V4L/DVB (6715): ivtv: Remove unnecessary register update
[linux-2.6/verdex.git] / drivers / mmc / host / imxmmc.h
blobe5339e334dbb3525a1e5175989153441024af729
2 # define __REG16(x) (*((volatile u16 *)IO_ADDRESS(x)))
4 #define MMC_STR_STP_CLK __REG16(IMX_MMC_BASE + 0x00)
5 #define MMC_STATUS __REG16(IMX_MMC_BASE + 0x04)
6 #define MMC_CLK_RATE __REG16(IMX_MMC_BASE + 0x08)
7 #define MMC_CMD_DAT_CONT __REG16(IMX_MMC_BASE + 0x0C)
8 #define MMC_RES_TO __REG16(IMX_MMC_BASE + 0x10)
9 #define MMC_READ_TO __REG16(IMX_MMC_BASE + 0x14)
10 #define MMC_BLK_LEN __REG16(IMX_MMC_BASE + 0x18)
11 #define MMC_NOB __REG16(IMX_MMC_BASE + 0x1C)
12 #define MMC_REV_NO __REG16(IMX_MMC_BASE + 0x20)
13 #define MMC_INT_MASK __REG16(IMX_MMC_BASE + 0x24)
14 #define MMC_CMD __REG16(IMX_MMC_BASE + 0x28)
15 #define MMC_ARGH __REG16(IMX_MMC_BASE + 0x2C)
16 #define MMC_ARGL __REG16(IMX_MMC_BASE + 0x30)
17 #define MMC_RES_FIFO __REG16(IMX_MMC_BASE + 0x34)
18 #define MMC_BUFFER_ACCESS __REG16(IMX_MMC_BASE + 0x38)
19 #define MMC_BUFFER_ACCESS_OFS 0x38
22 #define STR_STP_CLK_ENDIAN (1<<5)
23 #define STR_STP_CLK_RESET (1<<3)
24 #define STR_STP_CLK_ENABLE (1<<2)
25 #define STR_STP_CLK_START_CLK (1<<1)
26 #define STR_STP_CLK_STOP_CLK (1<<0)
27 #define STATUS_CARD_PRESENCE (1<<15)
28 #define STATUS_SDIO_INT_ACTIVE (1<<14)
29 #define STATUS_END_CMD_RESP (1<<13)
30 #define STATUS_WRITE_OP_DONE (1<<12)
31 #define STATUS_DATA_TRANS_DONE (1<<11)
32 #define STATUS_WR_CRC_ERROR_CODE_MASK (3<<10)
33 #define STATUS_CARD_BUS_CLK_RUN (1<<8)
34 #define STATUS_APPL_BUFF_FF (1<<7)
35 #define STATUS_APPL_BUFF_FE (1<<6)
36 #define STATUS_RESP_CRC_ERR (1<<5)
37 #define STATUS_CRC_READ_ERR (1<<3)
38 #define STATUS_CRC_WRITE_ERR (1<<2)
39 #define STATUS_TIME_OUT_RESP (1<<1)
40 #define STATUS_TIME_OUT_READ (1<<0)
41 #define STATUS_ERR_MASK 0x2f
42 #define CLK_RATE_PRESCALER(x) ((x) & 0x7)
43 #define CLK_RATE_CLK_RATE(x) (((x) & 0x7) << 3)
44 #define CMD_DAT_CONT_CMD_RESP_LONG_OFF (1<<12)
45 #define CMD_DAT_CONT_STOP_READWAIT (1<<11)
46 #define CMD_DAT_CONT_START_READWAIT (1<<10)
47 #define CMD_DAT_CONT_BUS_WIDTH_1 (0<<8)
48 #define CMD_DAT_CONT_BUS_WIDTH_4 (2<<8)
49 #define CMD_DAT_CONT_INIT (1<<7)
50 #define CMD_DAT_CONT_BUSY (1<<6)
51 #define CMD_DAT_CONT_STREAM_BLOCK (1<<5)
52 #define CMD_DAT_CONT_WRITE (1<<4)
53 #define CMD_DAT_CONT_DATA_ENABLE (1<<3)
54 #define CMD_DAT_CONT_RESPONSE_FORMAT_R1 (1)
55 #define CMD_DAT_CONT_RESPONSE_FORMAT_R2 (2)
56 #define CMD_DAT_CONT_RESPONSE_FORMAT_R3 (3)
57 #define CMD_DAT_CONT_RESPONSE_FORMAT_R4 (4)
58 #define CMD_DAT_CONT_RESPONSE_FORMAT_R5 (5)
59 #define CMD_DAT_CONT_RESPONSE_FORMAT_R6 (6)
60 #define INT_MASK_AUTO_CARD_DETECT (1<<6)
61 #define INT_MASK_DAT0_EN (1<<5)
62 #define INT_MASK_SDIO (1<<4)
63 #define INT_MASK_BUF_READY (1<<3)
64 #define INT_MASK_END_CMD_RES (1<<2)
65 #define INT_MASK_WRITE_OP_DONE (1<<1)
66 #define INT_MASK_DATA_TRAN (1<<0)
67 #define INT_ALL (0x7f)