btrfs: migrate the block group ref counting stuff
[linux/fpc-iii.git] / include / scsi / fc / fc_fcp.h
blob4b968448f4248ed34b799e22ccbbe45ec0c1e697
1 /* SPDX-License-Identifier: GPL-2.0-only */
2 /*
3 * Copyright(c) 2007 Intel Corporation. All rights reserved.
5 * Maintained at www.Open-FCoE.org
6 */
8 #ifndef _FC_FCP_H_
9 #define _FC_FCP_H_
11 #include <scsi/scsi.h>
14 * Fibre Channel Protocol for SCSI.
15 * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
19 * fc/fs.h defines FC_TYPE_FCP.
23 * Service parameter page parameters (word 3 bits) for Process Login.
25 #define FCP_SPPF_TASK_RETRY_ID 0x0200 /* task retry ID requested */
26 #define FCP_SPPF_RETRY 0x0100 /* retry supported */
27 #define FCP_SPPF_CONF_COMPL 0x0080 /* confirmed completion allowed */
28 #define FCP_SPPF_OVLY_ALLOW 0x0040 /* data overlay allowed */
29 #define FCP_SPPF_INIT_FCN 0x0020 /* initiator function */
30 #define FCP_SPPF_TARG_FCN 0x0010 /* target function */
31 #define FCP_SPPF_RD_XRDY_DIS 0x0002 /* disable XFER_RDY for reads */
32 #define FCP_SPPF_WR_XRDY_DIS 0x0001 /* disable XFER_RDY for writes */
35 * FCP_CMND IU Payload.
37 struct fcp_cmnd {
38 struct scsi_lun fc_lun; /* logical unit number */
39 __u8 fc_cmdref; /* command reference number */
40 __u8 fc_pri_ta; /* priority and task attribute */
41 __u8 fc_tm_flags; /* task management flags */
42 __u8 fc_flags; /* additional len & flags */
43 __u8 fc_cdb[16]; /* base CDB */
44 __be32 fc_dl; /* data length (must follow fc_cdb) */
47 #define FCP_CMND_LEN 32 /* expected length of structure */
49 struct fcp_cmnd32 {
50 struct scsi_lun fc_lun; /* logical unit number */
51 __u8 fc_cmdref; /* command reference number */
52 __u8 fc_pri_ta; /* priority and task attribute */
53 __u8 fc_tm_flags; /* task management flags */
54 __u8 fc_flags; /* additional len & flags */
55 __u8 fc_cdb[32]; /* base CDB */
56 __be32 fc_dl; /* data length (must follow fc_cdb) */
59 #define FCP_CMND32_LEN 48 /* expected length of structure */
60 #define FCP_CMND32_ADD_LEN (16 / 4) /* Additional cdb length */
63 * fc_pri_ta.
65 #define FCP_PTA_SIMPLE 0 /* simple task attribute */
66 #define FCP_PTA_HEADQ 1 /* head of queue task attribute */
67 #define FCP_PTA_ORDERED 2 /* ordered task attribute */
68 #define FCP_PTA_ACA 4 /* auto. contingent allegiance */
69 #define FCP_PTA_MASK 7 /* mask for task attribute field */
70 #define FCP_PRI_SHIFT 3 /* priority field starts in bit 3 */
71 #define FCP_PRI_RESVD_MASK 0x80 /* reserved bits in priority field */
74 * fc_tm_flags - task management flags field.
76 #define FCP_TMF_CLR_ACA 0x40 /* clear ACA condition */
77 #define FCP_TMF_TGT_RESET 0x20 /* target reset task management,
78 deprecated as of FCP-3 */
79 #define FCP_TMF_LUN_RESET 0x10 /* logical unit reset task management */
80 #define FCP_TMF_CLR_TASK_SET 0x04 /* clear task set */
81 #define FCP_TMF_ABT_TASK_SET 0x02 /* abort task set */
84 * fc_flags.
85 * Bits 7:2 are the additional FCP_CDB length / 4.
87 #define FCP_CFL_LEN_MASK 0xfc /* mask for additional length */
88 #define FCP_CFL_LEN_SHIFT 2 /* shift bits for additional length */
89 #define FCP_CFL_RDDATA 0x02 /* read data */
90 #define FCP_CFL_WRDATA 0x01 /* write data */
93 * FCP_TXRDY IU - transfer ready payload.
