Linux 2.6.20.7
[linux/fpc-iii.git] / drivers / sbus / char / vfc.h
blob63941a259b927436f2f96e7589d8e8267e48ffa9
1 #ifndef _LINUX_VFC_H_
2 #define _LINUX_VFC_H_
4 /*
5 * The control register for the vfc is at offset 0x4000
6 * The first field ram bank is located at offset 0x5000
7 * The second field ram bank is at offset 0x7000
8 * i2c_reg address the Phillips PCF8584(see notes in vfc_i2c.c)
9 * data and transmit register.
10 * i2c_s1 controls register s1 of the PCF8584
11 * i2c_write seems to be similar to i2c_write but I am not
12 * quite sure why sun uses it
14 * I am also not sure whether or not you can read the fram bank as a
15 * whole or whether you must read each word individually from offset
16 * 0x5000 as soon as I figure it out I will update this file */
18 struct vfc_regs {
19 char pad1[0x4000];
20 unsigned int control; /* Offset 0x4000 */
21 char pad2[0xffb]; /* from offset 0x4004 to 0x5000 */
22 unsigned int fram_bank1; /* Offset 0x5000 */
23 char pad3[0xffb]; /* from offset 0x5004 to 0x6000 */
24 unsigned int i2c_reg; /* Offset 0x6000 */
25 unsigned int i2c_magic2; /* Offset 0x6004 */
26 unsigned int i2c_s1; /* Offset 0x6008 */
27 unsigned int i2c_write; /* Offset 0x600c */
28 char pad4[0xff0]; /* from offset 0x6010 to 0x7000 */
29 unsigned int fram_bank2; /* Offset 0x7000 */
30 char pad5[0x1000];
33 #define VFC_SAA9051_NR (13)
34 #define VFC_SAA9051_ADDR (0x8a)
35 /* The saa9051 returns the following for its status
36 * bit 0 - 0
37 * bit 1 - SECAM color detected (1=found,0=not found)
38 * bit 2 - COLOR detected (1=found,0=not found)
39 * bit 3 - 0
40 * bit 4 - Field frequency bit (1=60Hz (NTSC), 0=50Hz (PAL))
41 * bit 5 - 1
42 * bit 6 - horizontal frequency lock (1=transmitter found,
43 * 0=no transmitter)
44 * bit 7 - Power on reset bit (1=reset,0=at least one successful
45 * read of the status byte)
48 #define VFC_SAA9051_PONRES (0x80)
49 #define VFC_SAA9051_HLOCK (0x40)
50 #define VFC_SAA9051_FD (0x10)
51 #define VFC_SAA9051_CD (0x04)
52 #define VFC_SAA9051_CS (0x02)
55 /* The various saa9051 sub addresses */
57 #define VFC_SAA9051_IDEL (0)
58 #define VFC_SAA9051_HSY_START (1)
59 #define VFC_SAA9051_HSY_STOP (2)
60 #define VFC_SAA9051_HC_START (3)
61 #define VFC_SAA9051_HC_STOP (4)
62 #define VFC_SAA9051_HS_START (5)
63 #define VFC_SAA9051_HORIZ_PEAK (6)
64 #define VFC_SAA9051_HUE (7)
65 #define VFC_SAA9051_C1 (8)
66 #define VFC_SAA9051_C2 (9)
67 #define VFC_SAA9051_C3 (0xa)
68 #define VFC_SAA9051_SECAM_DELAY (0xb)
71 /* Bit settings for saa9051 sub address 0x06 */
73 #define VFC_SAA9051_AP1 (0x01)
74 #define VFC_SAA9051_AP2 (0x02)
75 #define VFC_SAA9051_COR1 (0x04)
76 #define VFC_SAA9051_COR2 (0x08)
77 #define VFC_SAA9051_BP1 (0x10)
