arch/mips/boot/dts/qca/ar9331_dpt_module.dts

   1 // SPDX-License-Identifier: GPL-2.0
   2 /dts-v1/;
   3
   4 #include <dt-bindings/gpio/gpio.h>
   5 #include <dt-bindings/input/input.h>
   6
   7 #include "ar9331.dtsi"
   8
   9 / {
  10         model = "DPTechnics DPT-Module";
  11         compatible = "dptechnics,dpt-module";
  12
  13         aliases {
  14                 serial0 = &uart;
  15         };
  16
  17         memory@0 {
  18                 device_type = "memory";
  19                 reg = <0x0 0x4000000>;
  20         };
  21
  22         leds {
  23                 compatible = "gpio-leds";
  24
  25                 system {
  26                         label = "dpt-module:green:system";
  27                         gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
  28                         default-state = "off";
  29                 };
  30         };
  31
  32         gpio-keys {
  33                 compatible = "gpio-keys";
  34                 #address-cells = <1>;
  35                 #size-cells = <0>;
  36
  37                 button@0 {
  38                         label = "reset";
  39                         linux,code = <KEY_RESTART>;
  40                         gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
  41                 };
  42         };
  43 };
  44
  45 &ref {
  46         clock-frequency = <25000000>;
  47 };
  48
  49 &uart {
  50         status = "okay";
  51 };
  52
  53 &gpio {
  54         status = "okay";
  55 };
  56
  57 &usb {
  58         dr_mode = "host";
  59         status = "okay";
  60 };
  61
  62 &usb_phy {
  63         status = "okay";
  64 };
  65
  66 &spi {
  67         num-chipselects = <1>;
  68         status = "okay";
  69
  70         /* Winbond 25Q128FVSG SPI flash */
  71         spiflash: w25q128@0 {
  72                 #address-cells = <1>;
  73                 #size-cells = <1>;
  74                 compatible = "winbond,w25q128", "jedec,spi-nor";
  75                 spi-max-frequency = <104000000>;
  76                 reg = <0>;
  77         };
  78 };
  79
  80 &eth0 {
  81         status = "okay";
  82 };
  83
  84 &eth1 {
  85         status = "okay";
  86 };
  87
  88 &switch_port1 {
  89         label = "lan0";
  90         status = "okay";
  91 };
  92
  93 &phy_port0 {
  94         status = "okay";
  95 };
  96
  97 &phy_port4 {
  98         status = "okay";
  99 };