95 struct fcp_txrdy {
96 __be32 ft_data_ro; /* data relative offset */
97 __be32 ft_burst_len; /* burst length */
98 __u8 _ft_resvd[4]; /* reserved */
101 #define FCP_TXRDY_LEN 12 /* expected length of structure */
104 * FCP_RESP IU - response payload.
106 * The response payload comes in three parts: the flags/status, the
107 * sense/response lengths and the sense data/response info section.
109 * From FCP3r04, note 6 of section 9.5.13:
111 * Some early implementations presented the FCP_RSP IU without the FCP_RESID,
112 * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
113 * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
114 * non-standard behavior should be tolerated.
116 * All response frames will always contain the fcp_resp template. Some
117 * will also include the fcp_resp_len template.
119 * From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both
120 * are valid length.
122 struct fcp_resp {
123 __u8 _fr_resvd[8]; /* reserved */
124 __be16 fr_retry_delay; /* retry delay timer */
125 __u8 fr_flags; /* flags */
126 __u8 fr_status; /* SCSI status code */
129 #define FCP_RESP_LEN 12 /* expected length of structure */
131 struct fcp_resp_ext {
132 __be32 fr_resid; /* Residual value */
133 __be32 fr_sns_len; /* SCSI Sense length */
134 __be32 fr_rsp_len; /* Response Info length */
137 * Optionally followed by RSP info and/or SNS info and/or
138 * bidirectional read residual length, if any.
142 #define FCP_RESP_EXT_LEN 12 /* expected length of the structure */
144 struct fcp_resp_rsp_info {
145 __u8 _fr_resvd[3]; /* reserved */
146 __u8 rsp_code; /* Response Info Code */
147 __u8 _fr_resvd2[4]; /* reserved */
150 #define FCP_RESP_RSP_INFO_LEN4 4 /* without reserved field */
151 #define FCP_RESP_RSP_INFO_LEN8 8 /* with reserved field */
153 struct fcp_resp_with_ext {
154 struct fcp_resp resp;
155 struct fcp_resp_ext ext;
158 #define FCP_RESP_WITH_EXT (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
161 * fr_flags.
163 #define FCP_BIDI_RSP 0x80 /* bidirectional read response */
164 #define FCP_BIDI_READ_UNDER 0x40 /* bidir. read less than requested */
165 #define FCP_BIDI_READ_OVER 0x20 /* DL insufficient for full transfer */
166 #define FCP_CONF_REQ 0x10 /* confirmation requested */
167 #define FCP_RESID_UNDER 0x08 /* transfer shorter than expected */
168 #define FCP_RESID_OVER 0x04 /* DL insufficient for full transfer */
169 #define FCP_SNS_LEN_VAL 0x02 /* SNS_LEN field is valid */
170 #define FCP_RSP_LEN_VAL 0x01 /* RSP_LEN field is valid */
173 * rsp_codes
175 enum fcp_resp_rsp_codes {
176 FCP_TMF_CMPL = 0,
177 FCP_DATA_LEN_INVALID = 1,
178 FCP_CMND_FIELDS_INVALID = 2,
179 FCP_DATA_PARAM_MISMATCH = 3,
180 FCP_TMF_REJECTED = 4,
181 FCP_TMF_FAILED = 5,
182 FCP_TMF_INVALID_LUN = 9,
186 * FCP SRR Link Service request - Sequence Retransmission Request.
188 struct fcp_srr {
189 __u8 srr_op; /* opcode ELS_SRR */
190 __u8 srr_resvd[3]; /* opcode / reserved - must be zero */
191 __be16 srr_ox_id; /* OX_ID of failed command */
192 __be16 srr_rx_id; /* RX_ID of failed command */
193 __be32 srr_rel_off; /* relative offset */
194 __u8 srr_r_ctl; /* r_ctl for the information unit */
195 __u8 srr_resvd2[3]; /* reserved */
199 * Feature bits in name server FC-4 Features object.
201 #define FCP_FEAT_TARG (1 << 0) /* target function supported */
202 #define FCP_FEAT_INIT (1 << 1) /* initiator function supported */
204 #endif /* _FC_FCP_H_ */