1 #ifndef DW_SPI_HEADER_H
2 #define DW_SPI_HEADER_H
5 #include <linux/scatterlist.h>
6 #include <linux/gpio.h>
9 #define DW_SPI_CTRL0 0x00
10 #define DW_SPI_CTRL1 0x04
11 #define DW_SPI_SSIENR 0x08
12 #define DW_SPI_MWCR 0x0c
13 #define DW_SPI_SER 0x10
14 #define DW_SPI_BAUDR 0x14
15 #define DW_SPI_TXFLTR 0x18
16 #define DW_SPI_RXFLTR 0x1c
17 #define DW_SPI_TXFLR 0x20
18 #define DW_SPI_RXFLR 0x24
19 #define DW_SPI_SR 0x28
20 #define DW_SPI_IMR 0x2c
21 #define DW_SPI_ISR 0x30
22 #define DW_SPI_RISR 0x34
23 #define DW_SPI_TXOICR 0x38
24 #define DW_SPI_RXOICR 0x3c
25 #define DW_SPI_RXUICR 0x40
26 #define DW_SPI_MSTICR 0x44
27 #define DW_SPI_ICR 0x48
28 #define DW_SPI_DMACR 0x4c
29 #define DW_SPI_DMATDLR 0x50
30 #define DW_SPI_DMARDLR 0x54
31 #define DW_SPI_IDR 0x58
32 #define DW_SPI_VERSION 0x5c
33 #define DW_SPI_DR 0x60
35 /* Bit fields in CTRLR0 */
36 #define SPI_DFS_OFFSET 0
38 #define SPI_FRF_OFFSET 4
39 #define SPI_FRF_SPI 0x0
40 #define SPI_FRF_SSP 0x1
41 #define SPI_FRF_MICROWIRE 0x2
42 #define SPI_FRF_RESV 0x3
44 #define SPI_MODE_OFFSET 6
45 #define SPI_SCPH_OFFSET 6
46 #define SPI_SCOL_OFFSET 7
48 #define SPI_TMOD_OFFSET 8
49 #define SPI_TMOD_MASK (0x3 << SPI_TMOD_OFFSET)
50 #define SPI_TMOD_TR 0x0 /* xmit & recv */
51 #define SPI_TMOD_TO 0x1 /* xmit only */
52 #define SPI_TMOD_RO 0x2 /* recv only */
53 #define SPI_TMOD_EPROMREAD 0x3 /* eeprom read mode */
55 #define SPI_SLVOE_OFFSET 10
56 #define SPI_SRL_OFFSET 11
57 #define SPI_CFS_OFFSET 12
59 /* Bit fields in SR, 7 bits */
60 #define SR_MASK 0x7f /* cover 7 bits */
61 #define SR_BUSY (1 << 0)
62 #define SR_TF_NOT_FULL (1 << 1)
63 #define SR_TF_EMPT (1 << 2)
64 #define SR_RF_NOT_EMPT (1 << 3)
65 #define SR_RF_FULL (1 << 4)
66 #define SR_TX_ERR (1 << 5)
67 #define SR_DCOL (1 << 6)
69 /* Bit fields in ISR, IMR, RISR, 7 bits */
70 #define SPI_INT_TXEI (1 << 0)
71 #define SPI_INT_TXOI (1 << 1)
72 #define SPI_INT_RXUI (1 << 2)
73 #define SPI_INT_RXOI (1 << 3)
74 #define SPI_INT_RXFI (1 << 4)
75 #define SPI_INT_MSTI (1 << 5)
77 /* Bit fields in DMACR */
78 #define SPI_DMA_RDMAE (1 << 0)
79 #define SPI_DMA_TDMAE (1 << 1)
81 /* TX RX interrupt level threshold, max can be 256 */
82 #define SPI_INT_THRESHOLD 32
91 struct dw_spi_dma_ops
{
92 int (*dma_init
)(struct dw_spi
*dws
);
93 void (*dma_exit
)(struct dw_spi
*dws
);
94 int (*dma_setup
)(struct dw_spi
*dws
, struct spi_transfer
*xfer
);
95 bool (*can_dma
)(struct spi_master
*master
, struct spi_device
*spi
,
96 struct spi_transfer
*xfer
);
97 int (*dma_transfer
)(struct dw_spi
*dws
, struct spi_transfer
*xfer
);
98 void (*dma_stop
)(struct dw_spi
*dws
);
102 struct spi_master
*master
;
103 enum dw_ssi_type type
;
109 u32 fifo_len
; /* depth of the FIFO buffer */
110 u32 max_freq
; /* max bus freq supported */
112 u32 reg_io_width
; /* DR I/O width in bytes */
114 u16 num_cs
; /* supported slave numbers */
116 /* Current message transfer state info */
123 u8 n_bytes
; /* current is a 1/2 bytes op */
