OMAP3 SRF: Add virt clk nodes for VDD1/VDD2
[linux-ginger.git] / include / scsi / fc / fc_fcp.h
blob5d38f1989f37b90a14bafb9b8a0d501d63681773
1 /*
2 * Copyright(c) 2007 Intel Corporation. All rights reserved.
4 * This program is free software; you can redistribute it and/or modify it
5 * under the terms and conditions of the GNU General Public License,
6 * version 2, as published by the Free Software Foundation.
8 * This program is distributed in the hope it will be useful, but WITHOUT
9 * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
10 * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
11 * more details.
13 * You should have received a copy of the GNU General Public License along with
14 * this program; if not, write to the Free Software Foundation, Inc.,
15 * 51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA.
17 * Maintained at www.Open-FCoE.org
20 #ifndef _FC_FCP_H_
21 #define _FC_FCP_H_
24 * Fibre Channel Protocol for SCSI.
25 * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
29 * fc/fs.h defines FC_TYPE_FCP.
33 * Service parameter page parameters (word 3 bits) for Process Login.
35 #define FCP_SPPF_TASK_RETRY_ID 0x0200 /* task retry ID requested */
36 #define FCP_SPPF_RETRY 0x0100 /* retry supported */
37 #define FCP_SPPF_CONF_COMPL 0x0080 /* confirmed completion allowed */
38 #define FCP_SPPF_OVLY_ALLOW 0x0040 /* data overlay allowed */
39 #define FCP_SPPF_INIT_FCN 0x0020 /* initiator function */
40 #define FCP_SPPF_TARG_FCN 0x0010 /* target function */
41 #define FCP_SPPF_RD_XRDY_DIS 0x0002 /* disable XFER_RDY for reads */
42 #define FCP_SPPF_WR_XRDY_DIS 0x0001 /* disable XFER_RDY for writes */
45 * FCP_CMND IU Payload.
47 struct fcp_cmnd {
48 __u8 fc_lun[8]; /* logical unit number */
49 __u8 fc_cmdref; /* commmand reference number */
50 __u8 fc_pri_ta; /* priority and task attribute */
51 __u8 fc_tm_flags; /* task management flags */
52 __u8 fc_flags; /* additional len & flags */
53 __u8 fc_cdb[16]; /* base CDB */
54 __be32 fc_dl; /* data length (must follow fc_cdb) */
57 #define FCP_CMND_LEN 32 /* expected length of structure */
59 struct fcp_cmnd32 {
60 __u8 fc_lun[8]; /* logical unit number */
61 __u8 fc_cmdref; /* commmand reference number */
62 __u8 fc_pri_ta; /* priority and task attribute */
63 __u8 fc_tm_flags; /* task management flags */
64 __u8 fc_flags; /* additional len & flags */
65 __u8 fc_cdb[32]; /* base CDB */
66 __be32 fc_dl; /* data length (must follow fc_cdb) */
69 #define FCP_CMND32_LEN 48 /* expected length of structure */
70 #define FCP_CMND32_ADD_LEN (16 / 4) /* Additional cdb length */
73 * fc_pri_ta.
75 #define FCP_PTA_SIMPLE 0 /* simple task attribute */
76 #define FCP_PTA_HEADQ 1 /* head of queue task attribute */
77 #define FCP_PTA_ORDERED 2 /* ordered task attribute */
78 #define FCP_PTA_ACA 4 /* auto. contigent allegiance */
79 #define FCP_PRI_SHIFT 3 /* priority field starts in bit 3 */
80 #define FCP_PRI_RESVD_MASK 0x80 /* reserved bits in priority field */
83 * fc_tm_flags - task management flags field.
85 #define FCP_TMF_CLR_ACA 0x40 /* clear ACA condition */
86 #define FCP_TMF_LUN_RESET 0x10 /* logical unit reset task management */
87 #define FCP_TMF_CLR_TASK_SET 0x04 /* clear task set */
88 #define FCP_TMF_ABT_TASK_SET 0x02 /* abort task set */
91 * fc_flags.
92 * Bits 7:2 are the additional FCP_CDB length / 4.
