treewide: remove redundant IS_ERR() before error code check
[linux/fpc-iii.git] / arch / arm64 / boot / dts / qcom / pm8916.dtsi
blob9dd2df1cbf47d7d19271c736eb319e6168819044
1 // SPDX-License-Identifier: GPL-2.0
2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
3 #include <dt-bindings/interrupt-controller/irq.h>
4 #include <dt-bindings/input/linux-event-codes.h>
5 #include <dt-bindings/spmi/spmi.h>
7 &spmi_bus {
9         pm8916_0: pm8916@0 {
10                 compatible = "qcom,pm8916", "qcom,spmi-pmic";
11                 reg = <0x0 SPMI_USID>;
12                 #address-cells = <1>;
13                 #size-cells = <0>;
15                 rtc@6000 {
16                         compatible = "qcom,pm8941-rtc";
17                         reg = <0x6000>;
18                         reg-names = "rtc", "alarm";
19                         interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
20                 };
22                 pon@800 {
23                         compatible = "qcom,pm8916-pon";
24                         reg = <0x800>;
25                         mode-bootloader = <0x2>;
26                         mode-recovery = <0x1>;
28                         pwrkey {
29                                 compatible = "qcom,pm8941-pwrkey";
30                                 interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
31                                 debounce = <15625>;
32                                 bias-pull-up;
33                                 linux,code = <KEY_POWER>;
34                         };
36                         watchdog {
37                                 compatible = "qcom,pm8916-wdt";
38                                 interrupts = <0x0 0x8 6 IRQ_TYPE_EDGE_RISING>;
39                                 timeout-sec = <60>;
40                         };
41                 };
43                 pm8916_gpios: gpios@c000 {
44                         compatible = "qcom,pm8916-gpio";
45                         reg = <0xc000>;
46                         gpio-controller;
47                         #gpio-cells = <2>;
48                         interrupts = <0 0xc0 0 IRQ_TYPE_NONE>,
49                                      <0 0xc1 0 IRQ_TYPE_NONE>,
50                                      <0 0xc2 0 IRQ_TYPE_NONE>,
51                                      <0 0xc3 0 IRQ_TYPE_NONE>;
52                 };
54                 pm8916_mpps: mpps@a000 {
55                         compatible = "qcom,pm8916-mpp";
56                         reg = <0xa000>;
57                         gpio-controller;
58                         #gpio-cells = <2>;
59                         interrupts = <0 0xa0 0 IRQ_TYPE_NONE>,
60                                      <0 0xa1 0 IRQ_TYPE_NONE>,
61                                      <0 0xa2 0 IRQ_TYPE_NONE>,
62                                      <0 0xa3 0 IRQ_TYPE_NONE>;
63                 };
65                 pm8916_temp: temp-alarm@2400 {
66                         compatible = "qcom,spmi-temp-alarm";
67                         reg = <0x2400>;
68                         interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
69                         io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
70                         io-channel-names = "thermal";
71                         #thermal-sensor-cells = <0>;
72                 };
74                 pm8916_vadc: vadc@3100 {
75                         compatible = "qcom,spmi-vadc";
76                         reg = <0x3100>;
77                         interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
78                         #address-cells = <1>;
79                         #size-cells = <0>;
80                         #io-channel-cells = <1>;
82                         usb_in {
83                                 reg = <VADC_USBIN>;
84                                 qcom,pre-scaling = <1 10>;
85                         };
86                         vph_pwr {
87                                 reg = <VADC_VSYS>;
88                                 qcom,pre-scaling = <1 3>;
89                         };
90                         die_temp {
91                                 reg = <VADC_DIE_TEMP>;
92                         };
93                         ref_625mv {
94                                 reg = <VADC_REF_625MV>;
95                         };
96                         ref_1250v {
97                                 reg = <VADC_REF_1250MV>;
98                         };
99                         ref_gnd {
100                                 reg = <VADC_GND_REF>;
101                         };
102                         ref_vdd {
103                                 reg = <VADC_VDD_VADC>;
104                         };
105                 };
106         };
108         pm8916_1: pm8916@1 {
109                 compatible = "qcom,pm8916", "qcom,spmi-pmic";
110                 reg = <0x1 SPMI_USID>;
111                 #address-cells = <1>;
112                 #size-cells = <0>;
114                 wcd_codec: codec@f000 {
115                         compatible = "qcom,pm8916-wcd-analog-codec";
116                         reg = <0xf000 0x200>;
117                         reg-names = "pmic-codec-core";
118                         clocks = <&gcc GCC_CODEC_DIGCODEC_CLK>;
119                         clock-names = "mclk";
120                         interrupt-parent = <&spmi_bus>;
121                         interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>,
122                                      <0x1 0xf0 0x1 IRQ_TYPE_NONE>,
123                                      <0x1 0xf0 0x2 IRQ_TYPE_NONE>,
124                                      <0x1 0xf0 0x3 IRQ_TYPE_NONE>,
125                                      <0x1 0xf0 0x4 IRQ_TYPE_NONE>,
126                                      <0x1 0xf0 0x5 IRQ_TYPE_NONE>,
127                                      <0x1 0xf0 0x6 IRQ_TYPE_NONE>,
128                                      <0x1 0xf0 0x7 IRQ_TYPE_NONE>,
129                                      <0x1 0xf1 0x0 IRQ_TYPE_NONE>,
130                                      <0x1 0xf1 0x1 IRQ_TYPE_NONE>,
131                                      <0x1 0xf1 0x2 IRQ_TYPE_NONE>,
132                                      <0x1 0xf1 0x3 IRQ_TYPE_NONE>,
133                                      <0x1 0xf1 0x4 IRQ_TYPE_NONE>,
134                                      <0x1 0xf1 0x5 IRQ_TYPE_NONE>;
135                         interrupt-names = "cdc_spk_cnp_int",
136                                           "cdc_spk_clip_int",
137                                           "cdc_spk_ocp_int",
138                                           "mbhc_ins_rem_det1",
139                                           "mbhc_but_rel_det",
140                                           "mbhc_but_press_det",
141                                           "mbhc_ins_rem_det",
142                                           "mbhc_switch_int",
143                                           "cdc_ear_ocp_int",
144                                           "cdc_hphr_ocp_int",
145                                           "cdc_hphl_ocp_det",
146                                           "cdc_ear_cnp_int",
147                                           "cdc_hphr_cnp_int",
148                                           "cdc_hphl_cnp_int";
149                         vdd-cdc-io-supply = <&pm8916_l5>;
150                         vdd-cdc-tx-rx-cx-supply = <&pm8916_l5>;
151                         vdd-micbias-supply = <&pm8916_l13>;
152                         #sound-dai-cells = <1>;
153                 };
154         };