x86/boot: Rename overlapping memcpy() to memmove()
[linux/fpc-iii.git] / arch / arm / mm / proc-v7m.S
blob7229d8d0be1af2eba82adaf8825fd88490c8a4f4
1 /*
2  *  linux/arch/arm/mm/proc-v7m.S
3  *
4  *  Copyright (C) 2008 ARM Ltd.
5  *  Copyright (C) 2001 Deep Blue Solutions Ltd.
6  *
7  * This program is free software; you can redistribute it and/or modify
8  * it under the terms of the GNU General Public License version 2 as
9  * published by the Free Software Foundation.
10  *
11  *  This is the "shell" of the ARMv7-M processor support.
12  */
13 #include <linux/linkage.h>
14 #include <asm/assembler.h>
15 #include <asm/memory.h>
16 #include <asm/v7m.h>
17 #include "proc-macros.S"
19 ENTRY(cpu_v7m_proc_init)
20         ret     lr
21 ENDPROC(cpu_v7m_proc_init)
23 ENTRY(cpu_v7m_proc_fin)
24         ret     lr
25 ENDPROC(cpu_v7m_proc_fin)
28  *      cpu_v7m_reset(loc)
29  *
30  *      Perform a soft reset of the system.  Put the CPU into the
31  *      same state as it would be if it had been reset, and branch
32  *      to what would be the reset vector.
33  *
34  *      - loc   - location to jump to for soft reset
35  */
36         .align  5
37 ENTRY(cpu_v7m_reset)
38         ret     r0
39 ENDPROC(cpu_v7m_reset)
42  *      cpu_v7m_do_idle()
43  *
44  *      Idle the processor (eg, wait for interrupt).
45  *
46  *      IRQs are already disabled.
47  */
48 ENTRY(cpu_v7m_do_idle)
49         wfi
50         ret     lr
51 ENDPROC(cpu_v7m_do_idle)
53 ENTRY(cpu_v7m_dcache_clean_area)
54         ret     lr
55 ENDPROC(cpu_v7m_dcache_clean_area)
58  * There is no MMU, so here is nothing to do.
59  */
60 ENTRY(cpu_v7m_switch_mm)
61         ret     lr
62 ENDPROC(cpu_v7m_switch_mm)
64 .globl  cpu_v7m_suspend_size
65 .equ    cpu_v7m_suspend_size, 0
67 #ifdef CONFIG_ARM_CPU_SUSPEND
68 ENTRY(cpu_v7m_do_suspend)
69         ret     lr
70 ENDPROC(cpu_v7m_do_suspend)
72 ENTRY(cpu_v7m_do_resume)
73         ret     lr
74 ENDPROC(cpu_v7m_do_resume)
75 #endif
77         .section ".text.init", #alloc, #execinstr
80  *      __v7m_setup
81  *
82  *      This should be able to cover all ARMv7-M cores.
83  */
84 __v7m_setup:
85         @ Configure the vector table base address
86         ldr     r0, =BASEADDR_V7M_SCB
87         ldr     r12, =vector_table
88         str     r12, [r0, V7M_SCB_VTOR]
90         @ enable UsageFault, BusFault and MemManage fault.
91         ldr     r5, [r0, #V7M_SCB_SHCSR]
92         orr     r5, #(V7M_SCB_SHCSR_USGFAULTENA | V7M_SCB_SHCSR_BUSFAULTENA | V7M_SCB_SHCSR_MEMFAULTENA)
93         str     r5, [r0, #V7M_SCB_SHCSR]
95         @ Lower the priority of the SVC and PendSV exceptions
96         mov     r5, #0x80000000
97         str     r5, [r0, V7M_SCB_SHPR2] @ set SVC priority
98         mov     r5, #0x00800000
99         str     r5, [r0, V7M_SCB_SHPR3] @ set PendSV priority
101         @ SVC to switch to handler mode. Notice that this requires sp to
102         @ point to writeable memory because the processor saves
103         @ some registers to the stack.
104         badr    r1, 1f
105         ldr     r5, [r12, #11 * 4]      @ read the SVC vector entry
106         str     r1, [r12, #11 * 4]      @ write the temporary SVC vector entry
107         mov     r6, lr                  @ save LR
108         ldr     sp, =init_thread_union + THREAD_START_SP
109         cpsie   i
110         svc     #0
111 1:      cpsid   i
112         str     r5, [r12, #11 * 4]      @ restore the original SVC vector entry
113         mov     lr, r6                  @ restore LR
115         @ Special-purpose control register
116         mov     r1, #1
117         msr     control, r1             @ Thread mode has unpriviledged access
119         @ Configure the System Control Register to ensure 8-byte stack alignment
120         @ Note the STKALIGN bit is either RW or RAO.
121         ldr     r12, [r0, V7M_SCB_CCR]  @ system control register
122         orr     r12, #V7M_SCB_CCR_STKALIGN
123         str     r12, [r0, V7M_SCB_CCR]
124         ret     lr
125 ENDPROC(__v7m_setup)
127         define_processor_functions v7m, dabort=nommu_early_abort, pabort=legacy_pabort, nommu=1
129         .section ".rodata"
130         string cpu_arch_name, "armv7m"
131         string cpu_elf_name "v7m"
132         string cpu_v7m_name "ARMv7-M"
134         .section ".proc.info.init", #alloc
136         /*
137          * Match any ARMv7-M processor core.
138          */
139         .type   __v7m_proc_info, #object
140 __v7m_proc_info:
141         .long   0x000f0000              @ Required ID value
142         .long   0x000f0000              @ Mask for ID
143         .long   0                       @ proc_info_list.__cpu_mm_mmu_flags
144         .long   0                       @ proc_info_list.__cpu_io_mmu_flags
145         initfn  __v7m_setup, __v7m_proc_info    @ proc_info_list.__cpu_flush
146         .long   cpu_arch_name
147         .long   cpu_elf_name
148         .long   HWCAP_HALF|HWCAP_THUMB|HWCAP_FAST_MULT
149         .long   cpu_v7m_name
150         .long   v7m_processor_functions @ proc_info_list.proc
151         .long   0                       @ proc_info_list.tlb
152         .long   0                       @ proc_info_list.user
153         .long   nop_cache_fns           @ proc_info_list.cache
154         .size   __v7m_proc_info, . - __v7m_proc_info