x86/boot: Rename overlapping memcpy() to memmove()
[linux/fpc-iii.git] / arch / arm / mach-pxa / cm-x255.c
blobb592f79a1742d7eab4f2315a41ebbdacf595bdda
1 /*
2 * linux/arch/arm/mach-pxa/cm-x255.c
4 * Copyright (C) 2007, 2008 CompuLab, Ltd.
5 * Mike Rapoport <mike@compulab.co.il>
7 * This program is free software; you can redistribute it and/or modify
8 * it under the terms of the GNU General Public License version 2 as
9 * published by the Free Software Foundation.
12 #include <linux/platform_device.h>
13 #include <linux/irq.h>
14 #include <linux/mtd/partitions.h>
15 #include <linux/mtd/physmap.h>
16 #include <linux/mtd/nand-gpio.h>
18 #include <linux/spi/spi.h>
19 #include <linux/spi/pxa2xx_spi.h>
21 #include <asm/mach/arch.h>
22 #include <asm/mach-types.h>
23 #include <asm/mach/map.h>
25 #include "pxa25x.h"
27 #include "generic.h"
29 #define GPIO_NAND_CS (5)
30 #define GPIO_NAND_ALE (4)
31 #define GPIO_NAND_CLE (3)
32 #define GPIO_NAND_RB (10)
34 static unsigned long cmx255_pin_config[] = {
35 /* AC'97 */
36 GPIO28_AC97_BITCLK,
37 GPIO29_AC97_SDATA_IN_0,
38 GPIO30_AC97_SDATA_OUT,
39 GPIO31_AC97_SYNC,
41 /* BTUART */
42 GPIO42_BTUART_RXD,
43 GPIO43_BTUART_TXD,
44 GPIO44_BTUART_CTS,
45 GPIO45_BTUART_RTS,
47 /* STUART */
48 GPIO46_STUART_RXD,
49 GPIO47_STUART_TXD,
51 /* LCD */
52 GPIOxx_LCD_TFT_16BPP,
54 /* SSP1 */
55 GPIO23_SSP1_SCLK,
56 GPIO24_SSP1_SFRM,
57 GPIO25_SSP1_TXD,
58 GPIO26_SSP1_RXD,
60 /* SSP2 */
61 GPIO81_SSP2_CLK_OUT,
62 GPIO82_SSP2_FRM_OUT,
63 GPIO83_SSP2_TXD,
64 GPIO84_SSP2_RXD,
66 /* PC Card */
67 GPIO48_nPOE,
68 GPIO49_nPWE,
69 GPIO50_nPIOR,
70 GPIO51_nPIOW,
71 GPIO52_nPCE_1,
72 GPIO53_nPCE_2,
73 GPIO54_nPSKTSEL,
74 GPIO55_nPREG,
75 GPIO56_nPWAIT,
76 GPIO57_nIOIS16,
78 /* SDRAM and local bus */
79 GPIO15_nCS_1,
80 GPIO78_nCS_2,
81 GPIO79_nCS_3,
82 GPIO80_nCS_4,
83 GPIO33_nCS_5,
84 GPIO18_RDY,
86 /* GPIO */
87 GPIO0_GPIO | WAKEUP_ON_EDGE_BOTH,
88 GPIO9_GPIO, /* PC card reset */
90 /* NAND controls */
91 GPIO5_GPIO | MFP_LPM_DRIVE_HIGH, /* NAND CE# */
92 GPIO4_GPIO | MFP_LPM_DRIVE_LOW, /* NAND ALE */
93 GPIO3_GPIO | MFP_LPM_DRIVE_LOW, /* NAND CLE */
94 GPIO10_GPIO, /* NAND Ready/Busy */
96 /* interrupts */
97 GPIO22_GPIO, /* DM9000 interrupt */
100 #if defined(CONFIG_SPI_PXA2XX)
101 static struct pxa2xx_spi_master pxa_ssp_master_info = {
102 .num_chipselect = 1,
105 static struct spi_board_info spi_board_info[] __initdata = {
106 [0] = {
107 .modalias = "rtc-max6902",
108 .max_speed_hz = 1000000,
109 .bus_num = 1,
110 .chip_select = 0,
114 static void __init cmx255_init_rtc(void)
116 pxa2xx_set_spi_info(1, &pxa_ssp_master_info);
117 spi_register_board_info(ARRAY_AND_SIZE(spi_board_info));
119 #else
