OMAP3: PM: CPUfreq support for OMAP3EVM board
[linux-ginger.git] / drivers / block / cciss_cmd.h
blobdbaed1ea0da3c9c2ba71993dfec116d291a87770
1 #ifndef CCISS_CMD_H
2 #define CCISS_CMD_H
3 //###########################################################################
4 //DEFINES
5 //###########################################################################
6 #define CISS_VERSION "1.00"
8 //general boundary defintions
9 #define SENSEINFOBYTES 32//note that this value may vary between host implementations
10 #define MAXSGENTRIES 31
11 #define MAXREPLYQS 256
13 //Command Status value
14 #define CMD_SUCCESS 0x0000
15 #define CMD_TARGET_STATUS 0x0001
16 #define CMD_DATA_UNDERRUN 0x0002
17 #define CMD_DATA_OVERRUN 0x0003
18 #define CMD_INVALID 0x0004
19 #define CMD_PROTOCOL_ERR 0x0005
20 #define CMD_HARDWARE_ERR 0x0006
21 #define CMD_CONNECTION_LOST 0x0007
22 #define CMD_ABORTED 0x0008
23 #define CMD_ABORT_FAILED 0x0009
24 #define CMD_UNSOLICITED_ABORT 0x000A
25 #define CMD_TIMEOUT 0x000B
26 #define CMD_UNABORTABLE 0x000C
28 /* Unit Attentions ASC's as defined for the MSA2012sa */
29 #define POWER_OR_RESET 0x29
30 #define STATE_CHANGED 0x2a
31 #define UNIT_ATTENTION_CLEARED 0x2f
32 #define LUN_FAILED 0x3e
33 #define REPORT_LUNS_CHANGED 0x3f
35 /* Unit Attentions ASCQ's as defined for the MSA2012sa */
37 /* These ASCQ's defined for ASC = POWER_OR_RESET */
38 #define POWER_ON_RESET 0x00
39 #define POWER_ON_REBOOT 0x01
40 #define SCSI_BUS_RESET 0x02
41 #define MSA_TARGET_RESET 0x03
42 #define CONTROLLER_FAILOVER 0x04
43 #define TRANSCEIVER_SE 0x05
44 #define TRANSCEIVER_LVD 0x06
46 /* These ASCQ's defined for ASC = STATE_CHANGED */
47 #define RESERVATION_PREEMPTED 0x03
48 #define ASYM_ACCESS_CHANGED 0x06
49 #define LUN_CAPACITY_CHANGED 0x09
51 //transfer direction
52 #define XFER_NONE 0x00
53 #define XFER_WRITE 0x01
54 #define XFER_READ 0x02
55 #define XFER_RSVD 0x03
57 //task attribute
58 #define ATTR_UNTAGGED 0x00
59 #define ATTR_SIMPLE 0x04
60 #define ATTR_HEADOFQUEUE 0x05
61 #define ATTR_ORDERED 0x06
62 #define ATTR_ACA 0x07
64 //cdb type
65 #define TYPE_CMD 0x00
66 #define TYPE_MSG 0x01
68 //config space register offsets
69 #define CFG_VENDORID 0x00
70 #define CFG_DEVICEID 0x02
71 #define CFG_I2OBAR 0x10
72 #define CFG_MEM1BAR 0x14
74 //i2o space register offsets
75 #define I2O_IBDB_SET 0x20
76 #define I2O_IBDB_CLEAR 0x70
77 #define I2O_INT_STATUS 0x30
78 #define I2O_INT_MASK 0x34
79 #define I2O_IBPOST_Q 0x40
80 #define I2O_OBPOST_Q 0x44
81 #define I2O_DMA1_CFG 0x214
83 //Configuration Table
84 #define CFGTBL_ChangeReq 0x00000001l
85 #define CFGTBL_AccCmds 0x00000001l
87 #define CFGTBL_Trans_Simple 0x00000002l
89 #define CFGTBL_BusType_Ultra2 0x00000001l
90 #define CFGTBL_BusType_Ultra3 0x00000002l
91 #define CFGTBL_BusType_Fibre1G 0x00000100l
92 #define CFGTBL_BusType_Fibre2G 0x00000200l
93 typedef struct _vals32
95 __u32 lower;
96 __u32 upper;
97 } vals32;
99 typedef union _u64bit
