2 * Lockless get_user_pages_fast for x86
4 * Copyright (C) 2008 Nick Piggin
5 * Copyright (C) 2008 Novell Inc.
7 #include <linux/sched.h>
9 #include <linux/vmstat.h>
10 #include <linux/highmem.h>
11 #include <linux/swap.h>
13 #include <asm/pgtable.h>
15 static inline pte_t
gup_get_pte(pte_t
*ptep
)
17 #ifndef CONFIG_X86_PAE
18 return ACCESS_ONCE(*ptep
);
21 * With get_user_pages_fast, we walk down the pagetables without taking
22 * any locks. For this we would like to load the pointers atomically,
23 * but that is not possible (without expensive cmpxchg8b) on PAE. What
24 * we do have is the guarantee that a pte will only either go from not
25 * present to present, or present to not present or both -- it will not
26 * switch to a completely different present page without a TLB flush in
27 * between; something that we are blocking by holding interrupts off.
29 * Setting ptes from not present to present goes:
34 * And present to not present goes:
39 * We must ensure here that the load of pte_low sees l iff pte_high
40 * sees h. We load pte_high *after* loading pte_low, which ensures we
41 * don't see an older value of pte_high. *Then* we recheck pte_low,
42 * which ensures that we haven't picked up a changed pte high. We might
43 * have got rubbish values from pte_low and pte_high, but we are
44 * guaranteed that pte_low will not have the present bit set *unless*
45 * it is 'l'. And get_user_pages_fast only operates on present ptes, so
48 * gup_get_pte should not be used or copied outside gup.c without being
49 * very careful -- it does not atomically load the pte or anything that
50 * is likely to be useful for you.
55 pte
.pte_low
= ptep
->pte_low
;
57 pte
.pte_high
= ptep
->pte_high
;
59 if (unlikely(pte
.pte_low
!= ptep
->pte_low
))
67 * The performance critical leaf functions are made noinline otherwise gcc
68 * inlines everything into a single function which results in too much
71 static noinline
int gup_pte_range(pmd_t pmd
, unsigned long addr
,
72 unsigned long end
, int write
, struct page
**pages
, int *nr
)
77 mask
= _PAGE_PRESENT
|_PAGE_USER
;
81 ptep
= pte_offset_map(&pmd
, addr
);
83 pte_t pte
= gup_get_pte(ptep
);
86 if ((pte_flags(pte
) & (mask
| _PAGE_SPECIAL
)) != mask
) {
90 VM_BUG_ON(!pfn_valid(pte_pfn(pte
)));
93 SetPageReferenced(page
);
97 } while (ptep
++, addr
+= PAGE_SIZE
, addr
!= end
);
103 static inline void get_head_page_multiple(struct page
*page
, int nr
)
105 VM_BUG_ON(page
!= compound_head(page
));
106 VM_BUG_ON(page_count(page
) == 0);
107 atomic_add(nr
, &page
->_count
);
108 SetPageReferenced(page
);
111 static noinline
int gup_huge_pmd(pmd_t pmd
, unsigned long addr
,
112 unsigned long end
, int write
, struct page
**pages
, int *nr
)
115 pte_t pte
= *(pte_t
*)&pmd
;
116 struct page
*head
, *page
;
119 mask
= _PAGE_PRESENT
|_PAGE_USER
;
122 if ((pte_flags(pte
) & mask
) != mask
)
124 /* hugepages are never "special" */
125 VM_BUG_ON(pte_flags(pte
) & _PAGE_SPECIAL
);
126 VM_BUG_ON(!pfn_valid(pte_pfn(pte
)));
129 head
= pte_page(pte
);
130 page
= head
+ ((addr
& ~PMD_MASK
) >> PAGE_SHIFT
);
132 VM_BUG_ON(compound_head(page
) != head
);
135 get_huge_page_tail(page
);
139 } while (addr
+= PAGE_SIZE
, addr
!= end
);
140 get_head_page_multiple(head
, refs
);
145 static int gup_pmd_range(pud_t pud
, unsigned long addr
, unsigned long end
,
146 int write
, struct page
**pages
, int *nr
)
151 pmdp
= pmd_offset(&pud
, addr
);
155 next
= pmd_addr_end(addr
, end
);
157 * The pmd_trans_splitting() check below explains why
158 * pmdp_splitting_flush has to flush the tlb, to stop
159 * this gup-fast code from running while we set the
160 * splitting bit in the pmd. Returning zero will take
161 * the slow path that will call wait_split_huge_page()
162 * if the pmd is still in splitting state. gup-fast
163 * can't because it has irq disabled and
164 * wait_split_huge_page() would never return as the
165 * tlb flush IPI wouldn't run.
