Documentation/devicetree/bindings/media/i2c/sony,imx214.txt

   1 * Sony 1/3.06-Inch 13.13Mp CMOS Digital Image Sensor
   2
   3 The Sony imx214 is a 1/3.06-inch CMOS active pixel digital image sensor with
   4 an active array size of 4224H x 3200V. It is programmable through an I2C
   5 interface.
   6 Image data is sent through MIPI CSI-2, through 2 or 4 lanes at a maximum
   7 throughput of 1.2Gbps/lane.
   8
   9
  10 Required Properties:
  11 - compatible: Shall be "sony,imx214".
  12 - reg: I2C bus address of the device. Depending on how the sensor is wired,
  13        it shall be <0x10> or <0x1a>;
  14 - enable-gpios: GPIO descriptor for the enable pin.
  15 - vdddo-supply: Chip digital IO regulator (1.8V).
  16 - vdda-supply: Chip analog regulator (2.7V).
  17 - vddd-supply: Chip digital core regulator (1.12V).
  18 - clocks: Reference to the xclk clock.
  19 - clock-frequency: Frequency of the xclk clock.
  20
  21 Optional Properties:
  22 - flash-leds: See ../video-interfaces.txt
  23 - lens-focus: See ../video-interfaces.txt
  24
  25 The imx214 device node shall contain one 'port' child node with
  26 an 'endpoint' subnode. For further reading on port node refer to
  27 Documentation/devicetree/bindings/media/video-interfaces.txt.
  28
  29 Required Properties on endpoint:
  30 - data-lanes: check ../video-interfaces.txt
  31 - link-frequencies: check ../video-interfaces.txt
  32 - remote-endpoint: check ../video-interfaces.txt
  33
  34 Example:
  35
  36         camera-sensor@1a {
  37                 compatible = "sony,imx214";
  38                 reg = <0x1a>;
  39                 vdddo-supply = <&pm8994_lvs1>;
  40                 vddd-supply = <&camera_vddd_1v12>;
  41                 vdda-supply = <&pm8994_l17>;
  42                 lens-focus = <&ad5820>;
  43                 enable-gpios = <&msmgpio 25 GPIO_ACTIVE_HIGH>;
  44                 clocks = <&mmcc CAMSS_MCLK0_CLK>;
  45                 clock-frequency = <24000000>;
  46                 port {
  47                         imx214_ep: endpoint {
  48                                 data-lanes = <1 2 3 4>;
  49                                 link-frequencies = /bits/ 64 <480000000>;
  50                                 remote-endpoint = <&csiphy0_ep>;
  51                         };
  52                 };
  53         };