drivers/net/phy/bcm-cygnus.c

   1 // SPDX-License-Identifier: GPL-2.0
   2 /*
   3  * Copyright (C) 2015 Broadcom Corporation
   4  */
   5
   6 /* Broadcom Cygnus SoC internal transceivers support. */
   7 #include "bcm-phy-lib.h"
   8 #include <linux/brcmphy.h>
   9 #include <linux/module.h>
  10 #include <linux/netdevice.h>
  11 #include <linux/phy.h>
  12
  13 struct bcm_omega_phy_priv {
  14         u64     *stats;
  15 };
  16
  17 /* Broadcom Cygnus Phy specific registers */
  18 #define MII_BCM_CYGNUS_AFE_VDAC_ICTRL_0  0x91E5 /* VDAL Control register */
  19
  20 static int bcm_cygnus_afe_config(struct phy_device *phydev)
  21 {
  22         int rc;
  23
  24         /* ensure smdspclk is enabled */
  25         rc = phy_write(phydev, MII_BCM54XX_AUX_CTL, 0x0c30);
  26         if (rc < 0)
  27                 return rc;
  28
  29         /* AFE_VDAC_ICTRL_0 bit 7:4 Iq=1100 for 1g 10bt, normal modes */
  30         rc = bcm_phy_write_misc(phydev, 0x39, 0x01, 0xA7C8);
  31         if (rc < 0)
  32                 return rc;
  33
  34         /* AFE_HPF_TRIM_OTHERS bit11=1, short cascode enable for all modes*/
  35         rc = bcm_phy_write_misc(phydev, 0x3A, 0x00, 0x0803);
  36         if (rc < 0)
  37                 return rc;
  38
  39         /* AFE_TX_CONFIG_1 bit 7:4 Iq=1100 for test modes */
  40         rc = bcm_phy_write_misc(phydev, 0x3A, 0x01, 0xA740);
  41         if (rc < 0)
  42                 return rc;
  43
  44         /* AFE TEMPSEN_OTHERS rcal_HT, rcal_LT 10000 */
  45         rc = bcm_phy_write_misc(phydev, 0x3A, 0x03, 0x8400);
  46         if (rc < 0)
  47                 return rc;
  48
  49         /* AFE_FUTURE_RSV bit 2:0 rccal <2:0>=100 */
  50         rc = bcm_phy_write_misc(phydev, 0x3B, 0x00, 0x0004);
  51         if (rc < 0)
  52                 return rc;
  53
  54         /* Adjust bias current trim to overcome digital offSet */
  55         rc = phy_write(phydev, MII_BRCM_CORE_BASE1E, 0x02);
  56         if (rc < 0)
  57                 return rc;
  58
  59         /* make rcal=100, since rdb default is 000 */
  60         rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB1, 0x10);
  61         if (rc < 0)
  62                 return rc;
  63
  64         /* CORE_EXPB0, Reset R_CAL/RC_CAL Engine */
  65         rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB0, 0x10);
  66         if (rc < 0)
  67                 return rc;
  68
  69         /* CORE_EXPB0, Disable Reset R_CAL/RC_CAL Engine */
  70         rc = bcm_phy_write_exp_sel(phydev, MII_BRCM_CORE_EXPB0, 0x00);
  71
  72         return 0;
  73 }
  74
  75 static int bcm_cygnus_config_init(struct phy_device *phydev)
  76 {
  77         int reg, rc;
  78
  79         reg = phy_read(phydev, MII_BCM54XX_ECR);
  80         if (reg < 0)
  81                 return reg;
  82
  83         /* Mask interrupts globally. */
  84         reg |= MII_BCM54XX_ECR_IM;
  85         rc = phy_write(phydev, MII_BCM54XX_ECR, reg);
  86         if (rc)
  87                 return rc;
  88
  89         /* Unmask events of interest */
  90         reg = ~(MII_BCM54XX_INT_DUPLEX |
  91                 MII_BCM54XX_INT_SPEED |
  92                 MII_BCM54XX_INT_LINK);
  93         rc = phy_write(phydev, MII_BCM54XX_IMR, reg);
  94         if (rc)
  95                 return rc;
  96
  97         /* Apply AFE settings for the PHY */
  98         rc = bcm_cygnus_afe_config(phydev);
  99         if (rc)
 100                 return rc;
 101
 102         /* Advertise EEE */
 103         rc = bcm_phy_set_eee(phydev, true);
 104         if (rc)
 105                 return rc;
 106
 107         /* Enable APD */
 108         return bcm_phy_enable_apd(phydev, false);
 109 }
 110
 111 static int bcm_cygnus_resume(struct phy_device *phydev)
 112 {
 113         int rc;
 114
 115         genphy_resume(phydev);
 116
 117         /* Re-initialize the PHY to apply AFE work-arounds and
 118          * configurations when coming out of suspend.