101 vals32 val32;
102 __u64 val;
103 } u64bit;
105 // Type defs used in the following structs
106 #define BYTE __u8
107 #define WORD __u16
108 #define HWORD __u16
109 #define DWORD __u32
110 #define QWORD vals32
112 //###########################################################################
113 //STRUCTURES
114 //###########################################################################
115 #define CISS_MAX_LUN 1024
116 #define CISS_MAX_PHYS_LUN 1024
117 // SCSI-3 Cmmands
119 #pragma pack(1)
121 #define CISS_INQUIRY 0x12
122 //Date returned
123 typedef struct _InquiryData_struct
125 BYTE data_byte[36];
126 } InquiryData_struct;
128 #define CISS_REPORT_LOG 0xc2 /* Report Logical LUNs */
129 #define CISS_REPORT_PHYS 0xc3 /* Report Physical LUNs */
130 // Data returned
131 typedef struct _ReportLUNdata_struct
133 BYTE LUNListLength[4];
134 DWORD reserved;
135 BYTE LUN[CISS_MAX_LUN][8];
136 } ReportLunData_struct;
138 #define CCISS_READ_CAPACITY 0x25 /* Read Capacity */
139 typedef struct _ReadCapdata_struct
141 BYTE total_size[4]; // Total size in blocks
142 BYTE block_size[4]; // Size of blocks in bytes
143 } ReadCapdata_struct;
145 #define CCISS_READ_CAPACITY_16 0x9e /* Read Capacity 16 */
147 /* service action to differentiate a 16 byte read capacity from
148 other commands that use the 0x9e SCSI op code */
150 #define CCISS_READ_CAPACITY_16_SERVICE_ACT 0x10
152 typedef struct _ReadCapdata_struct_16
154 BYTE total_size[8]; /* Total size in blocks */
155 BYTE block_size[4]; /* Size of blocks in bytes */
156 BYTE prot_en:1; /* protection enable bit */
157 BYTE rto_en:1; /* reference tag own enable bit */
158 BYTE reserved:6; /* reserved bits */
159 BYTE reserved2[18]; /* reserved bytes per spec */
160 } ReadCapdata_struct_16;
162 /* Define the supported read/write commands for cciss based controllers */
164 #define CCISS_READ_10 0x28 /* Read(10) */
165 #define CCISS_WRITE_10 0x2a /* Write(10) */
166 #define CCISS_READ_16 0x88 /* Read(16) */
167 #define CCISS_WRITE_16 0x8a /* Write(16) */
169 /* Define the CDB lengths supported by cciss based controllers */
171 #define CDB_LEN10 10
172 #define CDB_LEN16 16
174 // BMIC commands
175 #define BMIC_READ 0x26
176 #define BMIC_WRITE 0x27
177 #define BMIC_CACHE_FLUSH 0xc2
178 #define CCISS_CACHE_FLUSH 0x01 //C2 was already being used by CCISS
180 //Command List Structure
181 typedef union _SCSI3Addr_struct {
182 struct {
183 BYTE Dev;
184 BYTE Bus:6;
185 BYTE Mode:2; // b00
186 } PeripDev;
187 struct {
188 BYTE DevLSB;
189 BYTE DevMSB:6;
190 BYTE Mode:2; // b01
191 } LogDev;
192 struct {
193 BYTE Dev:5;
194 BYTE Bus:3;
195 BYTE Targ:6;
196 BYTE Mode:2; // b10
197 } LogUnit;
198 } SCSI3Addr_struct;
200 typedef struct _PhysDevAddr_struct {
201 DWORD TargetId:24;
202 DWORD Bus:6;
203 DWORD Mode:2;
204 SCSI3Addr_struct Target[2]; //2 level target device addr
205 } PhysDevAddr_struct;
207 typedef struct _LogDevAddr_struct {
