arch/arm/boot/dts/kirkwood-km_kirkwood.dts

   1 /dts-v1/;
   2
   3 #include "kirkwood.dtsi"
   4 #include "kirkwood-98dx4122.dtsi"
   5
   6 / {
   7         model = "Keymile Kirkwood Reference Design";
   8         compatible = "keymile,km_kirkwood", "marvell,kirkwood-98DX4122", "marvell,kirkwood";
   9
  10         memory {
  11                 device_type = "memory";
  12                 reg = <0x00000000 0x08000000>;
  13         };
  14
  15         chosen {
  16                 bootargs = "console=ttyS0,115200n8 earlyprintk";
  17         };
  18
  19         ocp@f1000000 {
  20                 pinctrl: pinctrl@10000 {
  21                         pinctrl-0 = < &pmx_i2c_gpio_sda &pmx_i2c_gpio_scl >;
  22                         pinctrl-names = "default";
  23
  24                         pmx_i2c_gpio_sda: pmx-gpio-sda {
  25                                 marvell,pins = "mpp8";
  26                                 marvell,function = "gpio";
  27                         };
  28                         pmx_i2c_gpio_scl: pmx-gpio-scl {
  29                                 marvell,pins = "mpp9";
  30                                 marvell,function = "gpio";
  31                         };
  32                 };
  33
  34                 serial@12000 {
  35                         status = "ok";
  36                 };
  37
  38                 nand@3000000 {
  39                         pinctrl-0 = <&pmx_nand>;
  40                         pinctrl-names = "default";
  41                         status = "ok";
  42                         chip-delay = <25>;
  43                 };
  44         };
  45
  46         i2c@0 {
  47                 compatible = "i2c-gpio";
  48                 gpios = < &gpio0 8 0            /* sda */
  49                         &gpio0 9 0 >;           /* scl */
  50                 i2c-gpio,delay-us = <2>;        /* ~100 kHz */
  51         };
  52 };
  53
  54 &mdio {
  55         status = "okay";
  56
  57         ethphy0: ethernet-phy@0 {
  58                 device_type = "ethernet-phy";
  59                 reg = <0>;
  60         };
  61 };
  62
  63 &eth0 {
  64         status = "okay";
  65         ethernet0-port@0 {
  66                 phy-handle = <&ethphy0>;
  67         };
  68 };