125 irqreturn_t (*transfer_handler
)(struct dw_spi
*dws
);
129 struct dma_chan
*txchan
;
130 struct dma_chan
*rxchan
;
131 unsigned long dma_chan_busy
;
132 dma_addr_t dma_addr
; /* phy address of the Data register */
133 struct dw_spi_dma_ops
*dma_ops
;
137 /* Bus interface info */
139 #ifdef CONFIG_DEBUG_FS
140 struct dentry
*debugfs
;
144 static inline u32
dw_readl(struct dw_spi
*dws
, u32 offset
)
146 return __raw_readl(dws
->regs
+ offset
);
149 static inline u16
dw_readw(struct dw_spi
*dws
, u32 offset
)
151 return __raw_readw(dws
->regs
+ offset
);
154 static inline void dw_writel(struct dw_spi
*dws
, u32 offset
, u32 val
)
156 __raw_writel(val
, dws
->regs
+ offset
);
159 static inline void dw_writew(struct dw_spi
*dws
, u32 offset
, u16 val
)
161 __raw_writew(val
, dws
->regs
+ offset
);
164 static inline u32
dw_read_io_reg(struct dw_spi
*dws
, u32 offset
)
166 switch (dws
->reg_io_width
) {
168 return dw_readw(dws
, offset
);
171 return dw_readl(dws
, offset
);
175 static inline void dw_write_io_reg(struct dw_spi
*dws
, u32 offset
, u32 val
)
177 switch (dws
->reg_io_width
) {
179 dw_writew(dws
, offset
, val
);
183 dw_writel(dws
, offset
, val
);
188 static inline void spi_enable_chip(struct dw_spi
*dws
, int enable
)
190 dw_writel(dws
, DW_SPI_SSIENR
, (enable
? 1 : 0));
193 static inline void spi_set_clk(struct dw_spi
*dws
, u16 div
)
195 dw_writel(dws
, DW_SPI_BAUDR
, div
);
198 /* Disable IRQ bits */
199 static inline void spi_mask_intr(struct dw_spi
*dws
, u32 mask
)
203 new_mask
= dw_readl(dws
, DW_SPI_IMR
) & ~mask
;
204 dw_writel(dws
, DW_SPI_IMR
, new_mask
);
207 /* Enable IRQ bits */
208 static inline void spi_umask_intr(struct dw_spi
*dws
, u32 mask
)
212 new_mask
= dw_readl(dws
, DW_SPI_IMR
) | mask
;
213 dw_writel(dws
, DW_SPI_IMR
, new_mask
);
217 * This does disable the SPI controller, interrupts, and re-enable the
218 * controller back. Transmit and receive FIFO buffers are cleared when the
219 * device is disabled.
221 static inline void spi_reset_chip(struct dw_spi
*dws
)
223 spi_enable_chip(dws
, 0);
224 spi_mask_intr(dws
, 0xff);
225 spi_enable_chip(dws
, 1);
228 static inline void spi_shutdown_chip(struct dw_spi
*dws
)
230 spi_enable_chip(dws
, 0);
235 * Each SPI slave device to work with dw_api controller should
236 * has such a structure claiming its working mode (poll or PIO/DMA),
237 * which can be save in the "controller_data" member of the
241 u8 poll_mode
; /* 1 for controller polling mode */
242 u8 type
; /* SPI/SSP/MicroWire */
243 void (*cs_control
)(u32 command
);
246 extern int dw_spi_add_host(struct device
*dev
, struct dw_spi
*dws
);
247 extern void dw_spi_remove_host(struct dw_spi
*dws
);
248 extern int dw_spi_suspend_host(struct dw_spi
*dws
);
249 extern int dw_spi_resume_host(struct dw_spi
*dws
);
251 /* platform related setup */
252 extern int dw_spi_mid_init(struct dw_spi
*dws
); /* Intel MID platforms */
253 #endif /* DW_SPI_HEADER_H */