drivers/scsi/st.h

   1
   2 #ifndef _ST_H
   3 #define _ST_H
   4
   5 #include <linux/completion.h>
   6 #include <linux/mutex.h>
   7 #include <linux/kref.h>
   8 #include <scsi/scsi_cmnd.h>
   9
  10 /* Descriptor for analyzed sense data */
  11 struct st_cmdstatus {
  12         int midlevel_result;
  13         struct scsi_sense_hdr sense_hdr;
  14         int have_sense;
  15         int residual;
  16         u64 uremainder64;
  17         u8 flags;
  18         u8 remainder_valid;
  19         u8 fixed_format;
  20         u8 deferred;
  21 };
  22
  23 struct scsi_tape;
  24
  25 /* scsi tape command */
  26 struct st_request {
  27         unsigned char cmd[MAX_COMMAND_SIZE];
  28         unsigned char sense[SCSI_SENSE_BUFFERSIZE];
  29         int result;
  30         struct scsi_tape *stp;
  31         struct completion *waiting;
  32         struct bio *bio;
  33 };
  34
  35 /* The tape buffer descriptor. */
  36 struct st_buffer {
  37         unsigned char dma;      /* DMA-able buffer */
  38         unsigned char cleared;  /* internal buffer cleared after open? */
  39         unsigned short do_dio;  /* direct i/o set up? */
  40         int buffer_size;
  41         int buffer_blocks;
  42         int buffer_bytes;
  43         int read_pointer;
  44         int writing;
  45         int syscall_result;
  46         struct st_request *last_SRpnt;
  47         struct st_cmdstatus cmdstat;
  48         struct page **reserved_pages;
  49         int reserved_page_order;
  50         struct page **mapped_pages;
  51         struct rq_map_data map_data;
  52         unsigned char *b_data;
  53         unsigned short use_sg;  /* zero or max number of s/g segments for this adapter */
  54         unsigned short sg_segs;         /* number of segments in s/g list */
  55         unsigned short frp_segs;        /* number of buffer segments */
  56 };
  57
  58 /* The tape mode definition */
  59 struct st_modedef {
  60         unsigned char defined;
  61         unsigned char sysv;     /* SYS V semantics? */
  62         unsigned char do_async_writes;
  63         unsigned char do_buffer_writes;
  64         unsigned char do_read_ahead;
  65         unsigned char defaults_for_writes;
  66         unsigned char default_compression;      /* 0 = don't touch, etc */
  67         short default_density;  /* Forced density, -1 = no value */
  68         int default_blksize;    /* Forced blocksize, -1 = no value */
  69         struct scsi_tape *tape;
  70         struct device *devs[2];  /* Auto-rewind and non-rewind devices */
  71         struct cdev *cdevs[2];  /* Auto-rewind and non-rewind devices */
  72 };
  73
  74 /* Number of modes can be changed by changing ST_NBR_MODE_BITS. The maximum
  75    number of modes is 16 (ST_NBR_MODE_BITS 4) */
  76 #define ST_NBR_MODE_BITS 2
  77 #define ST_NBR_MODES (1 << ST_NBR_MODE_BITS)
  78 #define ST_MODE_SHIFT (7 - ST_NBR_MODE_BITS)
  79 #define ST_MODE_MASK ((ST_NBR_MODES - 1) << ST_MODE_SHIFT)
  80
  81 #define ST_MAX_TAPES (1 << (20 - (ST_NBR_MODE_BITS + 1)))
  82 #define ST_MAX_TAPE_ENTRIES  (ST_MAX_TAPES << (ST_NBR_MODE_BITS + 1))
  83
  84 /* The status related to each partition */
  85 struct st_partstat {
  86         unsigned char rw;
  87         unsigned char eof;
  88         unsigned char at_sm;
  89         unsigned char last_block_valid;
  90         u32 last_block_visited;
  91         int drv_block;          /* The block where the drive head is */
  92         int drv_file;
  93 };
  94
  95 #define ST_NBR_PARTITIONS 4
  96
  97 /* The tape drive descriptor */
  98 struct scsi_tape {
  99         struct scsi_driver *driver;
 100         struct scsi_device *device;
 101         struct mutex lock;      /* For serialization */
 102         struct completion wait; /* For SCSI commands */
 103         struct st_buffer *buffer;
 104         int index;
 105
 106         /* Drive characteristics */
 107         unsigned char omit_blklims;
 108         unsigned char do_auto_lock;
 109         unsigned char can_bsr;
 110         unsigned char can_partitions;
 111         unsigned char two_fm;
 112         unsigned char fast_mteom;
 113         unsigned char immediate;
 114         unsigned char restr_dma;
 115         unsigned char scsi2_logical;
 116         unsigned char default_drvbuffer;        /* 0xff = don't touch, value 3 bits */