167 if (pmd_none(pmd
) || pmd_trans_splitting(pmd
))
169 if (unlikely(pmd_large(pmd
))) {
170 if (!gup_huge_pmd(pmd
, addr
, next
, write
, pages
, nr
))
173 if (!gup_pte_range(pmd
, addr
, next
, write
, pages
, nr
))
176 } while (pmdp
++, addr
= next
, addr
!= end
);
181 static noinline
int gup_huge_pud(pud_t pud
, unsigned long addr
,
182 unsigned long end
, int write
, struct page
**pages
, int *nr
)
185 pte_t pte
= *(pte_t
*)&pud
;
186 struct page
*head
, *page
;
189 mask
= _PAGE_PRESENT
|_PAGE_USER
;
192 if ((pte_flags(pte
) & mask
) != mask
)
194 /* hugepages are never "special" */
195 VM_BUG_ON(pte_flags(pte
) & _PAGE_SPECIAL
);
196 VM_BUG_ON(!pfn_valid(pte_pfn(pte
)));
199 head
= pte_page(pte
);
200 page
= head
+ ((addr
& ~PUD_MASK
) >> PAGE_SHIFT
);
202 VM_BUG_ON(compound_head(page
) != head
);
205 get_huge_page_tail(page
);
209 } while (addr
+= PAGE_SIZE
, addr
!= end
);
210 get_head_page_multiple(head
, refs
);
215 static int gup_pud_range(pgd_t pgd
, unsigned long addr
, unsigned long end
,
216 int write
, struct page
**pages
, int *nr
)
221 pudp
= pud_offset(&pgd
, addr
);
225 next
= pud_addr_end(addr
, end
);
228 if (unlikely(pud_large(pud
))) {
229 if (!gup_huge_pud(pud
, addr
, next
, write
, pages
, nr
))
232 if (!gup_pmd_range(pud
, addr
, next
, write
, pages
, nr
))
235 } while (pudp
++, addr
= next
, addr
!= end
);
241 * Like get_user_pages_fast() except its IRQ-safe in that it won't fall
242 * back to the regular GUP.
244 int __get_user_pages_fast(unsigned long start
, int nr_pages
, int write
,
247 struct mm_struct
*mm
= current
->mm
;
248 unsigned long addr
, len
, end
;
256 len
= (unsigned long) nr_pages
<< PAGE_SHIFT
;
258 if (unlikely(!access_ok(write
? VERIFY_WRITE
: VERIFY_READ
,
259 (void __user
*)start
, len
)))
263 * XXX: batch / limit 'nr', to avoid large irq off latency
264 * needs some instrumenting to determine the common sizes used by
265 * important workloads (eg. DB2), and whether limiting the batch size
266 * will decrease performance.
268 * It seems like we're in the clear for the moment. Direct-IO is
269 * the main guy that batches up lots of get_user_pages, and even
270 * they are limited to 64-at-a-time which is not so many.
273 * This doesn't prevent pagetable teardown, but does prevent
274 * the pagetables and pages from being freed on x86.
276 * So long as we atomically load page table pointers versus teardown
277 * (which we do on x86, with the above PAE exception), we can follow the
278 * address down to the the page and take a ref on it.
280 local_irq_save(flags
);
281 pgdp
= pgd_offset(mm
, addr
);
285 next
= pgd_addr_end(addr
, end
);
288 if (!gup_pud_range(pgd
, addr
, next
, write
, pages
, &nr
))
290 } while (pgdp
++, addr
= next
, addr
!= end
);
291 local_irq_restore(flags
);
297 * get_user_pages_fast() - pin user pages in memory
298 * @start: starting user address
299 * @nr_pages: number of pages from start to pin
300 * @write: whether pages will be written to
301 * @pages: array that receives pointers to the pages pinned.
302 * Should be at least nr_pages long.
304 * Attempt to pin user pages in memory without taking mm->mmap_sem.
305 * If not successful, it will fall back to taking the lock and
306 * calling get_user_pages().
308 * Returns number of pages pinned. This may be fewer than the number
309 * requested. If nr_pages is 0 or negative, returns 0. If no pages
310 * were pinned, returns -errno.
312 int get_user_pages_fast(unsigned long start
, int nr_pages
, int write
,
315 struct mm_struct
*mm
= current
->mm
;
316 unsigned long addr
, len
, end
;
323 len
= (unsigned long) nr_pages
<< PAGE_SHIFT
;
330 if (end
>> __VIRTUAL_MASK_SHIFT
)
335 * XXX: batch / limit 'nr', to avoid large irq off latency
336 * needs some instrumenting to determine the common sizes used by
337 * important workloads (eg. DB2), and whether limiting the batch size
338 * will decrease performance.
340 * It seems like we're in the clear for the moment. Direct-IO is
341 * the main guy that batches up lots of get_user_pages, and even
342 * they are limited to 64-at-a-time which is not so many.
345 * This doesn't prevent pagetable teardown, but does prevent
346 * the pagetables and pages from being freed on x86.
348 * So long as we atomically load page table pointers versus teardown
349 * (which we do on x86, with the above PAE exception), we can follow the
350 * address down to the the page and take a ref on it.
353 pgdp
= pgd_offset(mm
, addr
);
357 next
= pgd_addr_end(addr
, end
);
360 if (!gup_pud_range(pgd
, addr
, next
, write
, pages
, &nr
))
362 } while (pgdp
++, addr
= next
, addr
!= end
);
365 VM_BUG_ON(nr
!= (end
- start
) >> PAGE_SHIFT
);
374 /* Try to get the remaining pages with get_user_pages */
375 start
+= nr
<< PAGE_SHIFT
;
378 down_read(&mm
->mmap_sem
);
379 ret
= get_user_pages(current
, mm
, start
,
380 (end
- start
) >> PAGE_SHIFT
, write
, 0, pages
, NULL
);
381 up_read(&mm
->mmap_sem
);
383 /* Have to be a bit careful with return values */