include/sound/sof/dai-intel.h

   1 /* SPDX-License-Identifier: (GPL-2.0 OR BSD-3-Clause) */
   2 /*
   3  * This file is provided under a dual BSD/GPLv2 license.  When using or
   4  * redistributing this file, you may do so under either license.
   5  *
   6  * Copyright(c) 2018 Intel Corporation. All rights reserved.
   7  */
   8
   9 #ifndef __INCLUDE_SOUND_SOF_DAI_INTEL_H__
  10 #define __INCLUDE_SOUND_SOF_DAI_INTEL_H__
  11
  12 #include <sound/sof/header.h>
  13
  14  /* ssc1: TINTE */
  15 #define SOF_DAI_INTEL_SSP_QUIRK_TINTE           (1 << 0)
  16  /* ssc1: PINTE */
  17 #define SOF_DAI_INTEL_SSP_QUIRK_PINTE           (1 << 1)
  18  /* ssc2: SMTATF */
  19 #define SOF_DAI_INTEL_SSP_QUIRK_SMTATF          (1 << 2)
  20  /* ssc2: MMRATF */
  21 #define SOF_DAI_INTEL_SSP_QUIRK_MMRATF          (1 << 3)
  22  /* ssc2: PSPSTWFDFD */
  23 #define SOF_DAI_INTEL_SSP_QUIRK_PSPSTWFDFD      (1 << 4)
  24  /* ssc2: PSPSRWFDFD */
  25 #define SOF_DAI_INTEL_SSP_QUIRK_PSPSRWFDFD      (1 << 5)
  26 /* ssc1: LBM */
  27 #define SOF_DAI_INTEL_SSP_QUIRK_LBM             (1 << 6)
  28
  29  /* here is the possibility to define others aux macros */
  30
  31 #define SOF_DAI_INTEL_SSP_FRAME_PULSE_WIDTH_MAX         38
  32 #define SOF_DAI_INTEL_SSP_SLOT_PADDING_MAX              31
  33
  34 /* SSP clocks control settings
  35  *
  36  * Macros for clks_control field in sof_ipc_dai_ssp_params struct.
  37  */
  38
  39 /* mclk 0 disable */
  40 #define SOF_DAI_INTEL_SSP_MCLK_0_DISABLE                BIT(0)
  41 /* mclk 1 disable */
  42 #define SOF_DAI_INTEL_SSP_MCLK_1_DISABLE                BIT(1)
  43 /* mclk keep active */
  44 #define SOF_DAI_INTEL_SSP_CLKCTRL_MCLK_KA               BIT(2)
  45 /* bclk keep active */
  46 #define SOF_DAI_INTEL_SSP_CLKCTRL_BCLK_KA               BIT(3)
  47 /* fs keep active */
  48 #define SOF_DAI_INTEL_SSP_CLKCTRL_FS_KA                 BIT(4)
  49 /* bclk idle */
  50 #define SOF_DAI_INTEL_SSP_CLKCTRL_BCLK_IDLE_HIGH        BIT(5)
  51
  52 /* SSP Configuration Request - SOF_IPC_DAI_SSP_CONFIG */
  53 struct sof_ipc_dai_ssp_params {
  54         struct sof_ipc_hdr hdr;
  55         uint16_t reserved1;
  56         uint16_t mclk_id;
  57
  58         uint32_t mclk_rate;     /* mclk frequency in Hz */
  59         uint32_t fsync_rate;    /* fsync frequency in Hz */
  60         uint32_t bclk_rate;     /* bclk frequency in Hz */
  61
  62         /* TDM */
  63         uint32_t tdm_slots;
  64         uint32_t rx_slots;
  65         uint32_t tx_slots;
  66
  67         /* data */
  68         uint32_t sample_valid_bits;
  69         uint16_t tdm_slot_width;
  70         uint16_t reserved2;     /* alignment */
  71
  72         /* MCLK */
  73         uint32_t mclk_direction;
  74
  75         uint16_t frame_pulse_width;
  76         uint16_t tdm_per_slot_padding_flag;
  77         uint32_t clks_control;
  78         uint32_t quirks;
  79         uint32_t bclk_delay;    /* guaranteed time (ms) for which BCLK
  80                                  * will be driven, before sending data
  81                                  */
  82 } __packed;
  83
  84 /* HDA Configuration Request - SOF_IPC_DAI_HDA_CONFIG */
  85 struct sof_ipc_dai_hda_params {
  86         struct sof_ipc_hdr hdr;
  87         uint32_t link_dma_ch;
  88 } __packed;
  89
  90 /* DMIC Configuration Request - SOF_IPC_DAI_DMIC_CONFIG */
  91
  92 /* This struct is defined per 2ch PDM controller available in the platform.
  93  * Normally it is sufficient to set the used microphone specific enables to 1
  94  * and keep other parameters as zero. The customizations are:
  95  *
  96  * 1. If a device mixes different microphones types with different polarity
  97  * and/or the absolute polarity matters the PCM signal from a microphone
  98  * can be inverted with the controls.