 117         unsigned char cln_mode;                 /* 0 = none, otherwise sense byte nbr */
 118         unsigned char cln_sense_value;
 119         unsigned char cln_sense_mask;
 120         unsigned char use_pf;                   /* Set Page Format bit in all mode selects? */
 121         unsigned char try_dio;                  /* try direct i/o in general? */
 122         unsigned char try_dio_now;              /* try direct i/o before next close? */
 123         unsigned char c_algo;                   /* compression algorithm */
 124         unsigned char pos_unknown;                      /* after reset position unknown */
 125         unsigned char sili;                     /* use SILI when reading in variable b mode */
 126         unsigned char immediate_filemark;       /* write filemark immediately */
 127         int tape_type;
 128         int long_timeout;       /* timeout for commands known to take long time */
 129
 130         unsigned long max_pfn;  /* the maximum page number reachable by the HBA */
 131
 132         /* Mode characteristics */
 133         struct st_modedef modes[ST_NBR_MODES];
 134         int current_mode;
 135
 136         /* Status variables */
 137         int partition;
 138         int new_partition;
 139         int nbr_partitions;     /* zero until partition support enabled */
 140         struct st_partstat ps[ST_NBR_PARTITIONS];
 141         unsigned char dirty;
 142         unsigned char ready;
 143         unsigned char write_prot;
 144         unsigned char drv_write_prot;
 145         unsigned char in_use;
 146         unsigned char blksize_changed;
 147         unsigned char density_changed;
 148         unsigned char compression_changed;
 149         unsigned char drv_buffer;
 150         unsigned char density;
 151         unsigned char door_locked;
 152         unsigned char autorew_dev;   /* auto-rewind device */
 153         unsigned char rew_at_close;  /* rewind necessary at close */
 154         unsigned char inited;
 155         unsigned char cleaning_req;  /* cleaning requested? */
 156         int block_size;
 157         int min_block;
 158         int max_block;
 159         int recover_count;     /* From tape opening */
 160         int recover_reg;       /* From last status call */
 161
 162 #if DEBUG
 163         unsigned char write_pending;
 164         int nbr_finished;
 165         int nbr_waits;
 166         int nbr_requests;
 167         int nbr_dio;
 168         int nbr_pages;
 169         unsigned char last_cmnd[6];
 170         unsigned char last_sense[16];
 171 #endif
 172         struct gendisk *disk;
 173         struct kref     kref;
 174 };
 175
 176 /* Bit masks for use_pf */
 177 #define USE_PF      1
 178 #define PF_TESTED   2
 179
 180 /* Values of eof */
 181 #define ST_NOEOF        0
 182 #define ST_FM_HIT       1
 183 #define ST_FM           2
 184 #define ST_EOM_OK       3
 185 #define ST_EOM_ERROR    4
 186 #define ST_EOD_1        5
 187 #define ST_EOD_2        6
 188 #define ST_EOD          7
 189 /* EOD hit while reading => ST_EOD_1 => return zero => ST_EOD_2 =>
 190    return zero => ST_EOD, return ENOSPC */
 191 /* When writing: ST_EOM_OK == early warning found, write OK
 192                  ST_EOD_1  == allow trying new write after early warning
 193                  ST_EOM_ERROR == early warning found, not able to write all */
 194
 195 /* Values of rw */
 196 #define ST_IDLE         0
 197 #define ST_READING      1
 198 #define ST_WRITING      2
 199
 200 /* Values of ready state */
 201 #define ST_READY        0
 202 #define ST_NOT_READY    1
 203 #define ST_NO_TAPE      2
 204
 205 /* Values for door lock state */
 206 #define ST_UNLOCKED     0
 207 #define ST_LOCKED_EXPLICIT 1
 208 #define ST_LOCKED_AUTO  2
 209 #define ST_LOCK_FAILS   3
 210
 211 /* Positioning SCSI-commands for Tandberg, etc. drives */
 212 #define QFA_REQUEST_BLOCK       0x02
 213 #define QFA_SEEK_BLOCK          0x0c
 214
 215 /* Setting the binary options */
 216 #define ST_DONT_TOUCH  0
 217 #define ST_NO          1
 218 #define ST_YES         2
 219
 220 #define EXTENDED_SENSE_START  18
 221
 222 /* Masks for some conditions in the sense data */
 223 #define SENSE_FMK   0x80
 224 #define SENSE_EOM   0x40
 225 #define SENSE_ILI   0x20
 226
 227 #endif