120 static inline void cmx255_init_rtc(void) {}
121 #endif
123 #if defined(CONFIG_MTD_PHYSMAP) || defined(CONFIG_MTD_PHYSMAP_MODULE)
124 static struct mtd_partition cmx255_nor_partitions[] = {
126 .name = "ARMmon",
127 .size = 0x00030000,
128 .offset = 0,
129 .mask_flags = MTD_WRITEABLE /* force read-only */
130 } , {
131 .name = "ARMmon setup block",
132 .size = 0x00010000,
133 .offset = MTDPART_OFS_APPEND,
134 .mask_flags = MTD_WRITEABLE /* force read-only */
135 } , {
136 .name = "kernel",
137 .size = 0x00160000,
138 .offset = MTDPART_OFS_APPEND,
139 } , {
140 .name = "ramdisk",
141 .size = MTDPART_SIZ_FULL,
142 .offset = MTDPART_OFS_APPEND
146 static struct physmap_flash_data cmx255_nor_flash_data[] = {
148 .width = 2, /* bankwidth in bytes */
149 .parts = cmx255_nor_partitions,
150 .nr_parts = ARRAY_SIZE(cmx255_nor_partitions)
154 static struct resource cmx255_nor_resource = {
155 .start = PXA_CS0_PHYS,
156 .end = PXA_CS0_PHYS + SZ_8M - 1,
157 .flags = IORESOURCE_MEM,
160 static struct platform_device cmx255_nor = {
161 .name = "physmap-flash",
162 .id = -1,
163 .dev = {
164 .platform_data = cmx255_nor_flash_data,
166 .resource = &cmx255_nor_resource,
167 .num_resources = 1,
170 static void __init cmx255_init_nor(void)
172 platform_device_register(&cmx255_nor);
174 #else
175 static inline void cmx255_init_nor(void) {}
176 #endif
178 #if defined(CONFIG_MTD_NAND_GPIO) || defined(CONFIG_MTD_NAND_GPIO_MODULE)
179 static struct resource cmx255_nand_resource[] = {
180 [0] = {
181 .start = PXA_CS1_PHYS,
182 .end = PXA_CS1_PHYS + 11,
183 .flags = IORESOURCE_MEM,
185 [1] = {
186 .start = PXA_CS5_PHYS,
187 .end = PXA_CS5_PHYS + 3,
188 .flags = IORESOURCE_MEM,
192 static struct mtd_partition cmx255_nand_parts[] = {
193 [0] = {
194 .name = "cmx255-nand",
195 .size = MTDPART_SIZ_FULL,
196 .offset = 0,
200 static struct gpio_nand_platdata cmx255_nand_platdata = {
201 .gpio_nce = GPIO_NAND_CS,
202 .gpio_cle = GPIO_NAND_CLE,
203 .gpio_ale = GPIO_NAND_ALE,
204 .gpio_rdy = GPIO_NAND_RB,
205 .gpio_nwp = -1,
206 .parts = cmx255_nand_parts,
207 .num_parts = ARRAY_SIZE(cmx255_nand_parts),
208 .chip_delay = 25,
211 static struct platform_device cmx255_nand = {
212 .name = "gpio-nand",
213 .num_resources = ARRAY_SIZE(cmx255_nand_resource),
214 .resource = cmx255_nand_resource,
215 .id = -1,
216 .dev = {
217 .platform_data = &cmx255_nand_platdata,
221 static void __init cmx255_init_nand(void)
223 platform_device_register(&cmx255_nand);
225 #else
226 static inline void cmx255_init_nand(void) {}
227 #endif
229 void __init cmx255_init(void)
231 pxa2xx_mfp_config(ARRAY_AND_SIZE(cmx255_pin_config));
233 cmx255_init_rtc();
234 cmx255_init_nor();
235 cmx255_init_nand();