94 #define FCP_CFL_LEN_MASK 0xfc /* mask for additional length */
95 #define FCP_CFL_LEN_SHIFT 2 /* shift bits for additional length */
96 #define FCP_CFL_RDDATA 0x02 /* read data */
97 #define FCP_CFL_WRDATA 0x01 /* write data */
100 * FCP_TXRDY IU - transfer ready payload.
102 struct fcp_txrdy {
103 __be32 ft_data_ro; /* data relative offset */
104 __be32 ft_burst_len; /* burst length */
105 __u8 _ft_resvd[4]; /* reserved */
108 #define FCP_TXRDY_LEN 12 /* expected length of structure */
111 * FCP_RESP IU - response payload.
113 * The response payload comes in three parts: the flags/status, the
114 * sense/response lengths and the sense data/response info section.
116 * From FCP3r04, note 6 of section 9.5.13:
118 * Some early implementations presented the FCP_RSP IU without the FCP_RESID,
119 * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
120 * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
121 * non-standard behavior should be tolerated.
123 * All response frames will always contain the fcp_resp template. Some
124 * will also include the fcp_resp_len template.
126 struct fcp_resp {
127 __u8 _fr_resvd[8]; /* reserved */
128 __be16 fr_retry_delay; /* retry delay timer */
129 __u8 fr_flags; /* flags */
130 __u8 fr_status; /* SCSI status code */
133 #define FCP_RESP_LEN 12 /* expected length of structure */
135 struct fcp_resp_ext {
136 __be32 fr_resid; /* Residual value */
137 __be32 fr_sns_len; /* SCSI Sense length */
138 __be32 fr_rsp_len; /* Response Info length */
141 * Optionally followed by RSP info and/or SNS info and/or
142 * bidirectional read residual length, if any.
146 #define FCP_RESP_EXT_LEN 12 /* expected length of the structure */
148 struct fcp_resp_rsp_info {
149 __u8 _fr_resvd[3]; /* reserved */
150 __u8 rsp_code; /* Response Info Code */
151 __u8 _fr_resvd2[4]; /* reserved */
154 struct fcp_resp_with_ext {
155 struct fcp_resp resp;
156 struct fcp_resp_ext ext;
159 #define FCP_RESP_WITH_EXT (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
162 * fr_flags.
164 #define FCP_BIDI_RSP 0x80 /* bidirectional read response */
165 #define FCP_BIDI_READ_UNDER 0x40 /* bidir. read less than requested */
166 #define FCP_BIDI_READ_OVER 0x20 /* DL insufficient for full transfer */
167 #define FCP_CONF_REQ 0x10 /* confirmation requested */
168 #define FCP_RESID_UNDER 0x08 /* transfer shorter than expected */
169 #define FCP_RESID_OVER 0x04 /* DL insufficient for full transfer */
170 #define FCP_SNS_LEN_VAL 0x02 /* SNS_LEN field is valid */
171 #define FCP_RSP_LEN_VAL 0x01 /* RSP_LEN field is valid */
174 * rsp_codes
176 enum fcp_resp_rsp_codes {
177 FCP_TMF_CMPL = 0,
178 FCP_DATA_LEN_INVALID = 1,
179 FCP_CMND_FIELDS_INVALID = 2,
180 FCP_DATA_PARAM_MISMATCH = 3,
181 FCP_TMF_REJECTED = 4,
182 FCP_TMF_FAILED = 5,
183 FCP_TMF_INVALID_LUN = 9,
187 * FCP SRR Link Service request - Sequence Retransmission Request.
189 struct fcp_srr {
190 __u8 srr_op; /* opcode ELS_SRR */
191 __u8 srr_resvd[3]; /* opcode / reserved - must be zero */
192 __be16 srr_ox_id; /* OX_ID of failed command */
193 __be16 srr_rx_id; /* RX_ID of failed command */
194 __be32 srr_rel_off; /* relative offset */
195 __u8 srr_r_ctl; /* r_ctl for the information unit */
196 __u8 srr_resvd2[3]; /* reserved */
199 #endif /* _FC_FCP_H_ */