gpio: rcar: Fix runtime PM imbalance on error
[linux/fpc-iii.git] / drivers / media / i2c / tvp5150_reg.h
blobf716129adf0951d07891678de5d518f8fe479f70
1 /* SPDX-License-Identifier: GPL-2.0 */
2 /*
4 * tvp5150 - Texas Instruments TVP5150A/AM1 video decoder registers
6 * Copyright (c) 2005,2006 Mauro Carvalho Chehab <mchehab@kernel.org>
7 */
9 #define TVP5150_VD_IN_SRC_SEL_1 0x00 /* Video input source selection #1 */
10 #define TVP5150_ANAL_CHL_CTL 0x01 /* Analog channel controls */
11 #define TVP5150_OP_MODE_CTL 0x02 /* Operation mode controls */
12 #define TVP5150_MISC_CTL 0x03 /* Miscellaneous controls */
13 #define TVP5150_MISC_CTL_VBLK_GPCL BIT(7)
14 #define TVP5150_MISC_CTL_GPCL BIT(6)
15 #define TVP5150_MISC_CTL_INTREQ_OE BIT(5)
16 #define TVP5150_MISC_CTL_HVLK BIT(4)
17 #define TVP5150_MISC_CTL_YCBCR_OE BIT(3)
18 #define TVP5150_MISC_CTL_SYNC_OE BIT(2)
19 #define TVP5150_MISC_CTL_VBLANK BIT(1)
20 #define TVP5150_MISC_CTL_CLOCK_OE BIT(0)
22 #define TVP5150_AUTOSW_MSK 0x04 /* Autoswitch mask: TVP5150A / TVP5150AM */
24 /* Reserved 05h */
26 #define TVP5150_COLOR_KIL_THSH_CTL 0x06 /* Color killer threshold control */
27 #define TVP5150_LUMA_PROC_CTL_1 0x07 /* Luminance processing control #1 */
28 #define TVP5150_LUMA_PROC_CTL_2 0x08 /* Luminance processing control #2 */
29 #define TVP5150_BRIGHT_CTL 0x09 /* Brightness control */
30 #define TVP5150_SATURATION_CTL 0x0a /* Color saturation control */
31 #define TVP5150_HUE_CTL 0x0b /* Hue control */
32 #define TVP5150_CONTRAST_CTL 0x0c /* Contrast control */
33 #define TVP5150_DATA_RATE_SEL 0x0d /* Outputs and data rates select */
34 #define TVP5150_LUMA_PROC_CTL_3 0x0e /* Luminance processing control #3 */
35 #define TVP5150_CONF_SHARED_PIN 0x0f /* Configuration shared pins */
37 /* Reserved 10h */
39 #define TVP5150_ACT_VD_CROP_ST_MSB 0x11 /* Active video cropping start MSB */
40 #define TVP5150_ACT_VD_CROP_ST_LSB 0x12 /* Active video cropping start LSB */
41 #define TVP5150_ACT_VD_CROP_STP_MSB 0x13 /* Active video cropping stop MSB */
42 #define TVP5150_ACT_VD_CROP_STP_LSB 0x14 /* Active video cropping stop LSB */
43 #define TVP5150_GENLOCK 0x15 /* Genlock/RTC */
44 #define TVP5150_HORIZ_SYNC_START 0x16 /* Horizontal sync start */
46 /* Reserved 17h */
48 #define TVP5150_VERT_BLANKING_START 0x18 /* Vertical blanking start */
49 #define TVP5150_VERT_BLANKING_STOP 0x19 /* Vertical blanking stop */
50 #define TVP5150_CHROMA_PROC_CTL_1 0x1a /* Chrominance processing control #1 */
51 #define TVP5150_CHROMA_PROC_CTL_2 0x1b /* Chrominance processing control #2 */
52 #define TVP5150_INT_RESET_REG_B 0x1c /* Interrupt reset register B */
53 #define TVP5150_INT_ENABLE_REG_B 0x1d /* Interrupt enable register B */
54 #define TVP5150_INTT_CONFIG_REG_B 0x1e /* Interrupt configuration register B */
56 /* Reserved 1Fh-27h */
58 #define VIDEO_STD_MASK (0x07 >> 1)
59 #define TVP5150_VIDEO_STD 0x28 /* Video standard */
60 #define VIDEO_STD_AUTO_SWITCH_BIT 0x00
61 #define VIDEO_STD_NTSC_MJ_BIT 0x02
62 #define VIDEO_STD_PAL_BDGHIN_BIT 0x04
63 #define VIDEO_STD_PAL_M_BIT 0x06
64 #define VIDEO_STD_PAL_COMBINATION_N_BIT 0x08
65 #define VIDEO_STD_NTSC_4_43_BIT 0x0a
66 #define VIDEO_STD_SECAM_BIT 0x0c
68 #define VIDEO_STD_NTSC_MJ_BIT_AS 0x01
69 #define VIDEO_STD_PAL_BDGHIN_BIT_AS 0x03
70 #define VIDEO_STD_PAL_M_BIT_AS 0x05
71 #define VIDEO_STD_PAL_COMBINATION_N_BIT_AS 0x07
72 #define VIDEO_STD_NTSC_4_43_BIT_AS 0x09
73 #define VIDEO_STD_SECAM_BIT_AS 0x0b
75 /* Reserved 29h-2bh */
