1 # SPDX-License-Identifier: GPL-2.0-only
3 # UWB device configuration
7 tristate "Ultra Wideband devices"
9 select GENERIC_NET_UTILS
11 UWB is a high-bandwidth, low-power, point-to-point radio
12 technology using a wide spectrum (3.1-10.6GHz). It is
13 optimized for in-room use (480Mbps at 2 meters, 110Mbps at
14 10m). It serves as the transport layer for other protocols,
15 such as Wireless USB (WUSB).
17 The topology is peer to peer; however, higher level
18 protocols (such as WUSB) might impose a master/slave
21 Say Y here if your computer has UWB radio controllers (USB or PCI)
22 based. You will need to enable the radio controllers
23 below. It is ok to select all of them, no harm done.
25 For more help check the UWB and WUSB related files in
26 <file:Documentation/usb/>.
28 To compile the UWB stack as a module, choose M here.
33 tristate "UWB Radio Control driver for WUSB-compliant USB dongles (HWA)"
36 This driver enables the radio controller for HWA USB
37 devices. HWA stands for Host Wire Adapter, and it is a UWB
38 Radio Controller connected to your system via USB. Most of
39 them come with a Wireless USB host controller also.
41 To compile this driver select Y (built in) or M (module). It
42 is safe to select any even if you do not have the hardware.
45 tristate "UWB Radio Control driver for WHCI-compliant cards"
48 This driver enables the radio controller for WHCI cards.
50 WHCI is a specification developed by Intel
51 (http://www.intel.com/technology/comms/wusb/whci.htm) much
52 in the spirit of USB's EHCI, but for UWB and Wireless USB
53 radio/host controllers connected via memory mapping (eg:
54 PCI). Most of these cards come also with a Wireless USB host
57 To compile this driver select Y (built in) or M (module). It
58 is safe to select any even if you do not have the hardware.
61 tristate "Support for Intel Wireless UWB Link 1480 HWA"
65 This driver enables support for the i1480 when connected via
66 USB. It consists of a firmware uploader that will enable it
67 to behave as an HWA device.
69 To compile this driver select Y (built in) or M (module). It
70 is safe to select any even if you do not have the hardware.