mm/slab: sanity-check page type when looking up cache
[linux/fpc-iii.git] / drivers / gpio / gpio-janz-ttl.c
blobcdf50e4ea1650a7aa924529a23189e68f3d60c77
1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /*
3 * Janz MODULbus VMOD-TTL GPIO Driver
5 * Copyright (c) 2010 Ira W. Snyder <iws@ovro.caltech.edu>
6 */
8 #include <linux/kernel.h>
9 #include <linux/module.h>
10 #include <linux/init.h>
11 #include <linux/interrupt.h>
12 #include <linux/delay.h>
13 #include <linux/platform_device.h>
14 #include <linux/io.h>
15 #include <linux/gpio/driver.h>
16 #include <linux/slab.h>
17 #include <linux/bitops.h>
19 #include <linux/mfd/janz.h>
21 #define DRV_NAME "janz-ttl"
23 #define PORTA_DIRECTION 0x23
24 #define PORTB_DIRECTION 0x2B
25 #define PORTC_DIRECTION 0x06
26 #define PORTA_IOCTL 0x24
27 #define PORTB_IOCTL 0x2C
28 #define PORTC_IOCTL 0x07
30 #define MASTER_INT_CTL 0x00
31 #define MASTER_CONF_CTL 0x01
33 #define CONF_PAE BIT(2)
34 #define CONF_PBE BIT(7)
35 #define CONF_PCE BIT(4)
37 struct ttl_control_regs {
38 __be16 portc;
39 __be16 portb;
40 __be16 porta;
41 __be16 control;
44 struct ttl_module {
45 struct gpio_chip gpio;
47 /* base address of registers */
48 struct ttl_control_regs __iomem *regs;
50 u8 portc_shadow;
51 u8 portb_shadow;
52 u8 porta_shadow;
54 spinlock_t lock;
57 static int ttl_get_value(struct gpio_chip *gpio, unsigned offset)
59 struct ttl_module *mod = dev_get_drvdata(gpio->parent);
60 u8 *shadow;
61 int ret;
63 if (offset < 8) {
64 shadow = &mod->porta_shadow;
65 } else if (offset < 16) {
66 shadow = &mod->portb_shadow;
67 offset -= 8;
68 } else {
69 shadow = &mod->portc_shadow;
70 offset -= 16;
73 spin_lock(&mod->lock);
74 ret = *shadow & BIT(offset);
75 spin_unlock(&mod->lock);
76 return !!ret;
79 static void ttl_set_value(struct gpio_chip *gpio, unsigned offset, int value)
81 struct ttl_module *mod = dev_get_drvdata(gpio->parent);
82 void __iomem *port;
83 u8 *shadow;
85 if (offset < 8) {
86 port = &mod->regs->porta;
87 shadow = &mod->porta_shadow;
88 } else if (offset < 16) {
89 port = &mod->regs->portb;
90 shadow = &mod->portb_shadow;
91 offset -= 8;
92 } else {
93 port = &mod->regs->portc;
94 shadow = &mod->portc_shadow;
95 offset -= 16;
98 spin_lock(&mod->lock);
99 if (value)
100 *shadow |= BIT(offset);
101 else
102 *shadow &= ~BIT(offset);
104 iowrite16be(*shadow, port);
105 spin_unlock(&mod->lock);
108 static void ttl_write_reg(struct ttl_module *mod, u8 reg, u16 val)
110 iowrite16be(reg, &mod->regs->control);
111 iowrite16be(val, &mod->regs->control);
114 static void ttl_setup_device(struct ttl_module *mod)
116 /* reset the device to a known state */
117 iowrite16be(0x0000, &mod->regs->control);
118 iowrite16be(0x0001, &mod->regs->control);
119 iowrite16be(0x0000, &mod->regs->control);
121 /* put all ports in open-drain mode */
122 ttl_write_reg(mod, PORTA_IOCTL, 0x00ff);
123 ttl_write_reg(mod, PORTB_IOCTL, 0x00ff);
124 ttl_write_reg(mod, PORTC_IOCTL, 0x000f);
126 /* set all ports as outputs */
127 ttl_write_reg(mod, PORTA_DIRECTION, 0x0000);
128 ttl_write_reg(mod, PORTB_DIRECTION, 0x0000);
129 ttl_write_reg(mod, PORTC_DIRECTION, 0x0000);
131 /* set all ports to drive zeroes */
132 iowrite16be(0x0000, &mod->regs->porta);
133 iowrite16be(0x0000, &mod->regs->portb);
134 iowrite16be(0x0000, &mod->regs->portc);
136 /* enable all ports */
137 ttl_write_reg(mod, MASTER_CONF_CTL, CONF_PAE | CONF_PBE | CONF_PCE);
140 static int ttl_probe(struct platform_device *pdev)
142 struct janz_platform_data *pdata;
143 struct ttl_module *mod;
144 struct gpio_chip *gpio;
145 int ret;
147 pdata = dev_get_platdata(&pdev->dev);
148 if (!pdata) {
149 dev_err(&pdev->dev, "no platform data\n");
150 return -ENXIO;
153 mod = devm_kzalloc(&pdev->dev, sizeof(*mod), GFP_KERNEL);
154 if (!mod)
155 return -ENOMEM;
157 platform_set_drvdata(pdev, mod);
158 spin_lock_init(&mod->lock);
160 /* get access to the MODULbus registers for this module */
161 mod->regs = devm_platform_ioremap_resource(pdev, 0);
162 if (IS_ERR(mod->regs))
163 return PTR_ERR(mod->regs);
165 ttl_setup_device(mod);
167 /* Initialize the GPIO data structures */
168 gpio = &mod->gpio;
169 gpio->parent = &pdev->dev;
170 gpio->label = pdev->name;
171 gpio->get = ttl_get_value;
172 gpio->set = ttl_set_value;
173 gpio->owner = THIS_MODULE;
175 /* request dynamic allocation */
176 gpio->base = -1;
177 gpio->ngpio = 20;
179 ret = devm_gpiochip_add_data(&pdev->dev, gpio, NULL);
180 if (ret) {
181 dev_err(&pdev->dev, "unable to add GPIO chip\n");
182 return ret;
185 return 0;
188 static struct platform_driver ttl_driver = {
189 .driver = {
190 .name = DRV_NAME,
192 .probe = ttl_probe,
195 module_platform_driver(ttl_driver);
197 MODULE_AUTHOR("Ira W. Snyder <iws@ovro.caltech.edu>");
198 MODULE_DESCRIPTION("Janz MODULbus VMOD-TTL Driver");
199 MODULE_LICENSE("GPL");
200 MODULE_ALIAS("platform:janz-ttl");