78 #define VFC_SAA9051_BP2 (0x20)
79 #define VFC_SAA9051_PF (0x40)
80 #define VFC_SAA9051_BY (0x80)
83 /* Bit settings for saa9051 sub address 0x08 */
85 #define VFC_SAA9051_CCFR0 (0x01)
86 #define VFC_SAA9051_CCFR1 (0x02)
87 #define VFC_SAA9051_YPN (0x04)
88 #define VFC_SAA9051_ALT (0x08)
89 #define VFC_SAA9051_CO (0x10)
90 #define VFC_SAA9051_VTR (0x20)
91 #define VFC_SAA9051_FS (0x40)
92 #define VFC_SAA9051_HPLL (0x80)
95 /* Bit settings for saa9051 sub address 9 */
97 #define VFC_SAA9051_SS0 (0x01)
98 #define VFC_SAA9051_SS1 (0x02)
99 #define VFC_SAA9051_AFCC (0x04)
100 #define VFC_SAA9051_CI (0x08)
101 #define VFC_SAA9051_SA9D4 (0x10) /* Don't care bit */
102 #define VFC_SAA9051_OEC (0x20)
103 #define VFC_SAA9051_OEY (0x40)
104 #define VFC_SAA9051_VNL (0x80)
107 /* Bit settings for saa9051 sub address 0x0A */
109 #define VFC_SAA9051_YDL0 (0x01)
110 #define VFC_SAA9051_YDL1 (0x02)
111 #define VFC_SAA9051_YDL2 (0x04)
112 #define VFC_SAA9051_SS2 (0x08)
113 #define VFC_SAA9051_SS3 (0x10)
114 #define VFC_SAA9051_YC (0x20)
115 #define VFC_SAA9051_CT (0x40)
116 #define VFC_SAA9051_SYC (0x80)
119 #define VFC_SAA9051_SA(a,b) ((a)->saa9051_state_array[(b)+1])
120 #define vfc_update_saa9051(a) (vfc_i2c_sendbuf((a),VFC_SAA9051_ADDR,\
121 (a)->saa9051_state_array,\
122 VFC_SAA9051_NR))
125 struct vfc_dev {
126 volatile struct vfc_regs __iomem *regs;
127 struct vfc_regs *phys_regs;
128 unsigned int control_reg;
129 struct semaphore device_lock_sem;
130 int instance;
131 int busy;
132 unsigned long which_io;
133 unsigned char saa9051_state_array[VFC_SAA9051_NR];
136 extern struct vfc_dev **vfc_dev_lst;
138 void captstat_reset(struct vfc_dev *);
139 void memptr_reset(struct vfc_dev *);
141 int vfc_pcf8584_init(struct vfc_dev *);
142 void vfc_i2c_delay_no_busy(struct vfc_dev *, unsigned long);
143 void vfc_i2c_delay(struct vfc_dev *);
144 int vfc_i2c_sendbuf(struct vfc_dev *, unsigned char, char *, int) ;
145 int vfc_i2c_recvbuf(struct vfc_dev *, unsigned char, char *, int) ;
146 int vfc_i2c_reset_bus(struct vfc_dev *);
147 int vfc_init_i2c_bus(struct vfc_dev *);
148 void vfc_lock_device(struct vfc_dev *);
149 void vfc_unlock_device(struct vfc_dev *);
151 #define VFC_CONTROL_DIAGMODE 0x10000000
152 #define VFC_CONTROL_MEMPTR 0x20000000
153 #define VFC_CONTROL_CAPTURE 0x02000000
154 #define VFC_CONTROL_CAPTRESET 0x04000000
156 #define VFC_STATUS_CAPTURE 0x08000000
158 #ifdef VFC_IOCTL_DEBUG
159 #define VFC_IOCTL_DEBUG_PRINTK(a) printk a
160 #else
161 #define VFC_IOCTL_DEBUG_PRINTK(a)
162 #endif
164 #ifdef VFC_I2C_DEBUG
165 #define VFC_I2C_DEBUG_PRINTK(a) printk a
166 #else
167 #define VFC_I2C_DEBUG_PRINTK(a)
168 #endif
170 #endif /* _LINUX_VFC_H_ */