152                     ": warning - can't reserve rom window, continuing\n");
 153                 region_fail = 1;
 154         }
 155
 156         /* remap the IO window (w/o caching) */
 157         scb2_ioaddr = ioremap_nocache(SCB2_ADDR, SCB2_WINDOW);
 158         if (!scb2_ioaddr) {
 159                 printk(KERN_ERR MODNAME ": Failed to ioremap window!\n");
 160                 if (!region_fail)
 161                         release_mem_region(SCB2_ADDR, SCB2_WINDOW);
 162                 return -ENOMEM;
 163         }
 164
 165         scb2_map.phys = SCB2_ADDR;
 166         scb2_map.virt = scb2_ioaddr;
 167         scb2_map.size = SCB2_WINDOW;
 168
 169         simple_map_init(&scb2_map);
 170
 171         /* try to find a chip */
 172         scb2_mtd = do_map_probe("cfi_probe", &scb2_map);
 173
 174         if (!scb2_mtd) {
 175                 printk(KERN_ERR MODNAME ": flash probe failed!\n");
 176                 iounmap(scb2_ioaddr);
 177                 if (!region_fail)
 178                         release_mem_region(SCB2_ADDR, SCB2_WINDOW);
 179                 return -ENODEV;
 180         }
 181
 182         scb2_mtd->owner = THIS_MODULE;
 183         if (scb2_fixup_mtd(scb2_mtd) < 0) {
 184                 del_mtd_device(scb2_mtd);
 185                 map_destroy(scb2_mtd);
 186                 iounmap(scb2_ioaddr);
 187                 if (!region_fail)
 188                         release_mem_region(SCB2_ADDR, SCB2_WINDOW);
 189                 return -ENODEV;
 190         }
 191
 192         printk(KERN_NOTICE MODNAME ": chip size 0x%x at offset 0x%x\n",
 193                scb2_mtd->size, SCB2_WINDOW - scb2_mtd->size);
 194
 195         add_mtd_device(scb2_mtd);
 196
 197         return 0;
 198 }
 199
 200 static void __devexit
 201 scb2_flash_remove(struct pci_dev *dev)
 202 {
 203         if (!scb2_mtd)
 204                 return;
 205
 206         /* disable flash writes */
 207         if (scb2_mtd->lock)
 208                 scb2_mtd->lock(scb2_mtd, 0, scb2_mtd->size);
 209
 210         del_mtd_device(scb2_mtd);
 211         map_destroy(scb2_mtd);
 212
 213         iounmap(scb2_ioaddr);
 214         scb2_ioaddr = NULL;
 215
 216         if (!region_fail)
 217                 release_mem_region(SCB2_ADDR, SCB2_WINDOW);
 218         pci_set_drvdata(dev, NULL);
 219 }
 220
 221 static struct pci_device_id scb2_flash_pci_ids[] = {
 222         {
 223           .vendor = PCI_VENDOR_ID_SERVERWORKS,
 224           .device = PCI_DEVICE_ID_SERVERWORKS_CSB5,
 225           .subvendor = PCI_ANY_ID,
 226           .subdevice = PCI_ANY_ID
 227         },
 228         { 0, }
 229 };
 230
 231 static struct pci_driver scb2_flash_driver = {
 232         .name =     "Intel SCB2 BIOS Flash",
 233         .id_table = scb2_flash_pci_ids,
 234         .probe =    scb2_flash_probe,
 235         .remove =   __devexit_p(scb2_flash_remove),
 236 };
 237
 238 static int __init
 239 scb2_flash_init(void)
 240 {
 241         return pci_module_init(&scb2_flash_driver);
 242 }
 243
 244 static void __exit
 245 scb2_flash_exit(void)
 246 {
 247         pci_unregister_driver(&scb2_flash_driver);
 248 }
 249
 250 module_init(scb2_flash_init);
 251 module_exit(scb2_flash_exit);
 252
 253 MODULE_LICENSE("GPL");
 254 MODULE_AUTHOR("Tim Hockin <thockin@sun.com>");
 255 MODULE_DESCRIPTION("MTD map driver for Intel SCB2 BIOS Flash");
 256 MODULE_DEVICE_TABLE(pci, scb2_flash_pci_ids);