Documentation/devicetree/bindings/mtd/pxa3xx-nand.txt

   1 PXA3xx NAND DT bindings
   2
   3 Required properties:
   4
   5  - compatible:          Should be set to one of the following:
   6                         marvell,pxa3xx-nand
   7                         marvell,armada370-nand
   8  - reg:                 The register base for the controller
   9  - interrupts:          The interrupt to map
  10  - #address-cells:      Set to <1> if the node includes partitions
  11
  12 Optional properties:
  13
  14  - marvell,nand-enable-arbiter: Set to enable the bus arbiter
  15  - marvell,nand-keep-config:    Set to keep the NAND controller config as set
  16                                 by the bootloader
  17  - num-cs:                      Number of chipselect lines to use
  18  - nand-on-flash-bbt:           boolean to enable on flash bbt option if
  19                                 not present false
  20  - nand-ecc-strength:           number of bits to correct per ECC step
  21  - nand-ecc-step-size:          number of data bytes covered by a single ECC step
  22
  23 The following ECC strength and step size are currently supported:
  24
  25  - nand-ecc-strength = <1>, nand-ecc-step-size = <512>
  26  - nand-ecc-strength = <4>, nand-ecc-step-size = <512>
  27  - nand-ecc-strength = <8>, nand-ecc-step-size = <512>
  28
  29 Example:
  30
  31         nand0: nand@43100000 {
  32                 compatible = "marvell,pxa3xx-nand";
  33                 reg = <0x43100000 90>;
  34                 interrupts = <45>;
  35                 #address-cells = <1>;
  36
  37                 marvell,nand-enable-arbiter;
  38                 marvell,nand-keep-config;
  39                 num-cs = <1>;
  40
  41                 /* partitions (optional) */
  42         };
  43