2 * Copyright (C) 2000 - 2007 Jeff Dike (jdike@{addtoit,linux.intel}.com)
3 * Licensed under the GPL
7 #include <linux/sched/signal.h>
8 #include <linux/hardirq.h>
9 #include <linux/module.h>
10 #include <linux/uaccess.h>
11 #include <linux/sched/debug.h>
12 #include <asm/current.h>
13 #include <asm/pgtable.h>
14 #include <asm/tlbflush.h>
16 #include <as-layout.h>
17 #include <kern_util.h>
22 * Note this is constrained to return 0, -EFAULT, -EACCESS, -ENOMEM by
25 int handle_page_fault(unsigned long address
, unsigned long ip
,
26 int is_write
, int is_user
, int *code_out
)
28 struct mm_struct
*mm
= current
->mm
;
29 struct vm_area_struct
*vma
;
35 unsigned int flags
= FAULT_FLAG_ALLOW_RETRY
| FAULT_FLAG_KILLABLE
;
37 *code_out
= SEGV_MAPERR
;
40 * If the fault was with pagefaults disabled, don't take the fault, just
43 if (faulthandler_disabled())
47 flags
|= FAULT_FLAG_USER
;
49 down_read(&mm
->mmap_sem
);
50 vma
= find_vma(mm
, address
);
53 else if (vma
->vm_start
<= address
)
55 else if (!(vma
->vm_flags
& VM_GROWSDOWN
))
57 else if (is_user
&& !ARCH_IS_STACKGROW(address
))
59 else if (expand_stack(vma
, address
))
63 *code_out
= SEGV_ACCERR
;
65 if (!(vma
->vm_flags
& VM_WRITE
))
67 flags
|= FAULT_FLAG_WRITE
;
69 /* Don't require VM_READ|VM_EXEC for write faults! */
70 if (!(vma
->vm_flags
& (VM_READ
| VM_EXEC
)))
77 fault
= handle_mm_fault(vma
, address
, flags
);
79 if ((fault
& VM_FAULT_RETRY
) && fatal_signal_pending(current
))
82 if (unlikely(fault
& VM_FAULT_ERROR
)) {
83 if (fault
& VM_FAULT_OOM
) {
85 } else if (fault
& VM_FAULT_SIGSEGV
) {
87 } else if (fault
& VM_FAULT_SIGBUS
) {
93 if (flags
& FAULT_FLAG_ALLOW_RETRY
) {
94 if (fault
& VM_FAULT_MAJOR
)
98 if (fault
& VM_FAULT_RETRY
) {
99 flags
&= ~FAULT_FLAG_ALLOW_RETRY
;
100 flags
|= FAULT_FLAG_TRIED
;
106 pgd
= pgd_offset(mm
, address
);
107 pud
= pud_offset(pgd
, address
);
108 pmd
= pmd_offset(pud
, address
);
109 pte
= pte_offset_kernel(pmd
, address
);
110 } while (!pte_present(*pte
));
113 * The below warning was added in place of
114 * pte_mkyoung(); if (is_write) pte_mkdirty();
115 * If it's triggered, we'd see normally a hang here (a clean pte is
116 * marked read-only to emulate the dirty bit).
117 * However, the generic code can mark a PTE writable but clean on a
118 * concurrent read fault, triggering this harmlessly. So comment it out.
121 WARN_ON(!pte_young(*pte
) || (is_write
&& !pte_dirty(*pte
)));
123 flush_tlb_page(vma
, address
);
125 up_read(&mm
->mmap_sem
);
131 * We ran out of memory, call the OOM killer, and return the userspace
132 * (which will retry the fault, or kill us if we got oom-killed).
134 up_read(&mm
->mmap_sem
);
136 goto out_nosemaphore
;
137 pagefault_out_of_memory();
140 EXPORT_SYMBOL(handle_page_fault
);
142 static void show_segv_info(struct uml_pt_regs
*regs
)
144 struct task_struct
*tsk
= current
;
145 struct faultinfo
*fi
= UPT_FAULTINFO(regs
);
147 if (!unhandled_signal(tsk
, SIGSEGV
))
150 if (!printk_ratelimit())
153 printk("%s%s[%d]: segfault at %lx ip %px sp %px error %x",
154 task_pid_nr(tsk
) > 1 ? KERN_INFO
: KERN_EMERG
,
155 tsk
->comm
, task_pid_nr(tsk
), FAULT_ADDRESS(*fi
),
156 (void *)UPT_IP(regs
), (void *)UPT_SP(regs
),
159 print_vma_addr(KERN_CONT
" in ", UPT_IP(regs
));
160 printk(KERN_CONT
"\n");
163 static void bad_segv(struct faultinfo fi
, unsigned long ip
)
165 current
->thread
.arch
.faultinfo
= fi
;
166 force_sig_fault(SIGSEGV
, SEGV_ACCERR
, (void __user
*) FAULT_ADDRESS(fi
),
170 void fatal_sigsegv(void)
172 force_sigsegv(SIGSEGV
, current
);
173 do_signal(¤t
->thread
.regs
);
175 * This is to tell gcc that we're not returning - do_signal
176 * can, in general, return, but in this case, it's not, since
177 * we just got a fatal SIGSEGV queued.