77 #define TVP5150_CB_GAIN_FACT 0x2c /* Cb gain factor */
78 #define TVP5150_CR_GAIN_FACTOR 0x2d /* Cr gain factor */
79 #define TVP5150_MACROVISION_ON_CTR 0x2e /* Macrovision on counter */
80 #define TVP5150_MACROVISION_OFF_CTR 0x2f /* Macrovision off counter */
81 #define TVP5150_REV_SELECT 0x30 /* revision select (TVP5150AM1 only) */
83 /* Reserved 31h-7Fh */
85 #define TVP5150_MSB_DEV_ID 0x80 /* MSB of device ID */
86 #define TVP5150_LSB_DEV_ID 0x81 /* LSB of device ID */
87 #define TVP5150_ROM_MAJOR_VER 0x82 /* ROM major version */
88 #define TVP5150_ROM_MINOR_VER 0x83 /* ROM minor version */
89 #define TVP5150_VERT_LN_COUNT_MSB 0x84 /* Vertical line count MSB */
90 #define TVP5150_VERT_LN_COUNT_LSB 0x85 /* Vertical line count LSB */
91 #define TVP5150_INT_STATUS_REG_B 0x86 /* Interrupt status register B */
92 #define TVP5150_INT_ACTIVE_REG_B 0x87 /* Interrupt active register B */
93 #define TVP5150_STATUS_REG_1 0x88 /* Status register #1 */
94 #define TVP5150_STATUS_REG_2 0x89 /* Status register #2 */
95 #define TVP5150_STATUS_REG_3 0x8a /* Status register #3 */
96 #define TVP5150_STATUS_REG_4 0x8b /* Status register #4 */
97 #define TVP5150_STATUS_REG_5 0x8c /* Status register #5 */
98 /* Reserved 8Dh-8Fh */
99 /* Closed caption data registers */
100 #define TVP5150_CC_DATA_INI 0x90
101 #define TVP5150_CC_DATA_END 0x93
103 /* WSS data registers */
104 #define TVP5150_WSS_DATA_INI 0x94
105 #define TVP5150_WSS_DATA_END 0x99
107 /* VPS data registers */
108 #define TVP5150_VPS_DATA_INI 0x9a
109 #define TVP5150_VPS_DATA_END 0xa6
111 /* VITC data registers */
112 #define TVP5150_VITC_DATA_INI 0xa7
113 #define TVP5150_VITC_DATA_END 0xaf
115 #define TVP5150_VBI_FIFO_READ_DATA 0xb0 /* VBI FIFO read data */
117 /* Teletext filter 1 */
118 #define TVP5150_TELETEXT_FIL1_INI 0xb1
119 #define TVP5150_TELETEXT_FIL1_END 0xb5
121 /* Teletext filter 2 */
122 #define TVP5150_TELETEXT_FIL2_INI 0xb6
123 #define TVP5150_TELETEXT_FIL2_END 0xba
125 #define TVP5150_TELETEXT_FIL_ENA 0xbb /* Teletext filter enable */
126 /* Reserved BCh-BFh */
127 #define TVP5150_INT_STATUS_REG_A 0xc0 /* Interrupt status register A */
128 #define TVP5150_INT_A_LOCK_STATUS BIT(7)
129 #define TVP5150_INT_A_LOCK BIT(6)
130 #define TVP5150_INT_ENABLE_REG_A 0xc1 /* Interrupt enable register A */
131 #define TVP5150_INT_CONF 0xc2 /* Interrupt configuration */
132 #define TVP5150_VDPOE BIT(2)
133 #define TVP5150_VDP_CONF_RAM_DATA 0xc3 /* VDP configuration RAM data */
134 #define TVP5150_CONF_RAM_ADDR_LOW 0xc4 /* Configuration RAM address low byte */
135 #define TVP5150_CONF_RAM_ADDR_HIGH 0xc5 /* Configuration RAM address high byte */
136 #define TVP5150_VDP_STATUS_REG 0xc6 /* VDP status register */
137 #define TVP5150_FIFO_WORD_COUNT 0xc7 /* FIFO word count */
138 #define TVP5150_FIFO_INT_THRESHOLD 0xc8 /* FIFO interrupt threshold */
139 #define TVP5150_FIFO_RESET 0xc9 /* FIFO reset */
140 #define TVP5150_LINE_NUMBER_INT 0xca /* Line number interrupt */
141 #define TVP5150_PIX_ALIGN_REG_LOW 0xcb /* Pixel alignment register low byte */
142 #define TVP5150_PIX_ALIGN_REG_HIGH 0xcc /* Pixel alignment register high byte */
143 #define TVP5150_FIFO_OUT_CTRL 0xcd /* FIFO output control */
144 /* Reserved CEh */
145 #define TVP5150_FULL_FIELD_ENA 0xcf /* Full field enable 1 */
147 /* Line mode registers */
148 #define TVP5150_LINE_MODE_INI 0xd0
149 #define TVP5150_LINE_MODE_END 0xfb
151 #define TVP5150_FULL_FIELD_MODE_REG 0xfc /* Full field mode register */
152 /* Reserved FDh-FFh */