  99  *
 100  * 2. If the microphones in a stereo pair do not appear in captured stream
 101  * in desired order due to board schematics choises they can be swapped with
 102  * the clk_edge parameter.
 103  *
 104  * 3. If PDM bit errors are seen in capture (poor quality) the skew parameter
 105  * that delays the sampling time of data by half cycles of DMIC source clock
 106  * can be tried for improvement. However there is no guarantee for this to fix
 107  * data integrity problems.
 108  */
 109 struct sof_ipc_dai_dmic_pdm_ctrl {
 110         struct sof_ipc_hdr hdr;
 111         uint16_t id;            /**< PDM controller ID */
 112
 113         uint16_t enable_mic_a;  /**< Use A (left) channel mic (0 or 1)*/
 114         uint16_t enable_mic_b;  /**< Use B (right) channel mic (0 or 1)*/
 115
 116         uint16_t polarity_mic_a; /**< Optionally invert mic A signal (0 or 1) */
 117         uint16_t polarity_mic_b; /**< Optionally invert mic B signal (0 or 1) */
 118
 119         uint16_t clk_edge;      /**< Optionally swap data clock edge (0 or 1) */
 120         uint16_t skew;          /**< Adjust PDM data sampling vs. clock (0..15) */
 121
 122         uint16_t reserved[3];   /**< Make sure the total size is 4 bytes aligned */
 123 } __packed;
 124
 125 /* This struct contains the global settings for all 2ch PDM controllers. The
 126  * version number used in configuration data is checked vs. version used by
 127  * device driver src/drivers/dmic.c need to match. It is incremented from
 128  * initial value 1 if updates done for the to driver would alter the operation
 129  * of the microhone.
 130  *
 131  * Note: The microphone clock (pdmclk_min, pdmclk_max, duty_min, duty_max)
 132  * parameters need to be set as defined in microphone data sheet. E.g. clock
 133  * range 1.0 - 3.2 MHz is usually supported microphones. Some microphones are
 134  * multi-mode capable and there may be denied mic clock frequencies between
 135  * the modes. In such case set the clock range limits of the desired mode to
 136  * avoid the driver to set clock to an illegal rate.
 137  *
 138  * The duty cycle could be set to 48-52% if not known. Generally these
 139  * parameters can be altered within data sheet specified limits to match
 140  * required audio application performance power.
 141  *
 142  * The microphone clock needs to be usually about 50-80 times the used audio
 143  * sample rate. With highest sample rates above 48 kHz this can relaxed
 144  * somewhat.
 145  *
 146  * The parameter wake_up_time describes how long time the microphone needs
 147  * for the data line to produce valid output from mic clock start. The driver
 148  * will mute the captured audio for the given time. The min_clock_on_time
 149  * parameter is used to prevent too short clock bursts to happen. The driver
 150  * will keep the clock active after capture stop if this time is not yet
 151  * met. The unit for both is microseconds (us). Exceed of 100 ms will be
 152  * treated as an error.
 153  */
 154 struct sof_ipc_dai_dmic_params {
 155         struct sof_ipc_hdr hdr;
 156         uint32_t driver_ipc_version;    /**< Version (1..N) */
 157
 158         uint32_t pdmclk_min;    /**< Minimum microphone clock in Hz (100000..N) */
 159         uint32_t pdmclk_max;    /**< Maximum microphone clock in Hz (min...N) */
 160
 161         uint32_t fifo_fs;       /**< FIFO sample rate in Hz (8000..96000) */
 162         uint32_t reserved_1;    /**< Reserved */
 163         uint16_t fifo_bits;     /**< FIFO word length (16 or 32) */
 164         uint16_t reserved_2;    /**< Reserved */
 165
 166         uint16_t duty_min;      /**< Min. mic clock duty cycle in % (20..80) */
 167         uint16_t duty_max;      /**< Max. mic clock duty cycle in % (min..80) */
 168
 169         uint32_t num_pdm_active; /**< Number of active pdm controllers */
 170
 171         uint32_t wake_up_time;      /**< Time from clock start to data (us) */
 172         uint32_t min_clock_on_time; /**< Min. time that clk is kept on (us) */
 173         uint32_t unmute_ramp_time;  /**< Length of logarithmic gain ramp (ms) */
 174
 175         /* reserved for future use */
 176         uint32_t reserved[5];
 177
 178         /**< variable number of pdm controller config */
 179         struct sof_ipc_dai_dmic_pdm_ctrl pdm[0];
 180 } __packed;
 181
 182 /* ALH Configuration Request - SOF_IPC_DAI_ALH_CONFIG */
 183 struct sof_ipc_dai_alh_params {
 184         struct sof_ipc_hdr hdr;
 185         uint32_t stream_id;
 186
 187         /* reserved for future use */
 188         uint32_t reserved[15];
 189 } __packed;
 190
 191 #endif