 119          */
 120         rc = bcm_cygnus_config_init(phydev);
 121         if (rc)
 122                 return rc;
 123
 124         /* restart auto negotiation with the new settings */
 125         return genphy_config_aneg(phydev);
 126 }
 127
 128 static int bcm_omega_config_init(struct phy_device *phydev)
 129 {
 130         u8 count, rev;
 131         int ret = 0;
 132
 133         rev = phydev->phy_id & ~phydev->drv->phy_id_mask;
 134
 135         pr_info_once("%s: %s PHY revision: 0x%02x\n",
 136                      phydev_name(phydev), phydev->drv->name, rev);
 137
 138         /* Dummy read to a register to workaround an issue upon reset where the
 139          * internal inverter may not allow the first MDIO transaction to pass
 140          * the MDIO management controller and make us return 0xffff for such
 141          * reads.
 142          */
 143         phy_read(phydev, MII_BMSR);
 144
 145         switch (rev) {
 146         case 0x00:
 147                 ret = bcm_phy_28nm_a0b0_afe_config_init(phydev);
 148                 break;
 149         default:
 150                 break;
 151         }
 152
 153         if (ret)
 154                 return ret;
 155
 156         ret = bcm_phy_downshift_get(phydev, &count);
 157         if (ret)
 158                 return ret;
 159
 160         /* Only enable EEE if Wirespeed/downshift is disabled */
 161         ret = bcm_phy_set_eee(phydev, count == DOWNSHIFT_DEV_DISABLE);
 162         if (ret)
 163                 return ret;
 164
 165         return bcm_phy_enable_apd(phydev, true);
 166 }
 167
 168 static int bcm_omega_resume(struct phy_device *phydev)
 169 {
 170         int ret;
 171
 172         /* Re-apply workarounds coming out suspend/resume */
 173         ret = bcm_omega_config_init(phydev);
 174         if (ret)
 175                 return ret;
 176
 177         /* 28nm Gigabit PHYs come out of reset without any half-duplex
 178          * or "hub" compliant advertised mode, fix that. This does not
 179          * cause any problems with the PHY library since genphy_config_aneg()
 180          * gracefully handles auto-negotiated and forced modes.
 181          */
 182         return genphy_config_aneg(phydev);
 183 }
 184
 185 static int bcm_omega_get_tunable(struct phy_device *phydev,
 186                                  struct ethtool_tunable *tuna, void *data)
 187 {
 188         switch (tuna->id) {
 189         case ETHTOOL_PHY_DOWNSHIFT:
 190                 return bcm_phy_downshift_get(phydev, (u8 *)data);
 191         default:
 192                 return -EOPNOTSUPP;
 193         }
 194 }
 195
 196 static int bcm_omega_set_tunable(struct phy_device *phydev,
 197                                  struct ethtool_tunable *tuna,
 198                                  const void *data)
 199 {
 200         u8 count = *(u8 *)data;
 201         int ret;
 202
 203         switch (tuna->id) {
 204         case ETHTOOL_PHY_DOWNSHIFT:
 205                 ret = bcm_phy_downshift_set(phydev, count);
 206                 break;
 207         default:
 208                 return -EOPNOTSUPP;
 209         }
 210
 211         if (ret)
 212                 return ret;
 213
 214         /* Disable EEE advertisement since this prevents the PHY
 215          * from successfully linking up, trigger auto-negotiation restart
 216          * to let the MAC decide what to do.
