OMAP: Add new function to check wether there is irq pending
[linux-ginger.git] / arch / blackfin / include / asm / bfin5xx_spi.h
blobaaeb4df10d578c6128aa6ef13a6ffb41b91e6a25
1 /*
2 * Blackfin On-Chip SPI Driver
4 * Copyright 2004-2008 Analog Devices Inc.
6 * Enter bugs at http://blackfin.uclinux.org/
8 * Licensed under the GPL-2 or later.
9 */
11 #ifndef _SPI_CHANNEL_H_
12 #define _SPI_CHANNEL_H_
14 #define MIN_SPI_BAUD_VAL 2
16 #define SPI_READ 0
17 #define SPI_WRITE 1
19 #define SPI_CTRL_OFF 0x0
20 #define SPI_FLAG_OFF 0x4
21 #define SPI_STAT_OFF 0x8
22 #define SPI_TXBUFF_OFF 0xc
23 #define SPI_RXBUFF_OFF 0x10
24 #define SPI_BAUD_OFF 0x14
25 #define SPI_SHAW_OFF 0x18
28 #define BIT_CTL_ENABLE 0x4000
29 #define BIT_CTL_OPENDRAIN 0x2000
30 #define BIT_CTL_MASTER 0x1000
31 #define BIT_CTL_POLAR 0x0800
32 #define BIT_CTL_PHASE 0x0400
33 #define BIT_CTL_BITORDER 0x0200
34 #define BIT_CTL_WORDSIZE 0x0100
35 #define BIT_CTL_MISOENABLE 0x0020
36 #define BIT_CTL_RXMOD 0x0000
37 #define BIT_CTL_TXMOD 0x0001
38 #define BIT_CTL_TIMOD_DMA_TX 0x0003
39 #define BIT_CTL_TIMOD_DMA_RX 0x0002
40 #define BIT_CTL_SENDOPT 0x0004
41 #define BIT_CTL_TIMOD 0x0003
43 #define BIT_STAT_SPIF 0x0001
44 #define BIT_STAT_MODF 0x0002
45 #define BIT_STAT_TXE 0x0004
46 #define BIT_STAT_TXS 0x0008
47 #define BIT_STAT_RBSY 0x0010
48 #define BIT_STAT_RXS 0x0020
49 #define BIT_STAT_TXCOL 0x0040
50 #define BIT_STAT_CLR 0xFFFF
52 #define BIT_STU_SENDOVER 0x0001
53 #define BIT_STU_RECVFULL 0x0020
55 #define CFG_SPI_ENABLE 1
56 #define CFG_SPI_DISABLE 0
58 #define CFG_SPI_OUTENABLE 1
59 #define CFG_SPI_OUTDISABLE 0
61 #define CFG_SPI_ACTLOW 1
62 #define CFG_SPI_ACTHIGH 0
64 #define CFG_SPI_PHASESTART 1
65 #define CFG_SPI_PHASEMID 0
67 #define CFG_SPI_MASTER 1
68 #define CFG_SPI_SLAVE 0
70 #define CFG_SPI_SENELAST 0
71 #define CFG_SPI_SENDZERO 1
73 #define CFG_SPI_RCVFLUSH 1
74 #define CFG_SPI_RCVDISCARD 0
76 #define CFG_SPI_LSBFIRST 1
77 #define CFG_SPI_MSBFIRST 0
79 #define CFG_SPI_WORDSIZE16 1
80 #define CFG_SPI_WORDSIZE8 0
82 #define CFG_SPI_MISOENABLE 1
83 #define CFG_SPI_MISODISABLE 0
85 #define CFG_SPI_READ 0x00
86 #define CFG_SPI_WRITE 0x01
87 #define CFG_SPI_DMAREAD 0x02
88 #define CFG_SPI_DMAWRITE 0x03
90 #define CFG_SPI_CSCLEARALL 0
91 #define CFG_SPI_CHIPSEL1 1
92 #define CFG_SPI_CHIPSEL2 2
93 #define CFG_SPI_CHIPSEL3 3
94 #define CFG_SPI_CHIPSEL4 4
95 #define CFG_SPI_CHIPSEL5 5
96 #define CFG_SPI_CHIPSEL6 6
97 #define CFG_SPI_CHIPSEL7 7
99 #define CFG_SPI_CS1VALUE 1
100 #define CFG_SPI_CS2VALUE 2
101 #define CFG_SPI_CS3VALUE 3
102 #define CFG_SPI_CS4VALUE 4
103 #define CFG_SPI_CS5VALUE 5
104 #define CFG_SPI_CS6VALUE 6
105 #define CFG_SPI_CS7VALUE 7
107 #define CMD_SPI_SET_BAUDRATE 2
108 #define CMD_SPI_GET_SYSTEMCLOCK 25
109 #define CMD_SPI_SET_WRITECONTINUOUS 26
111 /* device.platform_data for SSP controller devices */
112 struct bfin5xx_spi_master {
113 u16 num_chipselect;
114 u8 enable_dma;
115 u16 pin_req[7];
118 /* spi_board_info.controller_data for SPI slave devices,
119 * copied to spi_device.platform_data ... mostly for dma tuning
121 struct bfin5xx_spi_chip {
122 u16 ctl_reg;
123 u8 enable_dma;
124 u8 bits_per_word;
125 u8 cs_change_per_word;
126 u16 cs_chg_udelay; /* Some devices require 16-bit delays */
127 u32 cs_gpio;
128 /* Value to send if no TX value is supplied, usually 0x0 or 0xFFFF */
129 u16 idle_tx_val;
132 #endif /* _SPI_CHANNEL_H_ */