1 // SPDX-License-Identifier: GPL-2.0-only
2 /* hplance.c : the Linux/hp300/lance ethernet driver
4 * Copyright (C) 05/1998 Peter Maydell <pmaydell@chiark.greenend.org.uk>
5 * Based on the Sun Lance driver and the NetBSD HP Lance driver
6 * Uses the generic 7990.c LANCE code.
9 #include <linux/module.h>
10 #include <linux/kernel.h>
11 #include <linux/types.h>
12 #include <linux/interrupt.h>
13 #include <linux/ioport.h>
14 #include <linux/string.h>
15 #include <linux/delay.h>
16 #include <linux/init.h>
17 #include <linux/errno.h>
18 /* Used for the temporal inet entries and routing */
19 #include <linux/socket.h>
20 #include <linux/route.h>
21 #include <linux/dio.h>
22 #include <linux/netdevice.h>
23 #include <linux/etherdevice.h>
24 #include <linux/skbuff.h>
27 #include <asm/pgtable.h>
31 /* We have 16392 bytes of RAM for the init block and buffers. This places
32 * an upper limit on the number of buffers we can use. NetBSD uses 8 Rx
33 * buffers and 2 Tx buffers, it takes (8 + 2) * 1544 bytes.
35 #define LANCE_LOG_TX_BUFFERS 1
36 #define LANCE_LOG_RX_BUFFERS 3
38 #include "7990.h" /* use generic LANCE code */
40 /* Our private data structure */
41 struct hplance_private
{
42 struct lance_private lance
;
45 /* function prototypes... This is easy because all the grot is in the
46 * generic LANCE support. All we have to support is probing for boards,
47 * plus board-specific init, open and close actions.
48 * Oh, and we need to tell the generic code how to read and write LANCE registers...
50 static int hplance_init_one(struct dio_dev
*d
, const struct dio_device_id
*ent
);
51 static void hplance_init(struct net_device
*dev
, struct dio_dev
*d
);
52 static void hplance_remove_one(struct dio_dev
*d
);
53 static void hplance_writerap(void *priv
, unsigned short value
);
54 static void hplance_writerdp(void *priv
, unsigned short value
);
55 static unsigned short hplance_readrdp(void *priv
);
56 static int hplance_open(struct net_device
*dev
);
57 static int hplance_close(struct net_device
*dev
);
59 static struct dio_device_id hplance_dio_tbl
[] = {
64 static struct dio_driver hplance_driver
= {
66 .id_table
= hplance_dio_tbl
,
67 .probe
= hplance_init_one
,
68 .remove
= hplance_remove_one
,
71 static const struct net_device_ops hplance_netdev_ops
= {
72 .ndo_open
= hplance_open
,
73 .ndo_stop
= hplance_close
,
74 .ndo_start_xmit
= lance_start_xmit
,
75 .ndo_set_rx_mode
= lance_set_multicast
,
76 .ndo_validate_addr
= eth_validate_addr
,
77 .ndo_set_mac_address
= eth_mac_addr
,
78 #ifdef CONFIG_NET_POLL_CONTROLLER
79 .ndo_poll_controller
= lance_poll
,
83 /* Find all the HP Lance boards and initialise them... */
84 static int hplance_init_one(struct dio_dev
*d
, const struct dio_device_id
*ent
)
86 struct net_device
*dev
;
89 dev
= alloc_etherdev(sizeof(struct hplance_private
));
94 if (!request_mem_region(dio_resource_start(d
),
95 dio_resource_len(d
), d
->name
))
99 err
= register_netdev(dev
);
101 goto out_release_mem_region
;
103 dio_set_drvdata(d
, dev
);
105 printk(KERN_INFO
"%s: %s; select code %d, addr %pM, irq %d\n",
106 dev
->name
, d
->name
, d
->scode
, dev
->dev_addr
, d
->ipl
);
110 out_release_mem_region
:
111 release_mem_region(dio_resource_start(d
), dio_resource_len(d
));
118 static void hplance_remove_one(struct dio_dev
*d
)
120 struct net_device
*dev
= dio_get_drvdata(d
);
122 unregister_netdev(dev
);
123 release_mem_region(dio_resource_start(d
), dio_resource_len(d
));
127 /* Initialise a single lance board at the given DIO device */
128 static void hplance_init(struct net_device
*dev
, struct dio_dev
*d
)
130 unsigned long va
= (d
->resource
.start
+ DIO_VIRADDRBASE
);
131 struct hplance_private
*lp
;
134 /* reset the board */
135 out_8(va
+ DIO_IDOFF
, 0xff);
136 udelay(100); /* ariba! ariba! udelay! udelay! */
138 /* Fill the dev fields */
140 dev
->netdev_ops
= &hplance_netdev_ops
;
143 for (i
= 0; i
< 6; i
++) {
144 /* The NVRAM holds our ethernet address, one nibble per byte,
145 * at bytes NVRAMOFF+1,3,5,7,9...
