rtc: stm32: fix misspelling and misalignment issues
[linux/fpc-iii.git] / Documentation / devicetree / bindings / media / i2c / toshiba,et8ek8.txt
blobe80d5891b7eddf53e499c64446e0df41b03cfad5
1 Toshiba et8ek8 5MP sensor
3 Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device
5 More detailed documentation can be found in
6 Documentation/devicetree/bindings/media/video-interfaces.txt .
9 Mandatory properties
10 --------------------
12 - compatible: "toshiba,et8ek8"
13 - reg: I2C address (0x3e, or an alternative address)
14 - vana-supply: Analogue voltage supply (VANA), 2.8 volts
15 - clocks: External clock to the sensor
16 - clock-frequency: Frequency of the external clock to the sensor. Camera
17   driver will set this frequency on the external clock. The clock frequency is
18   a pre-determined frequency known to be suitable to the board.
19 - reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
20   is in hardware standby mode when the signal is in the low state.
23 Optional properties
24 -------------------
26 - flash-leds: See ../video-interfaces.txt
27 - lens-focus: See ../video-interfaces.txt
30 Endpoint node mandatory properties
31 ----------------------------------
33 - remote-endpoint: A phandle to the bus receiver's endpoint node.
36 Example
37 -------
39 &i2c3 {
40         clock-frequency = <400000>;
42         cam1: camera@3e {
43                 compatible = "toshiba,et8ek8";
44                 reg = <0x3e>;
45                 vana-supply = <&vaux4>;
46                 clocks = <&isp 0>;
47                 clock-frequency = <9600000>;
48                 reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */
49                 port {
50                         csi_cam1: endpoint {
51                                 remote-endpoint = <&csi_out1>;
52                         };
53                 };
54         };