jfs: Simplify code
[linux/fpc-iii.git] / drivers / Makefile
blob53abb4a5f73601d183f05c2bb9ae9c8f06cdaec4
2 # Makefile for the Linux kernel device drivers.
4 # 15 Sep 2000, Christoph Hellwig <hch@infradead.org>
5 # Rewritten to use lists instead of if-statements.
8 obj-y += irqchip/
9 obj-y += bus/
11 obj-$(CONFIG_GENERIC_PHY) += phy/
13 # GPIO must come after pinctrl as gpios may need to mux pins etc
14 obj-$(CONFIG_PINCTRL) += pinctrl/
15 obj-$(CONFIG_GPIOLIB) += gpio/
16 obj-y += pwm/
17 obj-$(CONFIG_PCI) += pci/
18 obj-$(CONFIG_PARISC) += parisc/
19 obj-$(CONFIG_RAPIDIO) += rapidio/
20 obj-y += video/
21 obj-y += idle/
23 # IPMI must come before ACPI in order to provide IPMI opregion support
24 obj-$(CONFIG_IPMI_HANDLER) += char/ipmi/
26 obj-$(CONFIG_ACPI) += acpi/
27 obj-$(CONFIG_SFI) += sfi/
28 # PnP must come after ACPI since it will eventually need to check if acpi
29 # was used and do nothing if so
30 obj-$(CONFIG_PNP) += pnp/
31 obj-y += amba/
32 # Many drivers will want to use DMA so this has to be made available
33 # really early.
34 obj-$(CONFIG_DMADEVICES) += dma/
36 # SOC specific infrastructure drivers.
37 obj-y += soc/
39 obj-$(CONFIG_VIRTIO) += virtio/
40 obj-$(CONFIG_XEN) += xen/
42 # regulators early, since some subsystems rely on them to initialize
43 obj-$(CONFIG_REGULATOR) += regulator/
45 # reset controllers early, since gpu drivers might rely on them to initialize
46 obj-$(CONFIG_RESET_CONTROLLER) += reset/
48 # tty/ comes before char/ so that the VT console is the boot-time
49 # default.
50 obj-y += tty/
51 obj-y += char/
53 # iommu/ comes before gpu as gpu are using iommu controllers
54 obj-$(CONFIG_IOMMU_SUPPORT) += iommu/
56 # gpu/ comes after char for AGP vs DRM startup and after iommu
57 obj-y += gpu/
59 obj-$(CONFIG_CONNECTOR) += connector/
61 # i810fb and intelfb depend on char/agp/
62 obj-$(CONFIG_FB_I810) += video/fbdev/i810/
63 obj-$(CONFIG_FB_INTEL) += video/fbdev/intelfb/
65 obj-$(CONFIG_PARPORT) += parport/
66 obj-$(CONFIG_NVM) += lightnvm/
67 obj-y += base/ block/ misc/ mfd/ nfc/
68 obj-$(CONFIG_LIBNVDIMM) += nvdimm/
69 obj-$(CONFIG_DEV_DAX) += dax/
70 obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/
71 obj-$(CONFIG_NUBUS) += nubus/
72 obj-y += macintosh/
73 obj-$(CONFIG_IDE) += ide/
74 obj-$(CONFIG_SCSI) += scsi/
75 obj-y += nvme/
76 obj-$(CONFIG_ATA) += ata/
77 obj-$(CONFIG_TARGET_CORE) += target/
78 obj-$(CONFIG_MTD) += mtd/
79 obj-$(CONFIG_SPI) += spi/
80 obj-$(CONFIG_SPMI) += spmi/
81 obj-$(CONFIG_HSI) += hsi/
82 obj-y += net/
83 obj-$(CONFIG_ATM) += atm/
84 obj-$(CONFIG_FUSION) += message/
85 obj-y += firewire/
86 obj-$(CONFIG_UIO) += uio/
87 obj-$(CONFIG_VFIO) += vfio/
88 obj-y += cdrom/
89 obj-y += auxdisplay/
90 obj-$(CONFIG_PCCARD) += pcmcia/