208 DWORD VolId:30;
209 DWORD Mode:2;
210 BYTE reserved[4];
211 } LogDevAddr_struct;
213 typedef union _LUNAddr_struct {
214 BYTE LunAddrBytes[8];
215 SCSI3Addr_struct SCSI3Lun[4];
216 PhysDevAddr_struct PhysDev;
217 LogDevAddr_struct LogDev;
218 } LUNAddr_struct;
220 #define CTLR_LUNID "\0\0\0\0\0\0\0\0"
222 typedef struct _CommandListHeader_struct {
223 BYTE ReplyQueue;
224 BYTE SGList;
225 HWORD SGTotal;
226 QWORD Tag;
227 LUNAddr_struct LUN;
228 } CommandListHeader_struct;
229 typedef struct _RequestBlock_struct {
230 BYTE CDBLen;
231 struct {
232 BYTE Type:3;
233 BYTE Attribute:3;
234 BYTE Direction:2;
235 } Type;
236 HWORD Timeout;
237 BYTE CDB[16];
238 } RequestBlock_struct;
239 typedef struct _ErrDescriptor_struct {
240 QWORD Addr;
241 DWORD Len;
242 } ErrDescriptor_struct;
243 typedef struct _SGDescriptor_struct {
244 QWORD Addr;
245 DWORD Len;
246 DWORD Ext;
247 } SGDescriptor_struct;
249 typedef union _MoreErrInfo_struct{
250 struct {
251 BYTE Reserved[3];
252 BYTE Type;
253 DWORD ErrorInfo;
254 }Common_Info;
255 struct{
256 BYTE Reserved[2];
257 BYTE offense_size;//size of offending entry
258 BYTE offense_num; //byte # of offense 0-base
259 DWORD offense_value;
260 }Invalid_Cmd;
261 }MoreErrInfo_struct;
262 typedef struct _ErrorInfo_struct {
263 BYTE ScsiStatus;
264 BYTE SenseLen;
265 HWORD CommandStatus;
266 DWORD ResidualCnt;
267 MoreErrInfo_struct MoreErrInfo;
268 BYTE SenseInfo[SENSEINFOBYTES];
269 } ErrorInfo_struct;
271 /* Command types */
272 #define CMD_RWREQ 0x00
273 #define CMD_IOCTL_PEND 0x01
274 #define CMD_SCSI 0x03
275 #define CMD_MSG_DONE 0x04
276 #define CMD_MSG_TIMEOUT 0x05
277 #define CMD_MSG_STALE 0xff
279 /* This structure needs to be divisible by 8 for new
280 * indexing method.
282 #define PADSIZE (sizeof(long) - 4)
283 typedef struct _CommandList_struct {
284 CommandListHeader_struct Header;
285 RequestBlock_struct Request;
286 ErrDescriptor_struct ErrDesc;
287 SGDescriptor_struct SG[MAXSGENTRIES];
288 /* information associated with the command */
289 __u32 busaddr; /* physical address of this record */
290 ErrorInfo_struct * err_info; /* pointer to the allocated mem */
291 int ctlr;
292 int cmd_type;
293 long cmdindex;
294 struct hlist_node list;
295 struct request * rq;
296 struct completion *waiting;
297 int retry_count;
298 void * scsi_cmd;
299 char pad[PADSIZE];
300 } CommandList_struct;
302 //Configuration Table Structure
303 typedef struct _HostWrite_struct {
304 DWORD TransportRequest;
305 DWORD Reserved;
306 DWORD CoalIntDelay;
307 DWORD CoalIntCount;
308 } HostWrite_struct;
310 typedef struct _CfgTable_struct {
311 BYTE Signature[4];
312 DWORD SpecValence;
313 DWORD TransportSupport;
314 DWORD TransportActive;
315 HostWrite_struct HostWrite;
316 DWORD CmdsOutMax;
317 DWORD BusTypes;
318 DWORD Reserved;
319 BYTE ServerName[16];
320 DWORD HeartBeat;
321 DWORD SCSI_Prefetch;
322 } CfgTable_struct;
323 #pragma pack()
324 #endif // CCISS_CMD_H