Linux 4.1.18
[linux/fpc-iii.git] / arch / arm / plat-pxa / include / plat / dma.h
bloba7b91dc06852bc0c139077dee579c3b27f2b1dbb
1 #ifndef __PLAT_DMA_H
2 #define __PLAT_DMA_H
4 #define DMAC_REG(x) (*((volatile u32 *)(DMAC_REGS_VIRT + (x))))
6 #define DCSR(n) DMAC_REG((n) << 2)
7 #define DALGN DMAC_REG(0x00a0) /* DMA Alignment Register */
8 #define DINT DMAC_REG(0x00f0) /* DMA Interrupt Register */
9 #define DDADR(n) DMAC_REG(0x0200 + ((n) << 4))
10 #define DSADR(n) DMAC_REG(0x0204 + ((n) << 4))
11 #define DTADR(n) DMAC_REG(0x0208 + ((n) << 4))
12 #define DCMD(n) DMAC_REG(0x020c + ((n) << 4))
13 #define DRCMR(n) DMAC_REG((((n) < 64) ? 0x0100 : 0x1100) + \
14 (((n) & 0x3f) << 2))
16 #define DCSR_RUN (1 << 31) /* Run Bit (read / write) */
17 #define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch (read / write) */
18 #define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable (read / write) */
19 #define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */
20 #define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */
21 #define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */
22 #define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */
23 #define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */
25 #define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable (R/W) */
26 #define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */
27 #define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */
28 #define DCSR_SETCMPST (1 << 25) /* Set Descriptor Compare Status */
29 #define DCSR_CLRCMPST (1 << 24) /* Clear Descriptor Compare Status */
30 #define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */
31 #define DCSR_EORINTR (1 << 9) /* The end of Receive */
33 #define DRCMR_MAPVLD (1 << 7) /* Map Valid (read / write) */
34 #define DRCMR_CHLNUM 0x1f /* mask for Channel Number (read / write) */
36 #define DDADR_DESCADDR 0xfffffff0 /* Address of next descriptor (mask) */
37 #define DDADR_STOP (1 << 0) /* Stop (read / write) */
39 #define DCMD_INCSRCADDR (1 << 31) /* Source Address Increment Setting. */
40 #define DCMD_INCTRGADDR (1 << 30) /* Target Address Increment Setting. */
41 #define DCMD_FLOWSRC (1 << 29) /* Flow Control by the source. */
42 #define DCMD_FLOWTRG (1 << 28) /* Flow Control by the target. */
43 #define DCMD_STARTIRQEN (1 << 22) /* Start Interrupt Enable */
44 #define DCMD_ENDIRQEN (1 << 21) /* End Interrupt Enable */
45 #define DCMD_ENDIAN (1 << 18) /* Device Endian-ness. */
46 #define DCMD_BURST8 (1 << 16) /* 8 byte burst */
47 #define DCMD_BURST16 (2 << 16) /* 16 byte burst */
48 #define DCMD_BURST32 (3 << 16) /* 32 byte burst */
49 #define DCMD_WIDTH1 (1 << 14) /* 1 byte width */
50 #define DCMD_WIDTH2 (2 << 14) /* 2 byte width (HalfWord) */
51 #define DCMD_WIDTH4 (3 << 14) /* 4 byte width (Word) */
52 #define DCMD_LENGTH 0x01fff /* length mask (max = 8K - 1) */
55 * Descriptor structure for PXA's DMA engine
56 * Note: this structure must always be aligned to a 16-byte boundary.
59 typedef struct pxa_dma_desc {
60 volatile u32 ddadr; /* Points to the next descriptor + flags */
61 volatile u32 dsadr; /* DSADR value for the current transfer */
62 volatile u32 dtadr; /* DTADR value for the current transfer */
63 volatile u32 dcmd; /* DCMD value for the current transfer */
64 } pxa_dma_desc;
66 typedef enum {
67 DMA_PRIO_HIGH = 0,
68 DMA_PRIO_MEDIUM = 1,
69 DMA_PRIO_LOW = 2
70 } pxa_dma_prio;
73 * DMA registration
76 int __init pxa_init_dma(int irq, int num_ch);
78 int pxa_request_dma (char *name,
79 pxa_dma_prio prio,
80 void (*irq_handler)(int, void *),
81 void *data);
83 void pxa_free_dma (int dma_ch);
85 #endif /* __PLAT_DMA_H */