183 * segv_handler() - the SIGSEGV handler
184 * @sig: the signal number
185 * @unused_si: the signal info struct; unused in this handler
186 * @regs: the ptrace register information
188 * The handler first extracts the faultinfo from the UML ptrace regs struct.
189 * If the userfault did not happen in an UML userspace process, bad_segv is called.
190 * Otherwise the signal did happen in a cloned userspace process, handle it.
192 void segv_handler(int sig
, struct siginfo
*unused_si
, struct uml_pt_regs
*regs
)
194 struct faultinfo
* fi
= UPT_FAULTINFO(regs
);
196 if (UPT_IS_USER(regs
) && !SEGV_IS_FIXABLE(fi
)) {
197 show_segv_info(regs
);
198 bad_segv(*fi
, UPT_IP(regs
));
201 segv(*fi
, UPT_IP(regs
), UPT_IS_USER(regs
), regs
);
205 * We give a *copy* of the faultinfo in the regs to segv.
206 * This must be done, since nesting SEGVs could overwrite
207 * the info in the regs. A pointer to the info then would
210 unsigned long segv(struct faultinfo fi
, unsigned long ip
, int is_user
,
211 struct uml_pt_regs
*regs
)
216 int is_write
= FAULT_WRITE(fi
);
217 unsigned long address
= FAULT_ADDRESS(fi
);
219 if (!is_user
&& regs
)
220 current
->thread
.segv_regs
= container_of(regs
, struct pt_regs
, regs
);
222 if (!is_user
&& (address
>= start_vm
) && (address
< end_vm
)) {
223 flush_tlb_kernel_vm();
226 else if (current
->mm
== NULL
) {
227 show_regs(container_of(regs
, struct pt_regs
, regs
));
228 panic("Segfault with no mm");
230 else if (!is_user
&& address
> PAGE_SIZE
&& address
< TASK_SIZE
) {
231 show_regs(container_of(regs
, struct pt_regs
, regs
));
232 panic("Kernel tried to access user memory at addr 0x%lx, ip 0x%lx",
236 if (SEGV_IS_FIXABLE(&fi
))
237 err
= handle_page_fault(address
, ip
, is_write
, is_user
,
242 * A thread accessed NULL, we get a fault, but CR2 is invalid.
243 * This code is used in __do_copy_from_user() of TT mode.
244 * XXX tt mode is gone, so maybe this isn't needed any more
249 catcher
= current
->thread
.fault_catcher
;
252 else if (catcher
!= NULL
) {
253 current
->thread
.fault_addr
= (void *) address
;
254 UML_LONGJMP(catcher
, 1);
256 else if (current
->thread
.fault_addr
!= NULL
)
257 panic("fault_addr set but no fault catcher");
258 else if (!is_user
&& arch_fixup(ip
, regs
))
262 show_regs(container_of(regs
, struct pt_regs
, regs
));
263 panic("Kernel mode fault at addr 0x%lx, ip 0x%lx",
267 show_segv_info(regs
);
269 if (err
== -EACCES
) {
270 current
->thread
.arch
.faultinfo
= fi
;
271 force_sig_fault(SIGBUS
, BUS_ADRERR
, (void __user
*)address
,
274 BUG_ON(err
!= -EFAULT
);
275 current
->thread
.arch
.faultinfo
= fi
;
276 force_sig_fault(SIGSEGV
, si_code
, (void __user
*) address
,
282 current
->thread
.segv_regs
= NULL
;
287 void relay_signal(int sig
, struct siginfo
*si
, struct uml_pt_regs
*regs
)
290 if (!UPT_IS_USER(regs
)) {
292 printk(KERN_ERR
"Bus error - the host /dev/shm or /tmp "
293 "mount likely just ran out of space\n");
294 panic("Kernel mode signal %d", sig
);
297 arch_examine_signal(sig
, regs
);
299 /* Is the signal layout for the signal known?
300 * Signal data must be scrubbed to prevent information leaks.
304 if ((err
== 0) && (siginfo_layout(sig
, code
) == SIL_FAULT
)) {
305 struct faultinfo
*fi
= UPT_FAULTINFO(regs
);
306 current
->thread
.arch
.faultinfo
= *fi
;
307 force_sig_fault(sig
, code
, (void __user
*)FAULT_ADDRESS(*fi
),
310 printk(KERN_ERR
"Attempted to relay unknown signal %d (si_code = %d) with errno %d\n",
312 force_sig(sig
, current
);
316 void bus_handler(int sig
, struct siginfo
*si
, struct uml_pt_regs
*regs
)
318 if (current
->thread
.fault_catcher
!= NULL
)
319 UML_LONGJMP(current
->thread
.fault_catcher
, 1);
321 relay_signal(sig
, si
, regs
);
324 void winch(int sig
, struct siginfo
*unused_si
, struct uml_pt_regs
*regs
)
326 do_IRQ(WINCH_IRQ
, regs
);