 217          */
 218         ret = bcm_phy_set_eee(phydev, count == DOWNSHIFT_DEV_DISABLE);
 219         if (ret)
 220                 return ret;
 221
 222         return genphy_restart_aneg(phydev);
 223 }
 224
 225 static void bcm_omega_get_phy_stats(struct phy_device *phydev,
 226                                     struct ethtool_stats *stats, u64 *data)
 227 {
 228         struct bcm_omega_phy_priv *priv = phydev->priv;
 229
 230         bcm_phy_get_stats(phydev, priv->stats, stats, data);
 231 }
 232
 233 static int bcm_omega_probe(struct phy_device *phydev)
 234 {
 235         struct bcm_omega_phy_priv *priv;
 236
 237         priv = devm_kzalloc(&phydev->mdio.dev, sizeof(*priv), GFP_KERNEL);
 238         if (!priv)
 239                 return -ENOMEM;
 240
 241         phydev->priv = priv;
 242
 243         priv->stats = devm_kcalloc(&phydev->mdio.dev,
 244                                    bcm_phy_get_sset_count(phydev), sizeof(u64),
 245                                    GFP_KERNEL);
 246         if (!priv->stats)
 247                 return -ENOMEM;
 248
 249         return 0;
 250 }
 251
 252 static struct phy_driver bcm_cygnus_phy_driver[] = {
 253 {
 254         .phy_id        = PHY_ID_BCM_CYGNUS,
 255         .phy_id_mask   = 0xfffffff0,
 256         .name          = "Broadcom Cygnus PHY",
 257         /* PHY_GBIT_FEATURES */
 258         .config_init   = bcm_cygnus_config_init,
 259         .ack_interrupt = bcm_phy_ack_intr,
 260         .config_intr   = bcm_phy_config_intr,
 261         .suspend       = genphy_suspend,
 262         .resume        = bcm_cygnus_resume,
 263 }, {
 264         .phy_id         = PHY_ID_BCM_OMEGA,
 265         .phy_id_mask    = 0xfffffff0,
 266         .name           = "Broadcom Omega Combo GPHY",
 267         /* PHY_GBIT_FEATURES */
 268         .flags          = PHY_IS_INTERNAL,
 269         .config_init    = bcm_omega_config_init,
 270         .suspend        = genphy_suspend,
 271         .resume         = bcm_omega_resume,
 272         .get_tunable    = bcm_omega_get_tunable,
 273         .set_tunable    = bcm_omega_set_tunable,
 274         .get_sset_count = bcm_phy_get_sset_count,
 275         .get_strings    = bcm_phy_get_strings,
 276         .get_stats      = bcm_omega_get_phy_stats,
 277         .probe          = bcm_omega_probe,
 278 }
 279 };
 280
 281 static struct mdio_device_id __maybe_unused bcm_cygnus_phy_tbl[] = {
 282         { PHY_ID_BCM_CYGNUS, 0xfffffff0, },
 283         { PHY_ID_BCM_OMEGA, 0xfffffff0, },
 284         { }
 285 };
 286 MODULE_DEVICE_TABLE(mdio, bcm_cygnus_phy_tbl);
 287
 288 module_phy_driver(bcm_cygnus_phy_driver);
 289
 290 MODULE_DESCRIPTION("Broadcom Cygnus internal PHY driver");
 291 MODULE_LICENSE("GPL v2");
 292 MODULE_AUTHOR("Broadcom Corporation");