147 dev
->dev_addr
[i
] = ((in_8(va
+ HPLANCE_NVRAMOFF
+ i
*4 + 1) & 0xF) << 4)
148 | (in_8(va
+ HPLANCE_NVRAMOFF
+ i
*4 + 3) & 0xF);
151 lp
= netdev_priv(dev
);
152 lp
->lance
.name
= d
->name
;
154 lp
->lance
.init_block
= (struct lance_init_block
*)(va
+ HPLANCE_MEMOFF
); /* CPU addr */
155 lp
->lance
.lance_init_block
= NULL
; /* LANCE addr of same RAM */
156 lp
->lance
.busmaster_regval
= LE_C3_BSWP
; /* we're bigendian */
157 lp
->lance
.irq
= d
->ipl
;
158 lp
->lance
.writerap
= hplance_writerap
;
159 lp
->lance
.writerdp
= hplance_writerdp
;
160 lp
->lance
.readrdp
= hplance_readrdp
;
161 lp
->lance
.lance_log_rx_bufs
= LANCE_LOG_RX_BUFFERS
;
162 lp
->lance
.lance_log_tx_bufs
= LANCE_LOG_TX_BUFFERS
;
163 lp
->lance
.rx_ring_mod_mask
= RX_RING_MOD_MASK
;
164 lp
->lance
.tx_ring_mod_mask
= TX_RING_MOD_MASK
;
167 /* This is disgusting. We have to check the DIO status register for ack every
168 * time we read or write the LANCE registers.
170 static void hplance_writerap(void *priv
, unsigned short value
)
172 struct lance_private
*lp
= (struct lance_private
*)priv
;
174 out_be16(lp
->base
+ HPLANCE_REGOFF
+ LANCE_RAP
, value
);
175 } while ((in_8(lp
->base
+ HPLANCE_STATUS
) & LE_ACK
) == 0);
178 static void hplance_writerdp(void *priv
, unsigned short value
)
180 struct lance_private
*lp
= (struct lance_private
*)priv
;
182 out_be16(lp
->base
+ HPLANCE_REGOFF
+ LANCE_RDP
, value
);
183 } while ((in_8(lp
->base
+ HPLANCE_STATUS
) & LE_ACK
) == 0);
186 static unsigned short hplance_readrdp(void *priv
)
188 struct lance_private
*lp
= (struct lance_private
*)priv
;
191 value
= in_be16(lp
->base
+ HPLANCE_REGOFF
+ LANCE_RDP
);
192 } while ((in_8(lp
->base
+ HPLANCE_STATUS
) & LE_ACK
) == 0);
196 static int hplance_open(struct net_device
*dev
)
199 struct lance_private
*lp
= netdev_priv(dev
);
201 status
= lance_open(dev
); /* call generic lance open code */
204 /* enable interrupts at board level. */
205 out_8(lp
->base
+ HPLANCE_STATUS
, LE_IE
);
210 static int hplance_close(struct net_device
*dev
)
212 struct lance_private
*lp
= netdev_priv(dev
);
214 out_8(lp
->base
+ HPLANCE_STATUS
, 0); /* disable interrupts at boardlevel */
219 static int __init
hplance_init_module(void)
221 return dio_register_driver(&hplance_driver
);
224 static void __exit
hplance_cleanup_module(void)
226 dio_unregister_driver(&hplance_driver
);
229 module_init(hplance_init_module
);
230 module_exit(hplance_cleanup_module
);
232 MODULE_LICENSE("GPL");