Documentation/devicetree/bindings/mtd/lpc32xx-mlc.txt

   1 NXP LPC32xx SoC NAND MLC controller
   2
   3 Required properties:
   4 - compatible: "nxp,lpc3220-mlc"
   5 - reg: Address and size of the controller
   6 - interrupts: The NAND interrupt specification
   7 - gpios: GPIO specification for NAND write protect
   8
   9 The following required properties are very controller specific. See the LPC32xx
  10 User Manual 7.5.14 MLC NAND Timing Register (the values here are specified in
  11 Hz, to make them independent of actual clock speed and to provide for good
  12 accuracy:)
  13 - nxp,tcea_delay: TCEA_DELAY
  14 - nxp,busy_delay: BUSY_DELAY
  15 - nxp,nand_ta: NAND_TA
  16 - nxp,rd_high: RD_HIGH
  17 - nxp,rd_low: RD_LOW
  18 - nxp,wr_high: WR_HIGH
  19 - nxp,wr_low: WR_LOW
  20
  21 Optional subnodes:
  22 - Partitions, see Documentation/devicetree/bindings/mtd/partition.txt
  23
  24 Example:
  25
  26         mlc: flash@200A8000 {
  27                 compatible = "nxp,lpc3220-mlc";
  28                 reg = <0x200A8000 0x11000>;
  29                 interrupts = <11 0>;
  30                 #address-cells = <1>;
  31                 #size-cells = <1>;
  32
  33                 nxp,tcea-delay = <333333333>;
  34                 nxp,busy-delay = <10000000>;
  35                 nxp,nand-ta = <18181818>;
  36                 nxp,rd-high = <31250000>;
  37                 nxp,rd-low = <45454545>;
  38                 nxp,wr-high = <40000000>;
  39                 nxp,wr-low = <83333333>;
  40                 gpios = <&gpio 5 19 1>; /* GPO_P3 19, active low */
  41
  42                 mtd0@00000000 {
  43                         label = "boot";
  44                         reg = <0x00000000 0x00064000>;
  45                         read-only;
  46                 };
  47
  48                 ...
  49
  50         };