91 obj-$(CONFIG_DIO) += dio/
92 obj-$(CONFIG_SBUS) += sbus/
93 obj-$(CONFIG_ZORRO) += zorro/
94 obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/
95 obj-$(CONFIG_PARIDE) += block/paride/
96 obj-$(CONFIG_TC) += tc/
97 obj-$(CONFIG_UWB) += uwb/
98 obj-$(CONFIG_USB_PHY) += usb/
99 obj-$(CONFIG_USB) += usb/
100 obj-$(CONFIG_PCI) += usb/
101 obj-$(CONFIG_USB_GADGET) += usb/
102 obj-$(CONFIG_SERIO) += input/serio/
103 obj-$(CONFIG_GAMEPORT) += input/gameport/
104 obj-$(CONFIG_INPUT) += input/
105 obj-$(CONFIG_RTC_LIB) += rtc/
106 obj-y += i2c/ media/
107 obj-$(CONFIG_PPS) += pps/
108 obj-$(CONFIG_PTP_1588_CLOCK) += ptp/
109 obj-$(CONFIG_W1) += w1/
110 obj-y += power/
111 obj-$(CONFIG_HWMON) += hwmon/
112 obj-$(CONFIG_THERMAL) += thermal/
113 obj-$(CONFIG_WATCHDOG) += watchdog/
114 obj-$(CONFIG_MD) += md/
115 obj-$(CONFIG_BT) += bluetooth/
116 obj-$(CONFIG_ACCESSIBILITY) += accessibility/
117 obj-$(CONFIG_ISDN) += isdn/
118 obj-$(CONFIG_EDAC) += edac/
119 obj-$(CONFIG_EISA) += eisa/
120 obj-y += lguest/
121 obj-$(CONFIG_CPU_FREQ) += cpufreq/
122 obj-$(CONFIG_CPU_IDLE) += cpuidle/
123 obj-y += mmc/
124 obj-$(CONFIG_MEMSTICK) += memstick/
125 obj-$(CONFIG_NEW_LEDS) += leds/
126 obj-$(CONFIG_INFINIBAND) += infiniband/
127 obj-$(CONFIG_SGI_SN) += sn/
128 obj-y += firmware/
129 obj-$(CONFIG_CRYPTO) += crypto/
130 obj-$(CONFIG_SUPERH) += sh/
131 ifndef CONFIG_ARCH_USES_GETTIMEOFFSET
132 obj-y += clocksource/
133 endif
134 obj-$(CONFIG_DCA) += dca/
135 obj-$(CONFIG_HID) += hid/
136 obj-$(CONFIG_PPC_PS3) += ps3/
137 obj-$(CONFIG_OF) += of/
138 obj-$(CONFIG_SSB) += ssb/
139 obj-$(CONFIG_BCMA) += bcma/
140 obj-$(CONFIG_VHOST_RING) += vhost/
141 obj-$(CONFIG_VHOST) += vhost/
142 obj-$(CONFIG_VLYNQ) += vlynq/
143 obj-$(CONFIG_STAGING) += staging/
144 obj-y += platform/
145 #common clk code
146 obj-y += clk/
148 obj-$(CONFIG_MAILBOX) += mailbox/
149 obj-$(CONFIG_HWSPINLOCK) += hwspinlock/
150 obj-$(CONFIG_REMOTEPROC) += remoteproc/
151 obj-$(CONFIG_RPMSG) += rpmsg/
153 # Virtualization drivers
154 obj-$(CONFIG_VIRT_DRIVERS) += virt/
155 obj-$(CONFIG_HYPERV) += hv/
157 obj-$(CONFIG_PM_DEVFREQ) += devfreq/
158 obj-$(CONFIG_EXTCON) += extcon/
159 obj-$(CONFIG_MEMORY) += memory/
160 obj-$(CONFIG_IIO) += iio/
161 obj-$(CONFIG_VME_BUS) += vme/
162 obj-$(CONFIG_IPACK_BUS) += ipack/
163 obj-$(CONFIG_NTB) += ntb/
164 obj-$(CONFIG_FMC) += fmc/
165 obj-$(CONFIG_POWERCAP) += powercap/
166 obj-$(CONFIG_MCB) += mcb/
167 obj-$(CONFIG_PERF_EVENTS) += perf/
168 obj-$(CONFIG_RAS) += ras/
169 obj-$(CONFIG_THUNDERBOLT) += thunderbolt/
170 obj-$(CONFIG_CORESIGHT) += hwtracing/coresight/
171 obj-y += hwtracing/intel_th/
172 obj-$(CONFIG_STM) += hwtracing/stm/
173 obj-$(CONFIG_ANDROID) += android/
174 obj-$(CONFIG_NVMEM) += nvmem/
175 obj-$(CONFIG_FPGA) += fpga/