drivers/mtd/chips/fwh_lock.h

   1 #ifndef FWH_LOCK_H
   2 #define FWH_LOCK_H
   3
   4
   5 enum fwh_lock_state {
   6         FWH_UNLOCKED   = 0,
   7         FWH_DENY_WRITE = 1,
   8         FWH_IMMUTABLE  = 2,
   9         FWH_DENY_READ  = 4,
  10 };
  11
  12 struct fwh_xxlock_thunk {
  13         enum fwh_lock_state val;
  14         flstate_t state;
  15 };
  16
  17
  18 #define FWH_XXLOCK_ONEBLOCK_LOCK   ((struct fwh_xxlock_thunk){ FWH_DENY_WRITE, FL_LOCKING})
  19 #define FWH_XXLOCK_ONEBLOCK_UNLOCK ((struct fwh_xxlock_thunk){ FWH_UNLOCKED,   FL_UNLOCKING})
  20
  21 /*
  22  * This locking/unlock is specific to firmware hub parts.  Only one
  23  * is known that supports the Intel command set.    Firmware
  24  * hub parts cannot be interleaved as they are on the LPC bus
  25  * so this code has not been tested with interleaved chips,
  26  * and will likely fail in that context.
  27  */
  28 static int fwh_xxlock_oneblock(struct map_info *map, struct flchip *chip,
  29         unsigned long adr, int len, void *thunk)
  30 {
  31         struct cfi_private *cfi = map->fldrv_priv;
  32         struct fwh_xxlock_thunk *xxlt = (struct fwh_xxlock_thunk *)thunk;
  33         int ret;
  34
  35         /* Refuse the operation if the we cannot look behind the chip */
  36         if (chip->start < 0x400000) {
  37                 DEBUG( MTD_DEBUG_LEVEL3,
  38                         "MTD %s(): chip->start: %lx wanted >= 0x400000\n",
  39                         __func__, chip->start );
  40                 return -EIO;
  41         }
  42         /*
  43          * lock block registers:
  44          * - on 64k boundariesand
  45          * - bit 1 set high
  46          * - block lock registers are 4MiB lower - overflow subtract (danger)
  47          *
  48          * The address manipulation is first done on the logical address
  49          * which is 0 at the start of the chip, and then the offset of
  50          * the individual chip is addted to it.  Any other order a weird
  51          * map offset could cause problems.
  52          */
  53         adr = (adr & ~0xffffUL) | 0x2;
  54         adr += chip->start - 0x400000;
  55
  56         /*
  57          * This is easy because these are writes to registers and not writes
  58          * to flash memory - that means that we don't have to check status
  59          * and timeout.
  60          */
  61         spin_lock(chip->mutex);
  62         ret = get_chip(map, chip, adr, FL_LOCKING);
  63         if (ret) {
  64                 spin_unlock(chip->mutex);
  65                 return ret;
  66         }
  67
  68         chip->oldstate = chip->state;
  69         chip->state = xxlt->state;
  70         map_write(map, CMD(xxlt->val), adr);
  71
  72         /* Done and happy. */
  73         chip->state = chip->oldstate;
  74         put_chip(map, chip, adr);
  75         spin_unlock(chip->mutex);
  76         return 0;
  77 }
  78
  79
  80 static int fwh_lock_varsize(struct mtd_info *mtd, loff_t ofs, size_t len)
  81 {
  82         int ret;
  83
  84         ret = cfi_varsize_frob(mtd, fwh_xxlock_oneblock, ofs, len,
  85                 (void *)&FWH_XXLOCK_ONEBLOCK_LOCK);
  86
  87         return ret;
  88 }
  89
  90
  91 static int fwh_unlock_varsize(struct mtd_info *mtd, loff_t ofs, size_t len)
  92 {
  93         int ret;
  94
  95         ret = cfi_varsize_frob(mtd, fwh_xxlock_oneblock, ofs, len,
  96                 (void *)&FWH_XXLOCK_ONEBLOCK_UNLOCK);
  97
  98         return ret;
  99 }
 100
 101 static void fixup_use_fwh_lock(struct mtd_info *mtd, void *param)
 102 {
 103         printk(KERN_NOTICE "using fwh lock/unlock method\n");
 104         /* Setup for the chips with the fwh lock method */
 105         mtd->lock   = fwh_lock_varsize;
 106         mtd->unlock = fwh_unlock_varsize;
 107 }
 108 #endif /* FWH_LOCK_H */